Service bulletin NTB10104B

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
Type	Service bulletin
NHTSA id	10192747
Published by NHTSA	2021-05-10
Manufacturer's number	NTB10104B
Manufacturer's date	2016-02-25
NHTSA component	ENGINE AND ENGINE COOLING

NHTSA's summary

IF YOU CONFRIM An oil leak at the right side block ball plug behind the alternator. ACTION Use a punch to seat the block ball plug in the hole (refer to the Service Procedure). NOTE - Do not replace the engine block for this incident if it should occur. See this bulletin for further detail.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Engine

Vehicles listed
NISSAN ARMADA	2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014
NISSAN NV	2012, 2013, 2014, 2015, 2016
NISSAN TITAN	2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Recalls for the same vehicles and component
2011436	2011-12-20. Engine
11V592000	2011-12-19. ENGINE AND ENGINE COOLING
2010373	2010-10-28. Engine
10V517000	2010-10-28. ENGINE AND ENGINE COOLING

A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.

Other bulletins for the same vehicles and component
NTB22-026	2022-06-08. Service bulletin. SERVICE INFORMATION FOR FUEL GAUGE INACCURATE WITH DTCS STORED IN ECM SERVICE INFORMATION If a fuel level sensor has been diagnosed as sending an incorrect level signal, and one or more of the following DTCs are stored in the ECM, do not replace the entire “Fuel Level Sensor Unit, Fuel Filter and Fuel Pump Assembly” (fuel pump assembly). The fuel level sensor can be replaced separately. • P0460 (FUEL LEV SEN SLOSH) • P0461 (FUEL LEVEL SENSOR) • P0462 (FUEL LEVL SEN/CIRC) • P0463 (FUEL LEVL SEN/CIRC) NOTE: Warranty claims referring to fuel level issues that result in the replacement of the entire fuel pump assembly will be charged back.
NTB17-082E	2022-03-12. Service bulletin. DTC P0456 CAUSED BY EVAP LEAK AT VENT CONTROL VALVE O-RING This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB13-097J	2022-03-12. Service bulletin. EVAP LEAK DTC P0442, P0455, P0456 INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB13-027C	2022-03-12. Service bulletin. CAN COMMUNICATION – NETWORK DIAGNOSTIC FLOW CHART This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.
NTB15097	2021-05-10. Service bulletin. IF YOU CONFIRM: Coolant is leaking from the connector cap (bleeder cap). ACTION: 1. Remove the bleeder cap. 2. Install the new bleeder cap in reverse order of removal. See this bulletin for further details.
NTB15055	2021-05-10. Service bulletin. SERVICE INFORMATION After ECM reprogramming, the Calibration Verification Number (CVN) needs to be automatically calculated prior to State emissions testing (also known as Inspection Maintainence, I/M, or SMOG testing depending upon location). Allowing the vehicle to idle for 22 minutes will allow for faster CVN calculation. It is recommended that customers utilize this method if the vehicle needs to be tested for emissions soon after ECM reprogramming. See this bulletin for further detail.
NTB14109	2021-05-10. Service bulletin. SERVICE INFORMATION Starting with 2010 Model Year, Nissan vehicles have been gradually incorporating a new type of DTC known as Permanent DTC or P-DTC. If a vehicle is equipped with P-DTCs, all emission related DTCs will also set a P-DTC if the MIL is turned ON. A listing of which DTCs that will also set a P-DTC is found in the DTC Index in the EC-Engine Control section of the Electronic Service Manual (ESM). If a DTC repair is performed and the DTC erased, a vehicle may fail an Emission Inspection and Maintenance test if the P-DTC is not also erased. See this bulletin for further detail.
NTB13102A	2021-05-10. Service bulletin. IF YOU CONFIRM * The MIL is on with a current or past DTC of P0448 (Evap Canister Vent Control Valve) set. ACTION Confirm that the Tube Assy-Filler is the updated part as shown in Figure 2. * If the Tube Assy-Filler is the old style as shown in Figure 1, replace it with the Tube Assy-Filler (Figure 2) from the Parts Information on the next page. * If the Tube Assy-Filler is the new style as show in Figure 2, replace only the "Vent Filter" also shown in Figure 2 with the procedure on page 2. Please see this bulletin for further details.
NTB14062	2021-05-10. Service bulletin. SERVICE INFORMATION If a customer requests to have an accessory engine cooling fan installed on their vehicle, follow the Service Tips contained in this bulletin.
NTB12091A	2021-05-10. Service bulletin. SERVICE INFORMATION Replacement Engine Control Modules (ECMs) for many newer Nissan vehicles are now "Blank" ECMs. Blank ECMs come without software and must be programmed (not reprogrammed) before they will function. See this bulletin for further detail.