Service bulletin 630514
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10148039 |
| Published by NHTSA | 2018-11-13 |
| Manufacturer's number | 630514 |
| Manufacturer's date | 2014-09-01 |
| NHTSA component | ELECTRICAL SYSTEM; EXTERIOR LIGHTING:HEADLIGHTS; EXTERIOR LIGHTING |
NHTSA's summary
"Adaptive Headlight Malfunction in Cold Weather. * In very cold weather conditions (32ºF or below) with the light switch in the automatic position, the CCM (Check Control Message) ""Adaptive headlight malfunction"" is displayed. * When the CC message is displayed, all the lights continue to function. * When switching the headlights to high beam and the headlight unit is cold, the mechanism inside the headlight is too stiff to move. Software error in TMS 3 (headlight driver module AHL, xenon headlight)"
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Electrical system, Lighting, Headlights
| BMW 428I | 2014, 2015 |
|---|---|
| BMW 435I | 2014, 2015 |
| BMW 528I | 2013, 2014, 2015 |
| BMW 535D | 2014, 2015 |
| BMW 535I | 2013, 2014, 2015 |
| BMW 550I | 2013, 2014, 2015 |
| BMW 740I | 2013, 2014, 2015 |
| BMW 740LD | 2015 |
| BMW 740LI | 2013, 2014, 2015 |
| BMW 750I | 2013, 2014, 2015 |
| BMW 750LI | 2013, 2014, 2015 |
| BMW 760LI | 2014, 2015 |
| BMW ACTIVE HYBRID 7 | 2013 |
| BMW ACTIVE HYBRID 7 | 2014 |
| BMW M3 | 2015 |
| BMW M4 | 2015 |
| BMW M5 | 2013, 2014, 2015 |
| BMW X5 | 2014, 2015 |
| MAZDA CX-5 | 2019 |
| MAZDA MAZDA3 | 2019 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| SA-017-22a | 2022-06-04. Service bulletin. Some customers may complain about any of the following: *Infotainment Center Display does not provide the Authorization Code during the MyMazda App Connected Vehicle enrollment. **Remote function(s) inoperative. **Engine Start / Stop **Door Lock / Unlock **Lights ON / OFF *MAZDA CONNECT connected vehicle reception strength icon shows "X" or " ". Confirm the customer's phone and vehicle have good to strong reception during the concern as shown in the table below. **If the reception is weak, move the vehicle to a location where the reception is good to strong as shown in the table, then try to get the Authorization Code and/or operate the remote functions before proceeding to the Repair Procedure if there is still an issue. **If the reception is good to strong, proceed to the Repair Procedure. |
|---|---|
| 09-003-19-3555a | 2019-03-20. Service bulletin. Some customers may complain of condensation/fog inside the front (headlamp/headlight) or rear (taillamp/taillight) combination lights. The recent new models have been fitted with a clear lens which can cause the symptom to be more noticeable, however, it does not affect the performance of the light. This condensation/fog is a natural phenomenon that occurs when there is a fairly large temperature difference between the inside and the outside of the light housing. It is normal for very small water drops to appear in certain locations on the light units where the air is stagnant (condensation), making the lens look whitish (fog). This happens mostly in the corners and narrow spaces, and will typically clear during warmer ambient temperatures, or when the lights have been on for some time. |
| B630413 | 2018-12-10. Service bulletin. ?This Service Information bulletin supersedes SI B63 04 13 dated February 2013. It designates changes to this revision SUBJECT Moisture in LED Headlight . INFORMATION Covered under the terms of the BMW New Vehicle Limited Warranty for Passenger Cars and Light Trucks. |
| 630213 | 2018-11-26. Service bulletin. Check Control Message "Automatic Headlight Adjustment Failed". One or more of the following Check Control Messages (CCM) will be displayed on the Central Information Display (CID): * Adaptive light system defective * Front left or right lighting system defective * Automatic headlight range adjustment defective Additionally, one or more of the following symptoms may occur: * Both low-beam headlamps point in the downward direction. * The turn signal indicator in the KOMBI flashes rapidly. CAUSE Software error in the Footwell Module (FRM) |
| 621012 | 2018-11-26. Service bulletin. Head-Up Display Is Too Dark. The Head-up Display (HUD) is too dark. Rain/light/solar/condensation sensor (RLSB) hardware error |
| 513114 | 2018-11-13. Service bulletin. Headlight Cleaning System: Functional Operation Change. The customer complains that the headlight cleaning system is not working properly and only works after several actuating attempts. CAUSE The "functional" operation of the headlight cleaning system was changed with integration level F020-14-07-500. The functional changes to the headlight cleaning system's operation will occur only after programming the vehicle with ISTA/P 2.53.0 or higher. INFORMATION The headlight cleaning system is no longer activated with the first stalk activation when the lights are on. The functional programming change now requires the stalk to be activated four times before headlight cleaning is activated. The change prevents automatic activation of headlight cleaning when the customer only wants to clean his/her windshield. This is normal operation and no parts should be changed. |
| 630814 | 2018-11-13. Service bulletin. Active Headlight Control Malfunction in Both Headlights. AHL (Active Headlight Control) malfunctions on both sides. Both lights aim either up or down while driving. Fault Code 8041B6 is present. Broken mounting bolt holding on the rear height sensor bracket. |
| 630614 | 2018-11-13. Service bulletin. One or Both Headlights Are Aimed Downwards. The customer may experience one or more of the following complaints: * One or both headlights are aimed significantly too low (jammed lower limit). * No reference run is visible on the affected headlight when the ignition is turned on and the light switch is in the auto position. * No CCM (Check Control Message) is displayed when a headlight is faulty. CAUSE * TMS-3 (Headlight driver module AHL) coding error * Defective mechanism inside the headlight |
| 630814 | 2018-11-13. Service bulletin. Active Headlight Control Malfunction in Both Headlights. AHL (Active Headlight Control) malfunctions on both sides. Both lights aim either up or down while driving. CAUSE Broken mounting bolt holding on the rear height sensor bracket |
| 630115 | 2018-11-13. Service bulletin. "SUBJECT Check Control Message: Adaptive LED Headlight Malfunction. The following CC message is displayed: ""LED Headlight malfunction"" The fault codes listed below are stored in the LHM2 (LED main light module) and are not currently present: z LHM2_L: 8059A9 - Fan 1 defect z LHM2_L: 8059AA - Fan 2 defect z LHM2_R: 805B29 - Fan 1 defect z LHM2_R: 805B2A - Fan 2 defect Coding error in the LHM2 module" |