Service bulletin B610620
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10174020 |
| Published by NHTSA | 2020-04-20 |
| Manufacturer's number | B610620 |
| Manufacturer's date | 2020-04-01 |
| NHTSA component | VEHICLE SPEED CONTROL |
NHTSA's summary
TAILGATE MALFUNCTION WHEN OPENING OR CLOSING: This Service Information Bulletin (Revision 1) replaces SI B61 06 20 dated February 2020. Customer may complaint of any the following scenarios: When operating the tailgate by using any of the tailgate buttons the movement stops Tailgate opens when the remote control is within the proximity of the rear of the vehicle and a second person opens any of the doors using the outside door handle Tailgate opens again immediately after closing Erroneous ground signal set by the contactless tailgate opening control unit (smart-opener).
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Throttle and cruise control
| BMW M2 | 2020 |
|---|---|
| BMW R 1250 GS ADVENTURE | 2020 (the catalog's model; the bulletin names a series or trim of it) |
| BMW X1 | 2016, 2017, 2018, 2019, 2020 |
| BMW X1 SAV | 2016 to 2017 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| B660523 | 2023-11-01. Service bulletin. Various functions of the camera-based driver assistance systems (ADCAM system) can lead to customer complaints. |
|---|---|
| B660916 | 2018-12-10. Service bulletin. """Collision Warning Failed"" or ""Pedestrian Warning Failed"" CCM Display. While driving, a Check Control Message (CCM) is displayed advising of the following: Front collision warning failed Pedestrian detection failed The following fault code is stored in the KAFAS (Camera-based Driver Assistance System): 0X800AC4 - Camera calibration failed The KAFAS camera is not properly mounted and secured to the mounting bracket on the windshield; And/ or: The mounting bracket glued to the windshield is not installed correctly. The pictures below show both incorrect and correct installation. This picture shows the KAFAS camera installed in the bracket. Notice the spacing highlighted by the ""green lines""" |