Service bulletin 1805316

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
Type	Service bulletin
NHTSA id	10218130
Published by NHTSA	2022-08-22
Manufacturer's number	1805316
Manufacturer's date	2016-05-06
NHTSA component	POWER TRAIN

NHTSA's summary

Diagnostic And System Improvements.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Transmission and driveline

Vehicles listed
FIAT 500	2012, 2013

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Recalls for the same vehicles and component
2019577	2019-11-15. Powertrain
19V817000	2019-11-15. POWER TRAIN:AUTOMATIC TRANSMISSION:LEVER AND LINKAGE:FLOOR SHIFT; POWER TRAIN:AUTOMATIC TRANSMISSION
16V302000	2016-05-16. POWER TRAIN:MANUAL TRANSMISSION
2016217	2016-05-12. Powertrain
15V291000	2015-05-18. POWER TRAIN:AUTOMATIC TRANSMISSION
13V358000	2013-08-14. POWER TRAIN

A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.

Other bulletins for the same vehicles and component
9003791	2022-10-31. Service bulletin. 1.4L FIRE Service Engine (Normally Aspirated) This engine in this kit will contain one of 8 different production full dress engines, but labeled as component engine 68275870AA or 71AA. The received engine will be configured for use with an automatic transmission, (includes auto transmission adapter plate / flexplate) or manual transmission. (includes flywheel / clutch asm) The received engine will be configured with or without a block heater. If required, dealer to purchase/install the block heater. The included instruction sheet K6855863AB in engine kit 68275870AA is to be followed for all applications that it applies. Please see the sheet for details. In addition to the items detailed in instruction sheet K6855863AB, please read the following below to determine the rework required to install this engine into a 2012- 2018 Fiat 500 (FF) with 1.4L EAB normally aspirated engine: 1) determine which condition exists for the received service engine a) vehicle has a manual transmission, received manual transmission engine. b) vehicle has a manual transmission, received automatic transmission engine. c) vehicle has an automatic transmission, received automatic transmission engine. d) vehicle has an automatic transmission, received manual transmission engine. 2) follow below steps based on condition (a) through (d) above. Condition a) No further rework required, other than ordering/installing a block heater if required. Condition b) Remove flexplate / auto trans adapter plate / auto trans engine mounting bracket / auto trans engine oil dipstick from new service engine. Transfer flywheel / clutch / manual trans engine mounting bracket / manual trans engine oil dipstick from old engine. Order/install block heater if required. Condition c) Identify the automatic transmission adapter plate on the original engine. Looking at the rear of the vehicle engine with adapter plate mounted:
S1821000001	2022-09-26. Service bulletin. Gear Ratio DTC?s, Transmission Shift Concerns, Does Not Shift At Times, Shudders
9004009	2022-09-26. Service bulletin. Transmission Kit with Torque Converter 1. All Promaster (VF) 3.6L/62TE equipped vehicles. If the transmission bracket to the transmission case fasteners are removed during servicing, the fasteners (Part Number 06511385A$) are one-time usage. Vehicles built prior to 10/23/2015 requires Service Kit PN 68461214AA; includes Transmission Isolator PN 68264483AA, and Adaptation Bracket 68264479AA and Fastener Service Kit PN 68329056AA Vehicles built after on or after 10/23/2015 will require only the Fastener Service Kit PN 68329056AA. 2. All 3.6L/62TE equipped vehicles. If the vehicle you are repairing has a crack in the flex plate or failed pump bushing inspect and confirm that both (2) dowel pins are present in the engine block, which align the transmission center line to the crank shaft centerline and visually inspect the dowel alignment holes in the transmission case. If the holes are damaged or elongated the transmission should be replaced to prevent further damage to the transmission/flexplate or pump bushing due to the inability to properly align the engine to the transmission during the repair. 3. All 62TE equipped vehicles. If pump bushing is scored or damaged and the dowel pin alignment holes are ok, replace the pump assembly as opposed to complete transmission. 4. All 62TE equipped vehicles. If vehicle is jerking/slipping with MIL code(s) P0740 or P2764, check TCC Solenoid operation. If TCC Solenoid is ok, the codes are indicative of a torque converter failure. Replace the torque converter.
18-053-16	2022-08-22. Service bulletin. Flash: 1.4L Diagnostic And System Improvements This bulletin involves reprogramming the Powertrain Control Module (PCM) with the latest available software. Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that the following Diagnostic Trouble Codes (DTCs) have been set: · P1128-00 - Closed Loop Fueling Not Achieved - Bank 1 Upstream. · P1524-00 - Oil Pressure Out Of Range - Camshaft Advance/Retard Disabled (Sales Code EAF only). · P1607-00 - PCM Internal Shutdown Timer Rationality (Sales Code EAB only). · P2610-00 - PCM Internal Engine Off Timer Performance (Sales Code EAB only). · P1239-00 - Engine Oil Temperature Too Low (Sales Code EAB only). · P0298-00 - Engine Oil Temperature Too High (Sales Code EAB only). · P2299-00 - Brake Pedal Position/Accelerator Pedal Position Incompatible. · P0456-00 - Evap System Small Leak. Some customers may also experience the following conditions: · Intermittent fast crank condition. · Cranks as if no compression. · Intermittent crank - no start condition. In addition, the following software enhancement is available: · Scan tool enhancements to communicate with wiTECH to read DTCs descriptions for 2013 MY vehicles equipped with manual transmissions (Sales Code DDF) and Euro 4 Emission W/OBD (Sales Code NB4). · Improved reverse lamp activation time.
08-101-14	2022-08-22. Service bulletin. Convergence Telematics Module (CTM) Software Enhancements This bulletin involves inspecting and if required, replacement of the (CTM). The customer may notice that the displays on the TomTom screen may be missing some Battery Electric Vehicle (BEV) features. Charging schedule screen, power flow screen and charging station icon may be missing.
1802715RevC	2022-08-22. Service bulletin. Diagnostic And System Improvements.
18-027-15 REV. B	2022-07-25. Service bulletin. Flash: 1.4L Diagnostic And System Improvements This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software. Customers may experience one of the following: ? Intermittent fast crank condition ? Cranks as if no compression ? Malfunction Indicator Lamp (MIL) illumination ? Intermittent crank - no start condition The technician may find one or more of the following Diagnostic Trouble Codes (DTCs) are set in the Powertrain Control Module (PCM) memory: ? P1128-00 - Closed Loop Fueling Not Achieved - Bank 1 Upstream ? P1524-00 - Oil Pressure Out Of Range - Camshaft Advance/Retard Disabled (Sales code EAF only) ? P1607-00 - PCM Internal Shutdown Timer Rationality (Sales code EAB only) ? P2610-00 - PCM Internal Engine Off Timer Performance (Sales code EAB only) ? P1239-00 - Engine Oil Temperature Too Low (Sales code EAB only) ? P0298-00 - Engine Oil Temperature Too High (Sales code EAB only) ? P2299-00 - Brake Pedal Position/ Accelerator Pedal Position Incompatible ? P0456-00 - Evap System Small Leak ? P0456-00 - Evap System Small Leak
21-002-13	2022-07-18. Service bulletin. This bulletin involves insepcting and if necessary replacing the shift knob. Chrome top cap on the shift knob is loose.
1805316	2022-07-05. Service bulletin. Diagnostic And System Improvements.
21-002-13	2021-03-15. Service bulletin. This bulletin involves insepcting and if necessary replacing the shift knob. Chrome top cap on the shift knob is loose.