Service bulletin 9004116
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10173269 |
| Published by NHTSA | 2020-04-06 |
| Manufacturer's number | 9004116 |
| Manufacturer's date | 2020-02-05 |
| NHTSA component | VEHICLE SPEED CONTROL; PARKING BRAKE |
NHTSA's summary
HANDLE AND CABLE, Seat Release If you have a 2 door vehicle built after 8/6/2019 with an EZ entry handle that is loose or appears broken, please call FCA Redacted Content prior to replacing any parts. If no response in 15 minutes, proceed with repair. EZ entry handle mounting bracket may have grease present which may have damaged the plastic of the EZ entry handle. Thoroughly clean mounting bracket of any contamination prior to installing a new EZ entry handle as outlined in Service Bulletin 23-002-20.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Brakes, Throttle and cruise control, Parking brake
| JEEP WRANGLER | 2019, 2020 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 18-003-23 | 2023-02-13. Service bulletin. Flash: Powertrain Control Module (PCM) Updates Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or more of the following Diagnostic Trouble Codes (DTCs) have been set: **P016F - Closed Loop Fuel Pressure Control At Limit - Pressure Too Low. P025C - Fuel Pump Module Control Circuit Low. P208B - Reductant Pump 1 Control Performance. P0300-00 - Multiple Cylinder Misfire (MIL Illuminated During 4WD-LO Only). P0301-00 - Cylinder 1 Misfire (MIL Illuminated During 4WD-LO Only). P0302-00 - Cylinder 2 Misfire (MIL Illuminated During 4WD-LO Only). P0303-00 - Cylinder 3 Misfire (MIL Illuminated During 4WD-LO Only). P0304-00 - Cylinder 4 Misfire (MIL Illuminated During 4WD-LO Only). P0305-00 - Cylinder 5 Misfire (MIL Illuminated During 4WD-LO Only). P0403-00 - EGR Control Circuit Open ? Disabled Fault.** P225D-00 - NOX Sensor 1/1 Performance Signal Stuck Low. P249C-00 - Excessive Time To Enter Closed Loop Reductant Injection Control. P065A - Generator System Performance. P00F4-00 - Humidity Sensor Circuit Low. P20FB-00 - Reductant Pump 2 Control Performance. P200A-00 - Intake Manifold Runner Performance Bank 1. P200B-00 - Intake Manifold Runner Performance Bank 2. P2610 - PCM Internal Engine Off Timer Performance. P0534-00 - AC Refrigerant System A Charge Loss. P04DB-00 - Crankcase Ventilation System Disconnected. P204F-00 - Reductant System Performance. P2199-00 - Intake Air Temperature Sensor 1/2 Correlation. P0087-00 - Fuel Rail Pressure Too Low (with rapid apply and release of accelerator pedal). P0306-00 - Cylinder 6 Misfire. P01CB-00 - Cylinder 1 Injection Timing Performance Over Retarded. P01CC-00 - Cylinder 1 Injection Timing Performance Over Advanced. P01CD-00 - Cylinder 2 Injection Timing Performance Over Retarded. P01CE-00 - Cylinder 2 Injection Timing Performance Over Advanced. P01CF-00 - Cylinder 3 Injection Timing Performance Over Retarded. P01D0-00 - Cylinder 3 Injection Timi |
|---|---|
| S2108000170 | 2023-01-17. Service bulletin. Head unit button stuck DTC code B14DA-2A |
| S2108000170 | 2022-09-26. Service bulletin. Head unit button stuck DTC code B14DA-2A |
| 9004175 | 2022-09-15. Service bulletin. LATCH, Folding Top For a concern of a loose latch in the closed position, it is not necessary to replace the latch unless broken. Refer to instructions in service library. The position of the receiver attached to the vehicle header can be adjusted to change the ammount of force required to latch. |
| 9004017 | 2022-09-15. Service bulletin. CAMERA, Rear View For concerns of back up camera flicker/blank/blue/black screen or camera inop, please ensure Radio is at latest software level. After update, system requires three sleep cycles to function properly. Please verify camera LVDS cable connection at camera and radio head unit. Also verify harness connection between high mounted stop lamp and body harness for bent pins or loose connection at XY310A, XY485A. Please create and send a copy of the vehicle scan report and specify radio SW version and radio head unit ID to Bing Guo and Rafay Adil via email bingruo.guo@fcagroup.com (248) 500-7355 rafay.adil@fcagroup.com (248) 736-7059 Please call for any additional questions or assistance needed. If no response in 15 minutes, proceed with repair. Please be sure to attach a copy of the Vehicle Scan Report on the repair order. |
| 05-006-21 | 2021-12-13. Service bulletin. Rear Caliper Adapter Bolts Are Loose Or Missing This bulletin includes replacing all four rear caliper adapter bolts if loose or missing. Customers may comment on one or more of the following:Click or clunk from the rear of the vehicle. A missing or loose rear brake caliper adapter boltFig. 1.Missing And Loose Caliper Adapter Bolts |
| S2008000121 | 2020-09-28. Service bulletin. Right Front Parking Lamp LED Halo Does Not Illuminate |