Service bulletin S2208000050RevB
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10221438 |
| Published by NHTSA | 2022-09-26 |
| Manufacturer's number | S2208000050RevB |
| Manufacturer's date | 2022-06-22 |
| NHTSA component | ELECTRICAL SYSTEM:STARTER ASSEMBLY |
NHTSA's summary
Vehicle Will Not Start
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Electrical system, Starter
| JEEP GRAND CHEROKEE 4XE | 2022 (the catalog's model; the bulletin names a series or trim of it) |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 9100082 | 2022-11-07. Service bulletin. STARTER, Engine Prior to starter removal: 1. Inspect and check all connections to the starter motor solenoid a. Unplug and plug-in the T50 1-way connector as needed to verify the connection is good & tight and check for any bent pin in the connection. b. Inspect the T30 connection (i.e. B+ M8 threaded stud & nut) for tightness to assure cable ring terminal connection is secured and tight (use torque spec per service manual). 2. Check/verify all grounds in the cranking circuit a. Check tightness of mounting bolts that secure starter to the engine block b. Check main ground from engine to chassis c. Check battery ground cable connections are clean and tight d.Potentially, loosen both starter motor bolts, without removing, and re-tighten to torque specifications in the service manual e. After all steps above are complete, attempt to crank the engine to verify if improvement has been made (i.e. the steps fixed the customer complaint) 3. Conduct the voltage drop test (starter feed circuit) per the service manual before removing the starter motor 4. Starter Removal: conduct the removal if above steps do not fix the complaint a. Conduct bench test by applying 12 volts to motor T30 and T50 connections (i.e. conduct simple free speed test) b. Free speed test should result in starter motor pinion travel to pinion stop and rotation with normal rotational noise (i.e. no grinding, scrapping, etc.) c. If any abnormal noise is present, replace the starter motor 5. During starter removal, also remove and replace the two starter mounting bolts. Return the bolts with starter motor for analysis at QEC and the supplier warranty analysis lab. |
|---|---|
| S2208000140RevA | 2022-10-17. Service bulletin. Intermittently The Starter Clicks And Does Not Turn Over The Engine |
| S2208000140 | 2022-10-17. Service bulletin. Intermittently The Starter Clicks And Does Not Turn Over The Engine |
| S2208000072 | 2022-09-26. Service bulletin. RKE Does Not Work Or Has Short Range, TPM Is Not Reading Tire Pressures Or Remote Start Is Inoperative |