Service bulletin 9003756
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10224681 |
| Published by NHTSA | 2022-10-24 |
| Manufacturer's number | 9003756 |
| Manufacturer's date | 2017-08-02 |
| NHTSA component | BACK OVER PREVENTION; AIR BAGS; STEERING; PARKING BRAKE; ELECTRICAL SYSTEM |
NHTSA's summary
Rain light sensor Rain sense wipers do not operate: 1. Visual Inspection--> Check if the sensor is visually OK. (all the pins are OK) Check that the Connector is NOT loose (Sensor must get a voltage from 9V to 16V) 2. Functional Checks Rain--> Steering column switch is in auto mode (sensor is active) it is necessary to splash water on the sensitive surface of the sensor to trigger wipes. check the same for different sensitivities When the rain sensitivity is increased (for example from level 0 to level 1), as an acknowledgement a single wipe is seen. (This is not a phantom wipe) and this single wipe is not seen when the rain sensitivity is decreased (from higher level to lower level) Light--> Steering column switch is in auto mode (sensor is active) block the light coming on the sensor from outside of the vehicle (use a opaque object), the head lamps should be activated 3. If the sensor seems functional, it is ideal to remove the silicon gel pad from the sensor, replace it with the new silicon gel pad instead of replacing the whole sensor. When servicing the LRSM please replace the silicon gel pad with a new silicon gel pad (PN 68224945AA) instead of replacing the whole sensor.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Air bags, Brakes, Driver assistance, Electrical system, Steering, Backup camera, Parking brake
| CHRYSLER 200 | 2016, 2017 |
|---|---|
| CHRYSLER 200 | 2018 |
| CHRYSLER 300 | 2016, 2017, 2018 |
| CHRYSLER 300C | 2016, 2017 (the catalog's model; the bulletin names a series or trim of it) |
| CHRYSLER GRAND VOYAGER | 2016 |
| CHRYSLER PACIFICA | 2016 |
| CHRYSLER PACIFICA | 2017, 2018 |
| CHRYSLER PACIFICA PLUG-IN HYBRID | 2017, 2018 (the catalog's model; the bulletin names a series or trim of it) |
| CHRYSLER TOWN AND COUNTRY | 2016 |
| CHRYSLER TOWN AND COUNTRY | 2017 to 2018 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 19V886000 | 2019-12-12. BACK OVER PREVENTION: SENSING SYSTEM: CAMERA; EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC. |
|---|
A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.
| 9004452 | 2024-01-08. Service bulletin. CAMERA, Rear View Prior to replacement, please contact FCA Redacted Content. If no response in 15 minutes, proceed with repair. |
|---|---|
| 1802123 | 2024-01-02. Service bulletin. Flash: Powertrain Control Module (PCM) Updates Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or more of the following Diagnostic Trouble Codes (DTCs) have been set: Major monitor (misfire) and other diagnostics are disabled on a pending DTCs P0335 and P0339. ? **P0335 - Crankshaft Position Sensor Circuit (NA Only). ? P0339 - Crankshaft Position Sensor Intermittent (NA Only).** ? P06E4 - Control Module Wake-Up Circuit Performance. Software enhancement: Technicians and/or customers may report the vehicle will not pass a state smog check due to permanent fault codes which will not clear. As a result, the vehicles are not eligible to be registered in certain states. ? Corrections to allow the vehicle to clear the permanent fault codes. This bulletin involves reprogramming the PCM with the latest available software. NOTE: Four modules are required to be flashed for this update to be effective, the following modules are all to be updated along with this PCM update: ? Electronic Brake Booster Module (EBBM). ? AntiLock Brake System Module (ABS). ? Hybrid Control Processor (HCP) and Auxiliary Hybrid Control Processor (AHCP) or also known as a Power Inverter Module (PIM). |
| S1408000384 | 2024-01-02. Service bulletin. Start Stop Charging Warning Lamp Illuminated On, Intelligent Battery Sensor (IBS) State of Charge (SOC) Inaccurate, Battery Charging Message, Presence of IBS related Diagnostic Trouble Codes (DTCs), or Battery Warning Lamp On |
| 9003357 | 2024-01-02. Service bulletin. ADAPTER, Engine Oil Filter (Pentastar V6) For all 2014MY replace the Oil Filter Adapter (OFA). For any other MY (with mileage above 30,000) review and follow instructions from STAR Online S1809000007 REV. C available on Dealer Connect. Also, consider the following: 1) Remove OFA 2) Replace only the oil inlet O-ring and gaskets (seals kit in SOL above). 3) Re-install the OFA. For 2023MY and beyond use black O-ring. For 2022MY and prior use red O-ring. Note: When replacing OFA, it may be necessary to transfer the Oil Temp/Pressure Sensor from the old OFA to the new OFA. |
