Service bulletin Mil
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10213447 |
| Published by NHTSA | 2022-06-06 |
| Manufacturer's number | Mil |
| Manufacturer's date | 2021-03-16 |
| NHTSA component | SERVICE BRAKES; FUEL SYSTEM, GASOLINE; BACK OVER PREVENTION |
NHTSA's summary
MIL ON WITH DTC PO451 AND/OR PO12A Some customer s may complain about a MIL ON with DTC P0451 (Fuel tank pressure sensorL sensor characteristic malfunction) and/or P013A (HO2S: Slow response (during transition from rich to lean)) Recall 8615J repair procedure may correct this concern
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Brakes, Driver assistance, Fuel system, Backup camera
Trouble codes named
P013A, P0451
| MAZDA MAZDA3 | 2015, 2016 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 23V487000 | 2023-07-14. BACK OVER PREVENTION: SENSING SYSTEM: CAMERA |
|---|
A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.
| 09-032-23 | 2023-10-05. Service bulletin. SERVICE BULLETIN 09-031/20 ISSUED ON 09/21/20 IS NO LONGER VALID. IT IS SUPERCEDED BY RECALL 6023G (“2014-2018 MAZDA3 AND 2016-2021 CX-3 - REARVIEW IMAGE MAY NOT DISPLAY PROPERLY”). |
|---|---|
| Issues | 2022-06-06. Service bulletin. Active driving display caution (Update) |
| SA-001/22 | 2022-02-04. Service bulletin. Symptom troubleshooting tables to diagnose MAZDA CONNECT concerns. No. 1 Blank Screen No. 2. Rear View Camera is not displayed No. 3 Rebooting No. 4 Infotainment System Has No Sound No. 5 Commander Switch Does Not Work No. 6 Bluetooth device will not pair No. 7 Incorrect GPS position No. 8 Voice Recognition Does Not Work No. 9 Cannot Make a Hands-Free Call No. 10 Cannot Play Bluetooth Audio No. 11 Other Symptoms No. 12 How to update the Navigation SD Card Map No. 13 How to Check Navi SD Card VIN Lock |
| 09-038-16 | 2021-01-25. Service bulletin. Some vehicles may experience a rattle noise from the front door glass when driving with the window open approx 1/2 to 4 inches (1-10 cm) |
| 02-001-16 | 2021-01-25. Service bulletin. Popping and/or squeaking noise from front shock absorber and or creaking noise from front lower arm bushing. |
| 01-018-16 | 2021-01-25. Service bulletin. Unusual engine noise after a cold engine start. Some customers may complain about an unusual noise coming from the engine compartment for about 20 seconds after a cold engine start. This noise is a normal engine operation for improved exhaust gas emissions. The noise does not indicate a malfunction. |
| 02-005-17 | 2021-01-25. Service bulletin. Popping and/or squeaking noise from front shock absorber and or creaking noise from front lower arm bushing. Some vehicles may exhibit one or more of the following noises from the front suspension. * A squeaking noise from the front shock absorber when turning the steering wheel at a vehicle standstill caused by stick0slip between the front strut bearing and the coil spring. * A popping noise from the front shock absorber when passing over speed bumps caused by the bump stopper cointacting the strut bearing when the shock absorber is compressed. * A creaking noise from the lower arm when driving over road bumps at 20-40 km/h caused by stick-stick-slip of the front lower arm bushing. The noise occurs when the road surface is wet or after a car washing, and becomes moare noticeable as the speed bump gets higher. * To correct these problems, the following changes have been made. * For the squeaking and popping noise, the fshape of the bump stopper has been modified and a protector has been installed onto the coil spring. * For the creaking noise, the friction of the lower arm bushing has been reduced by adding a dry coating. Customers having this concern should have their vehicle repaired using the following repair procedure. |
| 09-031-20-3736 | 2020-10-03. Service bulletin. Some vehicles may exhibit a distorted image or no image from the rear mount camera when shifted into reverse. Due to friction, the coating of camera socket terminals may wear out, creating high electrical resistance. NOTE: The icons and the messages are displayed normally. |
| SA-038-20 | 2020-04-06. Service bulletin. Some customers may complain about a rear view monitor display that is: • Blank (or may have backup camera warning message) • Distorted • Blurry • Fuzzy • Split screen (see attached video) • Grainy. The icons and text are normally displayed. |
| SA-006-19a | 2019-05-30. Service bulletin. Some customers may complain about a MAZDA CONNECT system reboot or blank screen. Use the flowchart below to repair the vehicle. |