Service bulletin NTB21-118

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
Type	Service bulletin
NHTSA id	10206389
Published by NHTSA	2022-01-08
Manufacturer's number	NTB21-118
Manufacturer's date	2021-12-17
NHTSA component	STRUCTURE; VISIBILITY:GLASS, SIDE/REAR

NHTSA's summary

RESIDUE ON OUTER SURFACE OF FRONT DOOR GLASS IF YOU CONFIRM Adhesive residue is found on the outer surface of front driver (LH) side and/or front passenger (RH) side window glass. ACTION Follow the service procedure in this bulletin to: 1. Remove the door finisher on the affected side. 2. Confirm that the Intelligent Key door request switch wiring harness is contacting the glass. 3. Reroute the harness as needed. 4. Confirm that the harness is no longer contacting the glass.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Body and frame, Glass, wipers and mirrors

Vehicles listed
NISSAN FRONTIER	2022

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Recalls for the same vehicles and component
2022599	2022-10-21. Visual System
2022398	2022-07-22. Visual System

A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.

Other bulletins for the same vehicles and component
NTB09-131C	2026-04-29. Service bulletin. CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).
NTB09-131C	2026-04-29. Service bulletin. CERTIFICATION LABEL AND VIN PLATE REPLACEMENT SERVICE INFORMATION Because of collision damage or other vehicle repair, a replacement “Certification Label” or “VIN Plate/Label” may be needed. HINT: Certification Label = FMVSS (Federal Motor Vehicle Safety Standards) label. These items may be available from Nissan by request if certain criteria are met. This bulletin lists the criteria and provides an application form for such replacements. · The “VIN Plate/Label” (metal plate or vinyl label) is attached to the instrument panel or body on the driver side at the base of the windshield (see Figure 1). · The “Certification Label” (vinyl adhesive label) is located on the lower area of the driver side B-Pillar (see Figure 1).
NTB25-042	2025-09-15. Service bulletin. EXCESSIVE WIND NOISE FROM WINDSHIELD AREA YOU CONFIRM The customer states there is a screeching, humming, buzzing, whistling and/or squealing type wind noise from the windshield/roof area of the vehicle, AND The wind noise is most noticeable at speeds of 50 mph or higher. ACTION Use the SERVICE PROCEDURE starting on page 4 to install two (2) pieces of foam (one on each side) between the windshield molding and the body roof line. IMPORTANT: The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair.
NTB22-104A	2024-06-13. Service bulletin. DIAGNOSING DOOR LOCK OPERATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB17-019H	2024-06-07. Service bulletin. WINDOW GLASS WARRANTY INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB13-028I	2024-06-07. Service bulletin. REMOVING FOREIGN MATERIAL FROM THE WINDOW GLASS This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB09-081K	2024-06-07. Service bulletin. WINDSHIELD CRACKING This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB21-019C	2024-01-09. Service bulletin. FRONT MAP LAMP NOT WORKING OR SWITCH COMING APART This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB23-037	2023-05-06. Service bulletin. MANUAL SEAT TRACK ADJUSTMENT DOES NOT LOCK INTO POSITION IF YOU CONFIRM The seat track latching pawls for a front seat (left or right) are not synchronized. • The inboard track latches, but the outboard track does not latch unless the seat is pushed/pulled into position. HINT: The customer may report the following if this issue should occur: • The seat track seems loose when braking or accelerating. • The seat track is difficult to lock in place. • After adjusting the seat track, it shifts/locks into place while driving. ACTION Adjust/synchronize the outboard seat track following the SERVICE PROCEDURE in this bulletin.
NTB21-019B	2023-04-10. Service bulletin. FRONT MAP LAMP NOT WORKING OR SWITCH COMING APART This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.