Service bulletin 180214

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
Type	Service bulletin
NHTSA id	10148175
Published by NHTSA	2018-11-13
Manufacturer's number	180214
Manufacturer's date	2014-12-01
NHTSA component	POWER TRAIN

NHTSA's summary

Dual Mass Flywheel - Diagnosis and Inspection. INFORMATION The following three criteria must be checked, evaluated and the resulting findings documented on the repair order prior to replacing a dual-mass flywheel as defective: 1. Total rotational angle at no load condition (with applied torque less then 20 Nm) 2. Secondary plate longitudal axial play 3. Friction surface appearance changes due to thermal overload.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Transmission and driveline

Vehicles listed
BMW 328D	2014, 2015
BMW X3	2015

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Recalls for the same vehicles and component
20V185000	2020-03-26. POWER TRAIN:DRIVELINE:CONSTANT VELOCITY JOINT
2020127	2020-03-25. Powertrain
2014435	2014-10-03. Powertrain

A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.

Other bulletins for the same vehicles and component
B122519	2023-01-30. Service bulletin. After an automatic engine start (MSA start), the transmission intermittently goes into the Park "P" or Neutral "N" position without any customer influence.
B110221	2021-12-13. Service bulletin. With the court's FINAL approval, BMW of North America, LLC (BMW NA) has entered into a nationwide settlement with the plaintiffs in the following class action: Gelis, et al. v. Bayerische Motoren Werke Aktiengesellschaft and BMW of North America, LLC.
B110317	2021-11-08. Service bulletin. BMW of North America, LLC (BMW NA) is extending the limited warranty for the engine timing chain and oil pump drive chain modules to: 7 years/70,000 miles as determined by the vehicle's original in-service date
B120115	2020-09-14. Service bulletin. N20 and N26 Differential Pressure Sensor Fault: 195002 Stored in DME: The Service Engine Soon (MIL) light is on with the following differential pressure sensor fault stored: 195002 - Differential pressure sensor, tank vent valve, electrical: Short circuit to ground During engine operation, vibration and movement of the sensor can damage the pin contacts of the harness connector, or cause a break in the wiring.
B012618	2020-07-27. Service bulletin. EPS STEERING ELECTRIC MOTOR MOUNTING BOLTS LIMITED WARRANTY EXTENSION: There are front end noises when turning the steering wheel and/or there is limited power steering assist when maneuvering or parking the vehicle. For the basic steering gears, one possible cause is that the mounting bolts for the electric motor may become loose, missing and/or broken due to corrosion.
B010520	2020-05-18. Service bulletin. N47T/N57T EGR COOLER - LTD WTY EXTENSION TO 10 YEARS WITHOUT MILEAGE LIMIT: The vehicle demonstrates a power loss and the malfunction indicator lamp (MIL) on.
B340517	2020-04-20. Service bulletin. TICKING NOISE WHILE CORNERING WITHOUT THE BRAKES APPLIED: This Service Information Bulletin (Revision 3) replaces SI B34 05 17 dated September 2017. Ticking noise coming from front wheel while cornering without brakes applied noticeable at low speeds. The vehicle must be moving. See attached video V34 01 20 Note: For a similar noise heard when parking with the brakes applied refer to SIB 31 01 12. Microscopic movement of the contact interface between the inner brake disc and the wheel bearing flange on vehicles equipped with lightweight brake discs.
B120115	2018-12-17. Service bulletin. N20 and N26 Differential Pressure Sensor Fault 195002 Stored in DME. The Service Engine Soon (MIL) light is on with the following differential pressure sensor fault stored: ? 195002 - Differential pressure sensor, tank vent valve, electrical: Short circuit to ground During engine operation, vibration and movement of the sensor can damage the pin contacts of the harness connector, or cause a break in the wiring.
B270315	2018-12-10. Service bulletin. Vibration or Shudder from Driveline when Accelerating from a Stop. Chassis stabilization warning is displayed. Vehicle may exhibit a shudder or vibration when taking off from a stop. One or more of the following fault codes may be stored: LMV ? 440101 - Transfer box (VTG): End of transmission service life reached ? 440105 - Transfer box (VTG ) Calibration Faulty ? 440115 - Transfer box (VTG): Calibration angle deviation outside tolerance? 44011B - Set torque outside of the torque characteristic curve EGS ? 420611 - DSC interface (wheel speed): non-permitted deviation of wheel speed (actual speed of wheel RL/FL/RR/FR, 0x254) from output speed and turbine speed DSC ? 48097D - Transfer box: Fault, clutch position known, only rear-wheel drive These symptoms or faults would be stored on a vehicle with low mileage (< 12,500 miles). CAUSE A front or rear differential with the incorrect gear ratio was installed in the car. The front and rear differentials need to be geared exactly the same for the xDrive to function properly.
B240216	2018-12-10. Service bulletin. F30 PHEVs- Delayed Driving Readiness Status. Immediately after an engine start (start/stop button press), the gear selector is operated, but no drive position (D or R) can be engaged (transmission stays in P). The customer must operate the gear selector again to engage a desired drive position. Unfavorable software application Vehicle requires approximately 1 second after the start/stop button is pressed to establish a Drive Readiness status. If the gear selector is operated during this 1-second window, gear selection is not going to be executed and the gear shifter must be engaged again.