Service bulletin PIT5232D
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10123216 |
| Published by NHTSA | 2017-11-14 |
| Manufacturer's number | PIT5232D |
| Manufacturer's date | 2017-10-02 |
| NHTSA component | ELECTRICAL SYSTEM:12V/24V/48V BATTERY |
NHTSA's summary
This Preliminary Information communication provides information to the technician the steps to diagnose and repair the concern of the display is showing 32° F (0° C) after a battery or reprogramming a module. The outside temperature will begin to update if driven above 20 mph for at least 5 minutes. If the vehicle speed drops below 20 mph, the timer will reset and the display will stop updating. Once the display starts to update it may take several more minutes of driving above 20 mph for the display to fully update. Also if the vehicle is shut off for more than 8 hours the display will update when the ignition is turned on.
The document
The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.
Components
Electrical system, 12-volt battery
| BUICK ENVISION | 2016, 2017, 2018 |
|---|---|
| CADILLAC ESCALADE | 2015, 2016, 2017, 2018 |
| CHEVROLET SILVERADO | 2017 |
| CHEVROLET SILVERADO 1500 | 2014 (the catalog's model; the bulletin names a series or trim of it) |
| CHEVROLET SILVERADO 2500 | 2015, 2016 (the catalog's model; the bulletin names a series or trim of it) |
| CHEVROLET SILVERADO 2500 | 2018 (the catalog's model; the bulletin names a series or trim of it) |
| CHEVROLET SUBURBAN | 2015, 2016, 2017, 2018 |
| CHEVROLET TAHOE | 2015, 2016, 2017, 2018 |
| GMC SIERRA | 2017 |
| GMC SIERRA 1500 | 2014, 2015, 2016 (the catalog's model; the bulletin names a series or trim of it) |
| GMC SIERRA 3500 | 2018 (the catalog's model; the bulletin names a series or trim of it) |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 20-NA-132 | 2024-04-05. Service bulletin. This warranty administration bulletin provides policy information on the requirements for 12V battery testing and warranty replacements. |
|---|---|
| PIT5074H | 2023-12-11. Service bulletin. J-35616-64B Terminal Test Probe / Replacement Terminal / Terminated Lead. |
| PIT5074G | 2023-12-11. Service bulletin. Terminal Test Probe And Replacement Terminal. |
| 1408117001a | 2023-12-11. Service bulletin. Unable to Clear BCM DTCs After Completing Repair |
| 20NA132 | 2021-12-20. Service bulletin. This warranty administration bulletin provides policy information on the requirements for battery testing and warranty replacements. |
| 21NA158 | 2021-08-09. Service bulletin. This service bulletin provides information on High Voltage Battery Module Replacement. |
| 150603002H | 2021-04-16. Service bulletin. Original Equipment Batteries Part Number and ACDelco Replacement Battery Approved Warranty Part Numbers Correct battery cold cranking amperage (CCA) ratings and type are critical for proper test results when using the EL-50313. Access to the battery specification label, which contains the OEM part number and CCA rating and type, may be difficult without component removal. Refer to the table below for the original equipment ratings and part numbers used to set up a proper battery test. There has been some confusion as to the correct ACDelco battery warranty replacement. Refer to the table below for the correct battery warranty replacement. The correct ACDelco battery warranty replacement in the catalog is designated by the "Original Equipment Replacement" note in the description field. |
| 17-NA-327 | 2021-04-15. Service bulletin. Information for Dead Battery Condition Some customers may comment on the following conditions: • Dead battery • Dead battery after car sits a couple days Cause This condition may be caused by the OnStar® module staying awake, drawing power from the battery. Correction Note: If the vehicle is towed to the dealer with a dead battery, it is highly unlikely that a battery draw will be verified once the battery is charged. Verify that the vehicle VIN is flagged in the Global Warranty Management / Investigate History (GWM/IVH). If the VIN is flagged, do a Blue Button Press from the vehicle and request a "Re-configuration" and operational evaluation. |
| 18NA161 | 2019-11-25. Service bulletin. This technical bulletin provides a procedure for testing the battery cables for voltage drop, Checking for a bad ground at g218, Inspecting for a short at the starter B+ to shield and testing for a faulty battery. |
| 030603004Y | 2019-05-20. Service bulletin. This warranty administration bulletin provides policy information on the requirements for battery testing and warranty replacements. |