Service bulletin 9003765
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10224695 |
| Published by NHTSA | 2022-10-24 |
| Manufacturer's number | 9003765 |
| Manufacturer's date | 2017-08-16 |
| NHTSA component | BACK OVER PREVENTION; VISIBILITY:WINDSHIELD; EQUIPMENT:ELECTRICAL |
NHTSA's summary
Washer Fluid Sensor When the washer fluid light indicates low fluid after filling the reservoir, check the washer sensor wire harness for cuts / damage, check pin for looseness. Monitor fluid level sensor light while doing connector wiggle test and if necessary disconnect and reconnect connector. If it is necessary to replace the washer fluid sensor, please be careful to perform repair without damaging sensor.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Driver assistance, Equipment and accessories, Glass, wipers and mirrors, Backup camera, Windshield
| JEEP COMPASS | 2017 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 0813423 | 2023-07-31. Service bulletin. Radio SW update GR18.8 Customers may experience one or more of the following: ? WiFi hotspot connection failure (UAQ and UCA). ? Mobile Station Integrated Services Digital Network (MSISDN) missing from radio, no connected services working (UAQ and UCA). ? Navigation voice prompts are in a different language than what is set. ? Radio may reset or go blank (Rear View Camera (RVC) not affected). ? Unable to enter non-alphanumeric (Emoji) characters into the Wireless phone book for caller?s name ? Unable to communicate with the radio using wiTECH. This bulletin involves inspecting and if required, updating the radio software level to 18.7 (UGQ or UDQ) 18.8 (UAQ or UCQ). |
|---|---|
| 08-235-22 | 2023-01-17. Service bulletin. UCQ UAQ UGQ and UDQ Radio Enhancements Software Updated to 18.8 Customers may experience one or more of the following: ? **Wi-Fi hotspot connection failure (UAQ and UCA). ? Mobile Station Integrated Services Digital Network (MSISDN) missing from radio, no connected services working (UAQ and UCA)..** ? Navigation voice prompts are in a different language than what is set ? Radio may reset or go blank (Rear View Camera (RVC) not affected). ? Unable to enter non-alphanumeric (Emoji) characters into the Bluetooth phone book for caller?s name. ? Unable to communicate with the radio using wiTECH. This bulletin involves inspecting and if required, updating the radio software level to 18.7 (UGQ or UDQ) **18.8 (UAQ or UCQ)**. |
| 0808017 | 2022-10-24. Service bulletin. Radio Enhancements This bulletin involves updating the radio with the latest available software. Customers may notice that the radio display screen will turn black but the radio will still operate. |
| 0801022 | 2022-10-17. Service bulletin. Flash: Drivetrain Control Module (DTCM) Updates This bulletin involves reprogramming the DTCM with the latest available software. The customer may describe one or more of the following: Noise while disconnecting the 4WD at speeds around 56 kph (35 mph). A hum, chatter or growl noise heard intermittently at speeds approximately between 48-72 kph (30-45 mph). Upon further investigation the technician may find that the following Diagnostic Trouble Code (DTC) is active or stored:C2502-64 - Status ECM Tcfailsts Or Transm2 Transmissionfailsts Or Brake8 Dstfailsts Or Brake8 Escfailsts Or Status ECM Emsfailsts Or Ge Electricsteeringfailsts - Signal Plausibility Failure. DTC C2502-64 may be active or stored in the DTCM due to other OBD DTC?s with the Transmission Control Module (TCM) or Powertrain Control Module (PCM). The DTC will not turn on a Malfunction Indicator Lamp (MIL) light. |
| 9003825 | 2022-09-15. Service bulletin. LATCH, Hood For the following concerns, please verify secondary plunger switch before replacing hood latch with primary switch. Please refer to service information for complete diagnostics of the secondary plunger switch which is located in the left front under hood on RU, MP, and WK/WD and left rear under hood on KL. 1) Electronic Stop Start Message on Cluster or DTC P152F without hood ajar illuminated. 2) KL Hood ajar light is on or unlatched hood due to high closing effort. (KL hood may have a higher closing effort to latch the hood as rubber bumper interference is set purposely high to prevent hood flutter at highway speeds) If stop start message or DTC P152F is present on vehicles without a hood ajar light illuminated, the issue is not related to the primary hood latch switch. |
| W84 Combo Phase1 | 2022-07-18. Service bulletin. Customer Satisfaction Notification W84 Powertrain Software Update |
| S2008000018 | 2020-05-26. Service bulletin. Steering Wheel Switches, Terrain Switch Inoperative, Backup Camera Display Has No Grid Lines |
| S2008000018 | 2020-05-18. Service bulletin. Steering Wheel Switches, Terrain Switch Inoperative, Backup Camera Display Has No Grid Lines |
| S2008000018 | 2020-04-27. Service bulletin. Steering Wheel Switches, Terrain Switch Inoperative, Backup Camera Display Has No Grid Lines |