Service bulletin 1804922
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10220798 |
| Published by NHTSA | 2022-09-26 |
| Manufacturer's number | 1804922 |
| Manufacturer's date | 2022-03-11 |
| NHTSA component | EXTERIOR LIGHTING; BACK OVER PREVENTION; ELECTRICAL SYSTEM |
NHTSA's summary
Flash: Powertrain Control Module (PCM) Updates This bulletin involves reprogramming the PCM with the latest available software. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find the following (DTC): P0441- EVAP Purge System Performance. The customer may comment on one or more of the following: Abnormal Engine noise heard periodically. This noise is caused by Variable Valve Timing (VVT) cleaning cycle. A misfire condition with no Malfunction Indicator Lamp (MIL) illuminationor Diagnostic Trouble Codes (DTCs) set. In addition, the following software enhancements are available: Updates to include misfire DTCs.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Driver assistance, Electrical system, Lighting, Backup camera
Trouble codes named
P0441
| JEEP WRANGLER | 2020 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 24V676000 | 2024-09-12. BACK OVER PREVENTION: SENSING SYSTEM: CAMERA; EXTERIOR LIGHTING:BRAKE LIGHTS |
|---|---|
| 22V638000 | 2022-08-25. BACK OVER PREVENTION:DISPLAY FUNCTION |
| 20V191000 | 2020-09-10. BACK OVER PREVENTION: SENSING SYSTEM: CAMERA |
A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.
| 0300224 | 2024-03-18. Service bulletin. Front and Rear Axle Sensor Kit **Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that the following Diagnostic Trouble Code (DTC) has been set: ? C1451-11 - Service Axle Locker System** Customers may also comment on a Service Axle Locker message displayed in the Electronic Vehicle Information Center (EVIC) for this condition. |
|---|---|
| S2319000007 | 2024-01-08. Service bulletin. Squeak Noise From Dash Area When Turning The Steering Wheel. |
| 0804523 | 2024-01-02. Service bulletin. Radio Over The Air Updating to 34.42 Software Version ? Mobile Wi-Fi inoperative upon start up. ? Hotspot gives 9No Internet9 connection message on phone when trying to connect to a device. This bulletin provides information regarding the latest Firmware Over The Air (FOTA) update and provides the service technician an overview of the steps a customer will need to take to complete the update. The radio software will be updated from 34.4 to 34.42. |
| S2025000001 | 2024-01-02. Service bulletin. Malfunction Indicator Lamp Illumination (MIL). Diagnostic Trouble Code (DTC) P203E ? Reductant Level Sensor 1 Circuit Intermittent-Erratic Set. |
| 9003357 | 2024-01-02. Service bulletin. ADAPTER, Engine Oil Filter (Pentastar V6) For all 2014MY replace the Oil Filter Adapter (OFA). For any other MY (with mileage above 30,000) review and follow instructions from STAR Online S1809000007 REV. C available on Dealer Connect. Also, consider the following: 1) Remove OFA 2) Replace only the oil inlet O-ring and gaskets (seals kit in SOL above). 3) Re-install the OFA. For 2023MY and beyond use black O-ring. For 2022MY and prior use red O-ring. Note: When replacing OFA, it may be necessary to transfer the Oil Temp/Pressure Sensor from the old OFA to the new OFA. |
| 9100134 | 2024-01-02. Service bulletin. Engine When replacing a GMET4 long block from a 2021 JL or older, you will need to carry over the injector wiring harness from the original engine, and the Fuel pressure sensor should be replaced with part number: 68212572AB. |
| 9100247 | 2023-12-18. Service bulletin. ERG Hydraulic Tensioner Before replacing any FEAD components, please check FEAD belt layout as per the engine sales code. Customer complaint may include a noise from under the hood described as a squeal, screech, squeak, chirp or belt-related noise and/or noisy tensioner/pulley. Please refer to SOL# S2309000007. |
| S1808000152 | 2023-10-02. Service bulletin. CEL (Check Engine Lamp) Illuminated, P057B Brake Pedal Position Sensor Performance |
| 9100133 | 2023-07-31. Service bulletin. ROCKER ARM ASSY - ROLLER ROCKER Case 1.- Before replacing the intake or exhaust rocker arms due to an abnormal ticking noise, please check that the INTAKE Hydraulic Lash Adjusters are not "collapsed". If a collapsed INTAKE HLA is found, replace all INTAKE HLAs on the suspect cylinder head (no need to replace rocker arms). The noise can occur at low or high RPMs, and at low or high temperatures. There are no Diagnostic Trouble Codes (DTC)s present. Case 2.- If the INTAKE camshaft or INTAKE rocker arm has excessive wear on the high lift profile (Rocker arm: slider, Camshaft: central lobe), replace the intake camshaft (1) in that cylinder head and all intake rocker arms (6). |
| S2025000001 | 2023-04-17. Service bulletin. Malfunction Indicator Lamp Illumination (MIL). Diagnostic Trouble Code (DTC) P203E ? Reductant Level Sensor 1 Circuit Intermittent-Erratic Set. |