| 9004452 | 2023-10-30. Service bulletin. CAMERA, Rear View Prior to replacement, please contact FCA Redacted Content. If no response in 15 minutes, proceed with repair. |
| S1808000152 | 2023-10-02. Service bulletin. CEL (Check Engine Lamp) Illuminated, P057B Brake Pedal Position Sensor Performance |
| 9100133 | 2023-07-31. Service bulletin. ROCKER ARM ASSY - ROLLER ROCKER Case 1.- Before replacing the intake or exhaust rocker arms due to an abnormal ticking noise, please check that the INTAKE Hydraulic Lash Adjusters are not "collapsed". If a collapsed INTAKE HLA is found, replace all INTAKE HLAs on the suspect cylinder head (no need to replace rocker arms). The noise can occur at low or high RPMs, and at low or high temperatures. There are no Diagnostic Trouble Codes (DTC)s present. Case 2.- If the INTAKE camshaft or INTAKE rocker arm has excessive wear on the high lift profile (Rocker arm: slider, Camshaft: central lobe), replace the intake camshaft (1) in that cylinder head and all intake rocker arms (6). |
| 1802023 | 2023-04-17. Service bulletin. Flash: Powertrain Control Module (PCM) Updates Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or more of the following Diagnostic Trouble Codes (DTCs) have been set: ? P0335 - Crankshaft Position Sensor Circuit (NA Only). ? P0339 - Crankshaft Position Sensor Intermittent (NA Only). Major monitor (misfire) and other diagnostics are disabled on a pending DTCs P0335 and P0339.** Software enhancement: Technicians and/or customers may report the vehicle will not pass a state smog check due to permanent fault codes which will not clear. As a result, the vehicles are not eligible to be registered in certain states. ? Corrections to allow the vehicle to clear the permanent fault codes. This bulletin involves reprogramming the PCM with the latest available software. NOTE: Four modules are required to be flashed for this update to be effective, the following modules are all to be updated along with this PCM update: ? Electronic Brake Booster Module (EBBM). ? AntiLock Brake System Module (ABS). ? Hybrid Control Processor (HCP) and Auxiliary Hybrid Control Processor (AHCP) or also known as a Power Inverter Module (PIM). |
| 08-009-23 | 2023-02-13. Service bulletin. UAR and UCR Radio Enhancements Customers may experience one or more of the following: **Wi-Fi hotspot connection failure. Speaker popping, crackle noise during Voice Recognition (VR) response. Mobile Station Integrated Services Digital Network (MSISDN) missing from radio, no connected services working.** Lost radio presets. High pitch chime noise. Contact list not loading. Remote app inoperative. High pitch squeal, pop or humming sound coming from all of the speakers. Backup camera gridlines missing. Radios resets when a wireless connectivity paired phone receives two text messages one after another simultaneously after approximately seven seconds. (Sales Code ABD). Speaker crackling noise. Unable to adjust volume. Radio may reset /reboot, turn itself off and then back on. Active call not transferred to vehicle wireless connectivity. Voice Recognition (VR) not understanding commands. Wireless connectivity phonebook not available. Anti-theft code request message. Lines appear across screen. Radio will not switch modes between AM, FM, SAT or Media. Poor wireless connectivity sound quality. Phone pairing issues. In addition, the following enhancement is included in this update: Wireless connectivity pair or connection improvements. This bulletin involves inspecting and if required, updating the radio software level to **40.1. Depending on the radio?s current software level the radio may need a one or two USB update.** |
| 08-010-23 | 2023-02-13. Service bulletin. UGV UJV UKV and UCV Radio Enhancements Customers may experience one or more of the following: Arabic language missing (UJV only). Russian language missing (UGV only). PHEV vehicles may intermittently not charge when using the scheduled charging feature instead of ?Charge Now? button. When shifting to reverse, the radio displays blue/black lines instead of the rear view camera and is followed by a reset. Radio stays on with key ?OFF? and drains battery. Wi-Fi feature cannot be renewed after the trial period has expired. Radio reboots multiple times when a Samsung J-7T phone is connected for charging only. Audio System starts up with the anti-theft screen. Radio processor freezes while the navigation screen is loading. This bulletin involves inspecting and if required, updating the radio software level to: UJV or UGV - 21.9 UDV or UKV ? 19.11 |