Service bulletin 18NA270
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10156897 |
| Published by NHTSA | 2019-04-08 |
| Manufacturer's number | 18NA270 |
| Manufacturer's date | 2019-02-13 |
| NHTSA component | ELECTRICAL SYSTEM:WIRING; ENGINE |
NHTSA's summary
This technical bulletin provides a procedure on locating an engine wiring harness chaffing concern at the rear side of the engine manifold and repair accordingly in circuit 2501.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Electrical system, Engine, Wiring and fuses
| CHEVROLET CAMARO | 2016, 2017, 2018, 2019 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| PIC6421 | 2020-12-14. Service bulletin. This Preliminary information communicates that a dealer may order a replacement hood latch and find that it comes with a three wire connector where the vehicle originally had a two wire connector on the hood latch. The technician is instructed on how to properly wire the new hood latch to the vehicle. |
|---|---|
| 17NA292 | 2019-05-13. Service bulletin. This technical bulletin provides a procedure to inspect the wires and/or replace the Valve Rocker Arm Oil Control Valves if the DTCs listed are set. |
| 100089005G | 2019-05-13. Service bulletin. This warranty admin bulletin explains to the technician additional information may be needed when submitting transactions when doing wiring repairs. |
| 100089005H | 2019-03-18. Service bulletin. This warranty admin bulletin explains to the technician additional information may be needed when submitting transactions when doing wiring repairs. |
| 18258 | 2018-12-10. Service bulletin. 18258 - Service Update. These vehicles were built without anti-abrasion wrap on the engine wire harness designed to prevent potential wear-through of the wire harness insulation over extended periods of time. If insulation wear-through were to occur, damage to the harness wires may result. Damage to individual circuits may result in diagnostic trouble codes (DTC?s) being set. A service engine indicator may be displayed, and the engine may not start, run rough or run in reduced propulsion mode. Dealers will add an anti-abrasion wrap and sleeve to area of contact. |
| 18NA079 | 2018-05-21. Service bulletin. This technical bulletin provides a procedure to replace the drivers front door window regulator motor and door wiring harness if water and/or corrosion is found in the connectors. |
| 10-00-89-005E | 2018-05-21. Service bulletin. This warranty administration bulletin adds the 2016 model year to a communication which provides dealership personnel revised wiring repair labor operations and required additional information. |
| 17NA292 | 2018-04-23. Service bulletin. This technical bulletin provides a procedure to inspect the wires and/or replace the Valve Rocker Arm Oil Control Valves if the DTCs listed are set. |
| GCUS-3-771 | 2017-12-22. Service bulletin. 35740 Service Update. Some vehicles were built without a thermal sleeve on the main body wire harness to forward lamp wire harness connector. Dealers will cover the forward lamp wire harness and connector with a heat resistant thermal wrap. |
| 16-NA-302 | 2017-10-15. Service bulletin. This technical bulletin provides a procedure to install a new wiring harness bypass to correct the customers concern of the airbag lights flickering when the windshield wipers are activated. |