Service bulletin 08-130-21

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
Type	Service bulletin
NHTSA id	10218556
Published by NHTSA	2022-08-22
Manufacturer's number	08-130-21
Manufacturer's date	2021-08-05
NHTSA component	ELECTRICAL SYSTEM:SOFTWARE; BACK OVER PREVENTION; ELECTRICAL SYSTEM; EXTERIOR LIGHTING; ELECTRICAL SYSTEM:PROPULSION SYSTEM:HYBRID MANAGEMENT

NHTSA's summary

Flash: Battery Pack Control Module (BPCM) Diagnostic and System Updates This bulletin involves updating the BPCM with the latest available software. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation, the technician may one or more of the following Diagnostic Trouble Codes (DTCs) have been set: P0AA1-00 - Hybrid/EV Battery Positive Contactor ?A? Stuck Closed. P0AA4-00 - Hybrid Battery Negative Contactor Circuit Stuck Closed. P0C78-00 - Hybrid/EV Battery System Precharge Time Too Long. P0B3C-00 - Hybrid/EV Battery Voltage Sense 1 Circuit Performance. P0B41-00 - Hybrid/EV Battery Voltage Sense 2 Circuit Performance. P0B46-00 - Hybrid/EV Battery Voltage Sense 3 Circuit Performance. P0B4B-00 - Hybrid/EV Battery Voltage Sense 4 Circuit Performance. P0B50-00 - Hybrid/EV Battery Voltage Sense 5 Circuit Performance. P0B55-00 - Hybrid/EV Battery Voltage Sense 6 Circuit Performance. P1A16-00 - Hybrid/EV Wakeup Control 3 Output Circuit/Open. P1D7B-00 - Hybrid/EV Wakeup Control 3 Output Circuit Short to Battery. P1D7C-00 - Hybrid/EV Wakeup Control 3 Output Circuit Short to Ground. P1A29 - Cell Supervisory Circuit A Failure. P1A2A - Cell Supervisory Circuit B Failure. P1D3E - Internal Control Module Shut Off Test Error. U0594 - Implausible Data Received from HCP. P2BE5 - Hybrid/EV Battery Pack Current Sensor "C" Circuit Performance. B12B0-85 - Charge Temperature Indicator-Signal Above Allowable Range. Customer may also experience one or more of the following: Premature oil change message displayed on the cluster and vehicle may be running in fuel/oil refresh mode. Scheduled charging not functioning properly because the battery pack did not wake up while plugged in.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Driver assistance, Electrical system, Hybrid and electric drive, Lighting, Backup camera, Software

Trouble codes named

B12B0, P0AA1, P0AA4, P0B3C, P0B41, P0B46, P0B4B, P0B50, P0B55, P0C78, P1A16, P1A29, P1A2A, P1D3E, P1D7B, P1D7C, P2BE5, U0594

Vehicles listed
CHRYSLER PACIFICA	2017, 2018
CHRYSLER PACIFICA PLUG-IN HYBRID	2017, 2018 (the catalog's model; the bulletin names a series or trim of it)

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Recalls for the same vehicles and component
19V886000	2019-12-12. BACK OVER PREVENTION: SENSING SYSTEM: CAMERA; EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.
18V332000	2018-05-17. ELECTRICAL SYSTEM:SOFTWARE; VEHICLE SPEED CONTROL:CRUISE CONTROL; ELECTRICAL SYSTEM:WIRING
18V049000	2018-01-11. ELECTRICAL SYSTEM:SOFTWARE; ENGINE AND ENGINE COOLING:ENGINE

A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.

