WenmarOpen by Wenmar Pro

Service bulletin 08-084-19

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id10166588
Published by NHTSA2019-10-28
Manufacturer's number08-084-19
Manufacturer's date2019-08-21
NHTSA componentBACK OVER PREVENTION; ELECTRICAL SYSTEM

NHTSA's summary

Radio and Back-up Camera Enhancements This bulletin involves updating the radio software level to 1848.24. Customers may experience one or more of the following: Green horizontal lines on back up display, in reverse (If this is the customer concern use camera LOP 18-60-02-Y7, on JL vehicles only). Ghost Touch, features, modes and App?s changing, without drivers input. Speaker pop noise when using Bluetooth device. When vehicle is first started the radio will reset and the time display shows 12:00. Audio distortion and volume fluctuation. Blank rear camera image in reverse (If this is the customer concern use camera LOP 18-60-02-Y7) JL only. Audio cutting in and out during memory recall. Ring tone too loud. AM/FM volume fluctuates. While in CarPlay® or AndroidAuto® Google® maps showing wrong location. Phone disconnected after first call. Black screen or White screen with vertical lines. PIN clear and volume locked while KeySense is used. Audio static while in SXM/SAT modes. Echo heard during Bluetooth phone calls. The radio is locked up. The radio remains on after ignition has been turned off. The radio resets. The radio screen turns black. The radio screen shows messages ?Software Update? or ?Reinsert USB Device? and displays that screen in a continuous loop.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Driver assistance, Electrical system, Backup camera

Vehicles listed
CHRYSLER PACIFICA2018
DODGE CHALLENGER2018
DODGE CHARGER2018
DODGE DURANGO2018
JEEP GRAND CHEROKEE2018
JEEP WRANGLER2018

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Recalls for the same vehicles and component
24V6760002024-09-12. BACK OVER PREVENTION: SENSING SYSTEM: CAMERA; EXTERIOR LIGHTING:BRAKE LIGHTS
20V5120002020-08-27. BACK OVER PREVENTION: SENSING SYSTEM: CAMERA
19V8860002019-12-12. BACK OVER PREVENTION: SENSING SYSTEM: CAMERA; EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.

A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.

Other bulletins for the same vehicles and component
1032892025-03-04. Service bulletin. CAMERA - REAR VIEW
03002242024-03-18. Service bulletin. Front and Rear Axle Sensor Kit **Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that the following Diagnostic Trouble Code (DTC) has been set: ? C1451-11 - Service Axle Locker System** Customers may also comment on a Service Axle Locker message displayed in the Electronic Vehicle Information Center (EVIC) for this condition.
S23190000072024-01-08. Service bulletin. Squeak Noise From Dash Area When Turning The Steering Wheel.
90044522024-01-08. Service bulletin. CAMERA, Rear View Prior to replacement, please contact FCA Redacted Content. If no response in 15 minutes, proceed with repair.
18021232024-01-02. Service bulletin. Flash: Powertrain Control Module (PCM) Updates Customers may experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that one or more of the following Diagnostic Trouble Codes (DTCs) have been set: Major monitor (misfire) and other diagnostics are disabled on a pending DTCs P0335 and P0339. ? **P0335 - Crankshaft Position Sensor Circuit (NA Only). ? P0339 - Crankshaft Position Sensor Intermittent (NA Only).** ? P06E4 - Control Module Wake-Up Circuit Performance. Software enhancement: Technicians and/or customers may report the vehicle will not pass a state smog check due to permanent fault codes which will not clear. As a result, the vehicles are not eligible to be registered in certain states. ? Corrections to allow the vehicle to clear the permanent fault codes. This bulletin involves reprogramming the PCM with the latest available software. NOTE: Four modules are required to be flashed for this update to be effective, the following modules are all to be updated along with this PCM update: ? Electronic Brake Booster Module (EBBM). ? AntiLock Brake System Module (ABS). ? Hybrid Control Processor (HCP) and Auxiliary Hybrid Control Processor (AHCP) or also known as a Power Inverter Module (PIM).
S20250000012024-01-02. Service bulletin. Malfunction Indicator Lamp Illumination (MIL). Diagnostic Trouble Code (DTC) P203E ? Reductant Level Sensor 1 Circuit Intermittent-Erratic Set.
S14080003842024-01-02. Service bulletin. Start Stop Charging Warning Lamp Illuminated On, Intelligent Battery Sensor (IBS) State of Charge (SOC) Inaccurate, Battery Charging Message, Presence of IBS related Diagnostic Trouble Codes (DTCs), or Battery Warning Lamp On
90033572024-01-02. Service bulletin. ADAPTER, Engine Oil Filter (Pentastar V6) For all 2014MY replace the Oil Filter Adapter (OFA). For any other MY (with mileage above 30,000) review and follow instructions from STAR Online S1809000007 REV. C available on Dealer Connect. Also, consider the following: 1) Remove OFA 2) Replace only the oil inlet O-ring and gaskets (seals kit in SOL above). 3) Re-install the OFA. For 2023MY and beyond use black O-ring. For 2022MY and prior use red O-ring. Note: When replacing OFA, it may be necessary to transfer the Oil Temp/Pressure Sensor from the old OFA to the new OFA.
91001342024-01-02. Service bulletin. Engine When replacing a GMET4 long block from a 2021 JL or older, you will need to carry over the injector wiring harness from the original engine, and the Fuel pressure sensor should be replaced with part number: 68212572AB.
90044522023-10-30. Service bulletin. CAMERA, Rear View Prior to replacement, please contact FCA Redacted Content. If no response in 15 minutes, proceed with repair.