Service bulletin N10040413
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10188658 |
| Published by NHTSA | 2021-03-15 |
| Manufacturer's number | N10040413 |
| Manufacturer's date | 2013-04-04 |
| NHTSA component | EQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT; POWER TRAIN |
NHTSA's summary
Some of the above vehicles may experience a condition where the underbody transmission tunnel shield may partially separate from the vehicle floor pan and contact the aluminum driveshaft. Operating the vehicle with the transmission tunnel shield rubbing against the driveshaft could weaken the driveshaft at the rub point and cause it to break.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Equipment and accessories, Transmission and driveline
| DODGE NITRO | 2007, 2008 |
|---|---|
| JEEP LIBERTY | 2007, 2008 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 2013102 | 2013-04-05. Powertrain |
|---|---|
| 13V121000 | 2013-04-03. STRUCTURE; AIR BAGS; POWER TRAIN:DRIVELINE:DRIVESHAFT |
| 2006218 | 2006-09-08. Powertrain |
| 06V341000 | 2006-09-07. POWER TRAIN:AUTOMATIC TRANSMISSION |
A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.
| S1121000006RevA | 2022-09-26. Service bulletin. (Revision A) No Start No Crank ? Starter Will Not Engage And There Are No Related Codes Or Concerns |
|---|---|
| 9004009 | 2022-09-26. Service bulletin. Transmission Kit with Torque Converter 1. All Promaster (VF) 3.6L/62TE equipped vehicles. If the transmission bracket to the transmission case fasteners are removed during servicing, the fasteners (Part Number 06511385A$) are one-time usage. Vehicles built prior to 10/23/2015 requires Service Kit PN 68461214AA; includes Transmission Isolator PN 68264483AA, and Adaptation Bracket 68264479AA and Fastener Service Kit PN 68329056AA Vehicles built after on or after 10/23/2015 will require only the Fastener Service Kit PN 68329056AA. 2. All 3.6L/62TE equipped vehicles. If the vehicle you are repairing has a crack in the flex plate or failed pump bushing inspect and confirm that both (2) dowel pins are present in the engine block, which align the transmission center line to the crank shaft centerline and visually inspect the dowel alignment holes in the transmission case. If the holes are damaged or elongated the transmission should be replaced to prevent further damage to the transmission/flexplate or pump bushing due to the inability to properly align the engine to the transmission during the repair. 3. All 62TE equipped vehicles. If pump bushing is scored or damaged and the dowel pin alignment holes are ok, replace the pump assembly as opposed to complete transmission. 4. All 62TE equipped vehicles. If vehicle is jerking/slipping with MIL code(s) P0740 or P2764, check TCC Solenoid operation. If TCC Solenoid is ok, the codes are indicative of a torque converter failure. Replace the torque converter. |
| 9004361 | 2022-09-26. Service bulletin. NAG1 Transmission Before installing the transmission with the engine, check for dowel pins (2) for alignment. If the pins are missing request to add the dowel pin first and then install the transmission |
| 9001784 | 2022-09-26. Service bulletin. Mechanical rocker arm, intake, 1.7 ratio. |
| 3100619 | 2022-09-15. Service bulletin. Repair Parts Used For Structural Repairs This bulletin involves discussing FCA US LLC position with regard to structural repair parts usage. |
| 9001745 | 2022-07-25. Service bulletin. 05174039A$, 05072384A$, 05072138A$ - A/C Pressure Transducer For vehicles calling out AC Pressure Transducer Kit 05072138AA as a service part but built with different mating wiring connector (round) - also order connector repair kit 05019958AA (square).~ 2007MY RAM Trucks equipped with 6.7L Cummins turbo diesel engine only: If the A/C pressure transducer requires replacement, use part number 05072138AA that has a rectangular shaped electrical connector. If the engine wiring harness has a circular wiring connector, use jumper harness 68028774AA to change it to a rectangular connector.~ 6.7L RAM trucks built before10/17/2006 has pressures transducers (p/n 05191766AA) with a round connector that should have been changed per RRT 06- 068 to a rectangular transducer.~ 2001-2008 KJ, K1, ND.~ |
| N10040413 | 2022-07-18. Service bulletin. Some of the above vehicles may experience a condition where the underbody transmission tunnel shield may partially separate from the vehicle floor pan and contact the aluminum driveshaft. Operating the vehicle with the transmission tunnel shield rubbing against the driveshaft could weaken the driveshaft at the rub point and cause it to break. |
| 9001784 | 2021-05-03. Service bulletin. Mechanical rocker arm, intake, 1.7 ratio. |
| 9004361 | 2021-04-26. Service bulletin. NAG1 Transmission Before installing the transmission with the engine, check for dowel pins (2) for alignment. If the pins are missing request to add the dowel pin first and then install the transmission |
| S1121000006 Rev. | 2020-09-28. Service bulletin. (Revision A) No Start No Crank ? Starter Will Not Engage And There Are No Related Codes Or Concerns |