Service bulletin 660413
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10148131 |
| Published by NHTSA | 2018-11-13 |
| Manufacturer's number | 660413 |
| Manufacturer's date | 2014-07-01 |
| NHTSA component | BACK OVER PREVENTION |
NHTSA's summary
Reversing Camera Intermittently Does Not Display a Picture. After engaging reverse gear, the reversing camera intermittently does not display a picture. However, after a key cycle, the reversing camera once again displays the picture. One or more of the following may be noticed on the display at different times: 1. Black screen 2. Blue screen 3. Grey striped screen Note: All the displays may be seen with or without an exclamation mark. CAUSE Software error in the camera control unit (TRSVC - Top Rear Side View Camera)
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Driver assistance, Backup camera
| BMW X5 | 2014, 2015 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| B650414 | 2022-12-12. Service bulletin. According to the customer, the airbag warning light was on, but it may not be illuminated when the vehicle arrives in the workshop. 1. ACSM fault code "930A60 - Seat occupancy detection, front passenger; malfunction" is stored. The fault may or may not currently be present. Or 2. ACSM fault code "930A1C - Front passenger seat occupancy detection transmitting fault(moisture)" is stored. The fault may or may not currently be present. |
|---|---|
| B340517 | 2020-04-20. Service bulletin. TICKING NOISE WHILE CORNERING WITHOUT THE BRAKES APPLIED: This Service Information Bulletin (Revision 3) replaces SI B34 05 17 dated September 2017. Ticking noise coming from front wheel while cornering without brakes applied noticeable at low speeds. The vehicle must be moving. See attached video V34 01 20 Note: For a similar noise heard when parking with the brakes applied refer to SIB 31 01 12. Microscopic movement of the contact interface between the inner brake disc and the wheel bearing flange on vehicles equipped with lightweight brake discs. |
| B660115 | 2018-12-17. Service bulletin. Surround View Camera Last User Mode Operation Change. After programming with ISTA/P 2.53.5 or a more recent version, the rear camera view is displayed when the reverse gear is selected. The vehicle does not remember the last user mode (surround/top camera view). INFORMATION An operational concept change for the surround/top camera view was introduced with ISTA/P 2.53.5 (I-level Fxx-14-07-505). When the reverse gear is selected, the default view will be the rear camera. The surround/top camera view has been removed from the last user mode function. This is to meet the upcoming (new) federal regulations regarding rear view cameras. Note: The surround/top camera view is available, but the driver must manually switch the camera view using the iDrive controller. |
| B310112 | 2018-11-05. Service bulletin. CLICKING NOISE FROM FRONT AXLE This Service Information bulletin supersedes SI 31 01 12 dated June 2015. Clicking noises are heard from the front axle area while maneuvering at low speeds (e.g., parking lot maneuvers). CAUSE Movement between the contact surfaces of the wheel bearing and swivel bearing (knuckle) |