WenmarOpen by Wenmar Pro

Service bulletin ITB17-049

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id10118686
Published by NHTSA2017-10-12
Manufacturer's numberITB17-049
Manufacturer's date2017-09-25
NHTSA componentSEATS

NHTSA's summary

2017-2018 QX60 AND QX60 HYBRID; 2ND ROW SEAT HANDLE "CARGO MODE" CHANGE SERVICE INFORMATION A change has been made to the 2nd row seat handles in the Applied Vehicles. Vehicles produced between August 25, 2017 and September 8, 2017 (see VIN information below) are equipped with 2nd row seat handles that have "CARGO MODE" displayed on them (Figure 1). Applied Vehicles built before and after the time period shown above are equipped with blank seat handles (Figure 2). Vehicles built BETWEEN: Wheat interior: 5N1DL0M(**)HC 560656 to 5N1DL0M(**)JC 500895 Graphite or Java interior: 5N1DL0M(**)HC 560638 to 5N1DL0M(**)JC 500932 ARE equipped with 2nd row seat handles with "CARGO MODE" displayed on them. The Infiniti New Vehicle Limited Warranty does not cover replacement of a "CARGO MODE" handle (correctly built vehicle) with a blank handle. Refer to the Infiniti Assurance Products Resource Manual (APRM) for guidelines on warranty coverage. The vehicle owner's manual contains the complete details regarding the limited warranty.

The document

The document is the manufacturer's. This site does not hold it. NHTSA files a document at one of these two addresses; we have not asked NHTSA which.

Components

Seats

Vehicles listed
INFINITI QX602017, 2018
INFINITI QX60 HYBRID2017 (the catalog's model; the bulletin names a series or trim of it)

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Other bulletins for the same vehicles and component
ITB20-0042020-03-06. Service bulletin. 2013 JX AND 2014-2019 QX60; CLIMATE CONTROLLED SEAT INOPERATIVE IF YOU CONFIRM The driver or passenger side climate controlled seat: • - Heating and cooling features do not operate And • - The harness connector or control unit of the climate controlled seat appears as shown in Figure 3 or Figure 5. ACTION Perform the following to the affected seat: A. Replace the climate controlled seat control unit. B. Drill a hole for the new harness clip. C. Replace the harness connector of the climate controlled seat control unit.
ITB19-0242019-10-08. Service bulletin. DTC B00A0-00 STORED IF YOU CONFIRM DTC B00A0-00 (OCCUPANT DETECTION SENSOR UNIT) is stored And OCS zero point reset cannot be performed And The following screen will display: ACTION 1. Check the Occupant Classification System (OCS) control unit using the ODS Analysis tool software. • Refer to SERVICE PROCEDURE on the next page. HINT: “OCS” may also be referred to as “ODS”. 2. Perform “75-zero RESET”.