Service bulletin NTB11073A

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
Type	Service bulletin
NHTSA id	10192117
Published by NHTSA	2021-05-10
Manufacturer's number	NTB11073A
Manufacturer's date	2013-01-28
NHTSA component	BACK OVER PREVENTION:SOFTWARE

NHTSA's summary

On the Applied Vehicles listed in this bulletin, the navigation, mobile phone, iPod®, and voice recognition functions may not be working as intended. To remedy this potential condition, Nissan is conducting this voluntary service campaign to update the navigation software at no charge for parts or labor. In addition, as part of this navigation software update, a call waiting function will be added to the hands-free phone system. See this bulletin for further detail. Campaign ID# P1234

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Driver assistance, Backup camera

Vehicles listed
NISSAN 370Z	2010, 2011
NISSAN ALTIMA	2010, 2011
NISSAN GT-R	2010, 2011
NISSAN MAXIMA	2010, 2011

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Other bulletins for the same vehicles and component
NTB13079D	2021-05-10. Service bulletin. IF YOU CONFIRM: The vehicle speed is, or was, reduced by the CVT fail-safe (reduced vehicle speed) after continuous operation under the following conditions: * High RPM and/or high speed driving (RPM of 4000+ or speeds of 65 mph (104.6 km/h) for 1.0 - 1.5hrs or more) * Driving in ambient temperature of 96 degrees or higher * Climbing steep or extended hills for 6 miles (9.6 km) or more * Whine or rattle type noise occurring during reduced engine performance (vehicle speed decrease) ACTIONS: Install the SERVICE KIT-COOLER ASSY. See this bulletin for further detail.
NTB13088A	2021-05-10. Service bulletin. SERVICE INFORMATION This bulletin has compiled Tire Pressure Monitor System (TPMS) and Low Tire Pressure Warning System (LTPWS) information for: - Basic diagnosing of TPMS/LTPWS systems - Radio frequency interference causing a "No Data" (C1708, C1709, C1710, C1711) condition - Sensor leaks - Moving TPMS/LTPWS wheel assemblies from one vehicle to another and TPMS/LTPWS sensor registration - Air pressure changes with altitude and ambient temperatures - Aftermarket tire sealers - Aftermarket wheels - Inflating/deflating tires with TPMS/LTPWS sensors See this bulletin for further detail.
NTB12055E	2021-05-10. Service bulletin. IF YOU CONFIRM: Customers concern of a "clicking" noise coming from either left or right front/rear CV-type axles during take-off/acceleration. ACTION: Apply Molykote M77 grease (P/N 44003-7S000) to the hub bearing surfaces. NOTE: * Do not remove the axle from the hub or transmission for this bulletin * Refer to the Electronic Service Manual (ESM) for model specific torque specifications. - For 2007-2013 Versa and 2013 LEAF vehicles, see the Service Procedure torque specifications on page 4. See this bulletin for further detail.
NTB15060	2021-05-10. Service bulletin. SERVICE INFORMATION When servicing run flat tires or low profile tires: - Special equipment and procedures are required to avoid damage. - Specifically, Tire Pressure Monitor transmitters (TPMS sensors) can be damaged when improperly dismounting and mounting tires. - TPMS sensors becoming damaged during mounting or dismounting tires are not covered under warranty. - To avoid such damage, ensure that the tire changer being used and the operator of the tire changer is capable of servicing run flat and low profile tires. - Operator?s manuals for such tire changers must be followed. See this bulletin for further detail.
NTB09147A	2021-05-10. Service bulletin. IF YOU CONFIRM A rattle noise coming directly from the rear tail shaft area of the flywheel housing, ACTION Replace the Flywheel housing with the new one listed in the Parts Information of this bulletin. See this bulletin for further detail.
NTB12051J	2021-05-10. Service bulletin. IF YOU CONFIRM The MIL is ON with DTC P0101 for Mass Air Flow sensor (MAF) stored in the ECM, AND there are no drivability concerns. ACTION 1. Refer to step 6 in the SERVICE PROCEDURE to confirm this bulletin applies to the vehicle you are working on. 2. If this bulletin applies, reprogram the ECM. See this bulletin for further detail.
NTB00042D	2021-05-10. Service bulletin. SERVICE INFORMATION Changes or modifications to the front seat assembly trim materials may affect the proper operation of the Front Seat-Mounted Side-Impact Supplemental Air Bags and Passenger Occupant Classification Sensor and could result in serious personal injury or death. Nissan STRONGLY RECOMMENDS AGAINST making any change to seat trim materials from the factory equipped condition. This specifically applies to replacing the seat trim with non-factory materials; adding leather/cloth seat covers, seat pads, or seat storage pouches, etc. around or over the seat back and the passenger seat cushion. See this bulletin for further detail.
NTB10125E	2021-05-10. Service bulletin. IF YOU CONFIRM One or more of the following is occurring on an Applied Vehicle: -- Audio streaming via Bluetooth is "choppy" or "clipped." -- "Calculating Route" takes an extended period of time (2-5 minutes) to complete. -- "Could not find a route" displays when attempting to calculate a route. -- Voice Recognition sequence takes too many steps. -- Voice Recognition has difficulty recognizing voicetags. -- The Navigation system reboots. -- XM NavTraffic is slow to report. -- "Handset Phonebook" access is slow. -- When a hands-free call via Bluetooth is in progress and another call comes in ("call waiting"), there is no function available to answer the incoming call. -- Caller ID is not available when a hands-free call via Bluetooth is in progress and another call comes in. ACTION 1. Perform steps 1-7 of Confirm Navigation Program Version in the Service Procedure to verify whether or not this bulletin applies. 2. If this bulletin applies, load the Reprogramming Software DVD referenced in the Parts Information section. See this bulletin for further detail.