Other bulletins for the same vehicles and component
9004452	2024-01-08. Service bulletin. CAMERA, Rear View Prior to replacement, please contact FCA Redacted Content. If no response in 15 minutes, proceed with repair.
1802123	2024-01-02. Service bulletin. Flash: Powertrain Control Module (PCM) Updates Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or more of the following Diagnostic Trouble Codes (DTCs) have been set: Major monitor (misfire) and other diagnostics are disabled on a pending DTCs P0335 and P0339. ? P0335 - Crankshaft Position Sensor Circuit (NA Only). ? P0339 - Crankshaft Position Sensor Intermittent (NA Only). ? P06E4 - Control Module Wake-Up Circuit Performance. Software enhancement: Technicians and/or customers may report the vehicle will not pass a state smog check due to permanent fault codes which will not clear. As a result, the vehicles are not eligible to be registered in certain states. ? Corrections to allow the vehicle to clear the permanent fault codes. This bulletin involves reprogramming the PCM with the latest available software. NOTE: Four modules are required to be flashed for this update to be effective, the following modules are all to be updated along with this PCM update: ? Electronic Brake Booster Module (EBBM). ? AntiLock Brake System Module (ABS). ? Hybrid Control Processor (HCP) and Auxiliary Hybrid Control Processor (AHCP) or also known as a Power Inverter Module (PIM).
S1408000384	2024-01-02. Service bulletin. Start Stop Charging Warning Lamp Illuminated On, Intelligent Battery Sensor (IBS) State of Charge (SOC) Inaccurate, Battery Charging Message, Presence of IBS related Diagnostic Trouble Codes (DTCs), or Battery Warning Lamp On
9003357	2024-01-02. Service bulletin. ADAPTER, Engine Oil Filter (Pentastar V6) For all 2014MY replace the Oil Filter Adapter (OFA). For any other MY (with mileage above 30,000) review and follow instructions from STAR Online S1809000007 REV. C available on Dealer Connect. Also, consider the following: 1) Remove OFA 2) Replace only the oil inlet O-ring and gaskets (seals kit in SOL above). 3) Re-install the OFA. For 2023MY and beyond use black O-ring. For 2022MY and prior use red O-ring. Note: When replacing OFA, it may be necessary to transfer the Oil Temp/Pressure Sensor from the old OFA to the new OFA.
9004452	2023-10-30. Service bulletin. CAMERA, Rear View Prior to replacement, please contact FCA Redacted Content. If no response in 15 minutes, proceed with repair.
S1808000152	2023-10-02. Service bulletin. CEL (Check Engine Lamp) Illuminated, P057B Brake Pedal Position Sensor Performance
BulletinA	2023-07-31. Service bulletin. Customer Satisfaction Notification ZD7 - Radio Software Update
9100133	2023-07-31. Service bulletin. ROCKER ARM ASSY - ROLLER ROCKER Case 1.- Before replacing the intake or exhaust rocker arms due to an abnormal ticking noise, please check that the INTAKE Hydraulic Lash Adjusters are not "collapsed". If a collapsed INTAKE HLA is found, replace all INTAKE HLAs on the suspect cylinder head (no need to replace rocker arms). The noise can occur at low or high RPMs, and at low or high temperatures. There are no Diagnostic Trouble Codes (DTC)s present. Case 2.- If the INTAKE camshaft or INTAKE rocker arm has excessive wear on the high lift profile (Rocker arm: slider, Camshaft: central lobe), replace the intake camshaft (1) in that cylinder head and all intake rocker arms (6).
1802023	2023-04-17. Service bulletin. Flash: Powertrain Control Module (PCM) Updates Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or more of the following Diagnostic Trouble Codes (DTCs) have been set: ? P0335 - Crankshaft Position Sensor Circuit (NA Only). ? P0339 - Crankshaft Position Sensor Intermittent (NA Only). Major monitor (misfire) and other diagnostics are disabled on a pending DTCs P0335 and P0339.** Software enhancement: Technicians and/or customers may report the vehicle will not pass a state smog check due to permanent fault codes which will not clear. As a result, the vehicles are not eligible to be registered in certain states. ? Corrections to allow the vehicle to clear the permanent fault codes. This bulletin involves reprogramming the PCM with the latest available software. NOTE: Four modules are required to be flashed for this update to be effective, the following modules are all to be updated along with this PCM update: ? Electronic Brake Booster Module (EBBM). ? AntiLock Brake System Module (ABS). ? Hybrid Control Processor (HCP) and Auxiliary Hybrid Control Processor (AHCP) or also known as a Power Inverter Module (PIM).
08-009-23	2023-02-13. Service bulletin. UAR and UCR Radio Enhancements Customers may experience one or more of the following: Wi-Fi hotspot connection failure. Speaker popping, crackle noise during Voice Recognition (VR) response. Mobile Station Integrated Services Digital Network (MSISDN) missing from radio, no connected services working. Lost radio presets. High pitch chime noise. Contact list not loading. Remote app inoperative. High pitch squeal, pop or humming sound coming from all of the speakers. Backup camera gridlines missing. Radios resets when a wireless connectivity paired phone receives two text messages one after another simultaneously after approximately seven seconds. (Sales Code ABD). Speaker crackling noise. Unable to adjust volume. Radio may reset /reboot, turn itself off and then back on. Active call not transferred to vehicle wireless connectivity. Voice Recognition (VR) not understanding commands. Wireless connectivity phonebook not available. Anti-theft code request message. Lines appear across screen. Radio will not switch modes between AM, FM, SAT or Media. Poor wireless connectivity sound quality. Phone pairing issues. In addition, the following enhancement is included in this update: Wireless connectivity pair or connection improvements. This bulletin involves inspecting and if required, updating the radio software level to 40.1. Depending on the radio?s current software level the radio may need a one or two USB update.