WenmarOpen by Wenmar Pro

Service bulletin NTB13040A

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id10192207
Published by NHTSA2021-05-10
Manufacturer's numberNTB13040A
Manufacturer's date2013-07-05
NHTSA componentSUSPENSION; EQUIPMENT; POWER TRAIN; BACK OVER PREVENTION; ELECTRICAL SYSTEM

NHTSA's summary

IF YOU CONFIRM: A rattle or groan type noise is coming from the right front strut tower / engine area when: - An applied vehicle is traveling at 20 - 40 MPH AND / OR - The engine is running at 1,400 - 1,500 RPM AND - The generator (alternator) is the source of the noise. NOTE: This noise may be misdiagnosed as CVT or heat shield related. ACTION: Replace the alternator with the one listed in PARTS INFORMATION. - Refer to the M ELECTRICAL & POWER CONTROL > CHG Charging System section of the Electronic Service Manual (ESM). See this bulletin for further detail.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Driver assistance, Electrical system, Equipment and accessories, Suspension, Transmission and driveline, Backup camera

Vehicles listed
NISSAN ALTIMA2013

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Other bulletins for the same vehicles and component
NTB13106E2021-05-10. Service bulletin. SERVICE INFORMATION If the configuration of the Audio/Navigation unit has not been completed correctly, some of the symptoms that may occur are: * Intermittent or no back up camera operation * No steering wheel switch response to audio inputs * No volume response from volume knob * Volume very loud or very quiet and adjustment is overly sensitive * Equalizer is adjusted so that Bass control is at maximum all the time * DTC U1000 for AVM C/U could be present If the above symptoms occur: * Confirm the configuration of the Audio/Navigation unit is correct. NOTE: Correct configuration of the appropriate control unit will restore correct operation. Audio/Navigation unit configuration is outlined starting on page 2. See this bulletin for further detail.
NTB160232021-05-10. Service bulletin. IF YOU CONFIRM A customer concern of while turning the steering wheel or when driving at low speed (straight or turning), a high pitch power steering noise can be heard. * Only while seated inside the vehicle And * With all of the windows up NOTE: If the audio and/or HVAC systems are turned ON it may be difficult to hear this issue. ACTION Install an Insulator onto the end of the power steering pump motor housing with the Service Procedure starting on the next page. Please see this bulletin for further details.
NTB151022021-05-10. Service bulletin. IF YOU CONFIRM: A whine or grind type noise heard during acceleration and/or constant highway speeds. -The level of noise may increase as vehicle speed increases AND there are no other drivability issues or stored DTCs related to the CVT assembly (CVT). ACTION: Refer to the REPAIR FLOW CHART on page 3 for repair procedure. Refer to page 2 for information on special service tools. NOTE: Parts Kit #1 (see PARTS INFORMATION) must be available at the time the reduction gear bearing shim selection procedure, starting on page 11, is to be performed. See this bulletin for further detail.
NTB13088A2021-05-10. Service bulletin. SERVICE INFORMATION This bulletin has compiled Tire Pressure Monitor System (TPMS) and Low Tire Pressure Warning System (LTPWS) information for: - Basic diagnosing of TPMS/LTPWS systems - Radio frequency interference causing a "No Data" (C1708, C1709, C1710, C1711) condition - Sensor leaks - Moving TPMS/LTPWS wheel assemblies from one vehicle to another and TPMS/LTPWS sensor registration - Air pressure changes with altitude and ambient temperatures - Aftermarket tire sealers - Aftermarket wheels - Inflating/deflating tires with TPMS/LTPWS sensors See this bulletin for further detail.
NTB12055E2021-05-10. Service bulletin. IF YOU CONFIRM: Customers concern of a "clicking" noise coming from either left or right front/rear CV-type axles during take-off/acceleration. ACTION: Apply Molykote M77 grease (P/N 44003-7S000) to the hub bearing surfaces. NOTE: * Do not remove the axle from the hub or transmission for this bulletin * Refer to the Electronic Service Manual (ESM) for model specific torque specifications. - For 2007-2013 Versa and 2013 LEAF vehicles, see the Service Procedure torque specifications on page 4. See this bulletin for further detail.
NTB150602021-05-10. Service bulletin. SERVICE INFORMATION When servicing run flat tires or low profile tires: - Special equipment and procedures are required to avoid damage. - Specifically, Tire Pressure Monitor transmitters (TPMS sensors) can be damaged when improperly dismounting and mounting tires. - TPMS sensors becoming damaged during mounting or dismounting tires are not covered under warranty. - To avoid such damage, ensure that the tire changer being used and the operator of the tire changer is capable of servicing run flat and low profile tires. - Operator?s manuals for such tire changers must be followed. See this bulletin for further detail.
NTB12051J2021-05-10. Service bulletin. IF YOU CONFIRM The MIL is ON with DTC P0101 for Mass Air Flow sensor (MAF) stored in the ECM, AND there are no drivability concerns. ACTION 1. Refer to step 6 in the SERVICE PROCEDURE to confirm this bulletin applies to the vehicle you are working on. 2. If this bulletin applies, reprogram the ECM. See this bulletin for further detail.
NTB00042D2021-05-10. Service bulletin. SERVICE INFORMATION Changes or modifications to the front seat assembly trim materials may affect the proper operation of the Front Seat-Mounted Side-Impact Supplemental Air Bags and Passenger Occupant Classification Sensor and could result in serious personal injury or death. Nissan STRONGLY RECOMMENDS AGAINST making any change to seat trim materials from the factory equipped condition. This specifically applies to replacing the seat trim with non-factory materials; adding leather/cloth seat covers, seat pads, or seat storage pouches, etc. around or over the seat back and the passenger seat cushion. See this bulletin for further detail.
NTB130602021-05-10. Service bulletin. SERVICE INFORMATION On vehicles equipped with Navigation or Base Audio, the HVAC Display Screen, Base Audio display and overhead Lamp (located in overhead console) may shut off (black out) if the daytime or nighttime illumination controls are set to less than 1 bar. * Under these conditions the operation of the HVAC display, Base Audio unit and the overhead lighting illumination are possibly operating correctly, simply need adjustment, and should not be replaced. Please see this bulletin for further details.
NTB130422021-05-10. Service bulletin. IF YOU CONFIRM: A buzz or rattle type noise is coming from either front door ONLY when operating the audio system with a lot of bass. - The noise stops when applying pressure to the top of the front door power window and door lock switch finisher(s). - ANY noises heard from any other area under the same conditions are not related to this incident. ACTION: Replace both front door power window and door lock switch finishers. CAUTION: The pull handle outer finisher must be removed before removing each front door power window and door lock switch. - Do not replace the front door power window and door lock switches OR speakers for this incident, if it should occur. - Do not remove the front door finishers (door panels) when removing the power window and door lock switches. It is not necessary. - This bulletin does not apply to similar noises in areas other than the front door power window and door lock switches during audio system use. See this bulletin for further detail.