Service bulletin 18-064-14
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10139844 |
| Published by NHTSA | 2018-06-11 |
| Manufacturer's number | 18-064-14 |
| Manufacturer's date | 2014-11-18 |
| NHTSA component | POWER TRAIN |
NHTSA's summary
Flash: 2.0L Powertrain Diagnostic And System Enhancements This bulletin involves reprogramming the Powertrain Control Module (PCM) with the latest available software. A small number of customers may experience a slight idle instability while idling in gear with the brake released. New software has been developed to address this concern. Also included in this update is an enhancement to the Variable Valve Timing (VVT) system.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Transmission and driveline
| DODGE CALIBER | 2011 |
|---|---|
| JEEP COMPASS | 2011 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 1806414 | 2023-02-21. Service bulletin. 2.0L Powertrain Diagnostic And System Enhancements |
|---|---|
| U67 Combo Rev10 | 2023-02-13. Service bulletin. Emissions recal U67 Catalytic Converter Efficiency |
| U67 | 2023-01-17. Service bulletin. Some of the above-involved vehicles may exceed NOx (Oxides of Nitrogen) emission level standards due to loss of catalytic converter efficiency |
| V51 | 2022-12-19. Service bulletin. Customer Satisfaction Notification V51 Reprogram Powertrain Control Module |
| 9004266 | 2022-10-17. Service bulletin. TRANSMISSION, 5 Speed On replacing OE transmission 05106567A$/68042567A$ with reman transmission R8142074A$ replace with new Hydraulic Clutch Tube 05273429A$ to avoid interference with shift lever |
| 9004265 | 2022-10-17. Service bulletin. TRANSMISSION, 5 Speed Replacing OE transmission 05106789A$/68042789A$ with reman transmission R8142073A$ replace with new Hydraulic Clutch Tube 05273429A$ to avoid interference with shift lever |
| 9004009 | 2022-09-26. Service bulletin. Transmission Kit with Torque Converter 1. All Promaster (VF) 3.6L/62TE equipped vehicles. If the transmission bracket to the transmission case fasteners are removed during servicing, the fasteners (Part Number 06511385A$) are one-time usage. Vehicles built prior to 10/23/2015 requires Service Kit PN 68461214AA; includes Transmission Isolator PN 68264483AA, and Adaptation Bracket 68264479AA and Fastener Service Kit PN 68329056AA Vehicles built after on or after 10/23/2015 will require only the Fastener Service Kit PN 68329056AA. 2. All 3.6L/62TE equipped vehicles. If the vehicle you are repairing has a crack in the flex plate or failed pump bushing inspect and confirm that both (2) dowel pins are present in the engine block, which align the transmission center line to the crank shaft centerline and visually inspect the dowel alignment holes in the transmission case. If the holes are damaged or elongated the transmission should be replaced to prevent further damage to the transmission/flexplate or pump bushing due to the inability to properly align the engine to the transmission during the repair. 3. All 62TE equipped vehicles. If pump bushing is scored or damaged and the dowel pin alignment holes are ok, replace the pump assembly as opposed to complete transmission. 4. All 62TE equipped vehicles. If vehicle is jerking/slipping with MIL code(s) P0740 or P2764, check TCC Solenoid operation. If TCC Solenoid is ok, the codes are indicative of a torque converter failure. Replace the torque converter. |
| 1805819 | 2022-09-15. Service bulletin. No Start After Powertrain Control Module (PCM) Replacement and/or Reprogramming |
| 18-011-13 | 2022-07-25. Service bulletin. Flash: MIL Illumination P050B and/or Rattle/Clatter Sound on Cold Start-up This bulletin involves installing revised heater hoses, routing the purge solenoid wire harness, and installing revised Powertrain Control Module (PCM) software. Customers may indicate that they hear a clatter or rattle noise coming from the engine on initial start up after a long cold soak. A small number of customers may also experience a Malfunction Indicator Lamp (MIL) illumination. Upon further investigation the technician may find that the following Diagnostic Trouble Code (DTC) has been set. P050B - Cold Start Ignition Timing Performance |
| 9004509 | 2022-05-31. Service bulletin. Oil Filter If a Mopar Oil Filter is not available, use a filter that meets or exceeds USCAR36 specification and is compatible with semi and full synthetic oils. Recommended Brands: Wix, Purolator, and NapaGold |