WenmarOpen by Wenmar Pro

Service bulletin SSM 50105

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id10201588
Published by NHTSA2021-09-28
Manufacturer's numberSSM 50105
Manufacturer's date2021-09-10
NHTSA componentEQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT; VISIBILITY:SUN/MOON ROOF ASSEMBLY

NHTSA's summary

Some 2020-2021 Corsair/Escape vehicles may exhibit issues with the roof opening panel shield feature of the roof opening panel where a replacement shield pilot clip is needed. The shield pilot clips are now available separately for service, Part Number LJ6Z-5452118-A. Reference Workshop Manual (WSM), Section 501-17. Replacement of the roof opening panel sun shade is not necessary when only replacing the shield pilot clips.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Equipment and accessories, Glass, wipers and mirrors, Sunroof

Vehicles listed
FORD ESCAPE2020, 2021
LINCOLN CORSAIR2020, 2021

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Other bulletins for the same vehicles and component
TSB 20-23812020-12-05. Service bulletin. Some 2020 Escape/Corsair vehicles equipped with a roof opening panel may exhibit a bounce back when closing. This may be more noticeable when the engine is running. This may be due to the glass panel adjustment. To correct the condition, follow the Service Procedure steps to adjust the roof opening panel glass.
SSM 490872020-09-04. Service bulletin. Some 2020 Escape/Corsair vehicles equipped with a roof opening panel may exhibit a flutter, drone, hum, and/or vibration noise while driving. This may be due to an incorrectly adjusted roof opening panel. Components should not be replaced for this condition. Adjust the roof opening panel so that the front edge of the sliding glass panel is contacting the margin seal. Refer to Workshop Manual (WSM), Section 501-17. After adjustment perform a power roof opening panel initialization. Refer to WSM, Section 501-17.