WenmarOpen by Wenmar Pro

Service bulletin SSM 46207

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id10095994
Published by NHTSA2017-03-20
Manufacturer's numberSSM 46207
Manufacturer's date2016-11-15
NHTSA componentSTRUCTURE:BODY:DOOR

NHTSA's summary

SOME 2013-2017 FOCUS 4-DOOR SEDANS HAVE A SINGLE DAMPENER ON THE LEFT HAND SIDE, ADJACENT TO THE LIFTING COIL SPRING, TO SLOW THE OPERATION OF THE LUGGAGE COMPARTMENT DECK LID WHEN OPENING AND CLOSING. THE LUGGAGE COMPARTMENT DECK LID IS HELD OPEN ONLY BY THE COIL SPRINGS CONNECTED TO THE HINGES. THE DAMPENER IS NOT CHARGED WITH GAS TO SUPPORT THE LUGGAGE COMPARTMENT LID LIKE THE 5 DOOR HATCHBACK LIFT CYLINDERS. REFER TO THE UPDATED WORKSHOP MANUAL SECTION 501-03 FOR ADDITIONAL INFORMATION. IT IS NORMAL FOR THE DAMPENER TO COMPRESS EASILY WHEN REMOVED FROM THE VEHICLE, UNLIKE THE HATCHBACK LIFT SUPPORT CYLINDERS.

The document

No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.

Components

Body and frame

Vehicles listed
FORD FOCUS2013, 2014, 2015, 2016, 2017

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Recalls for the same vehicles and component
20170392017-01-25. Structure
17V0520002017-01-24. STRUCTURE:BODY
16V6980002016-09-28. LATCHES/LOCKS/LINKAGES:HATCHBACK/LIFTGATE:LOCK; STRUCTURE:BODY:HATCHBACK/LIFTGATE
20164752016-09-27. Structure
20164322016-09-06. Structure
20130752013-03-06. Structure

A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.

Other bulletins for the same vehicles and component
SSM 546012026-02-27. Service bulletin. Ford and Lincoln vehicles equipped with wired keyless entry keypad systems and accessory wireless keyless entry keypad systems may or may not come with a wallet card containing the master code. Unlike the integrated wired keypad, the accessory wireless keypad master code cannot be retrieved from the vehicle using a diagnostic scan tool or from the label printed on the body control module (BCM). The Factory Keyless Entry Code application within the diagnostic scan tool will not provide an applicable master code for the accessory wireless keypad. If the wallet card for an accessory keypad is not available, the "Wireless RF Keypad Diagnosis Guide" can be referenced and provides direction on how to retrieve the master code. This guide is located under the Workshop Manual tab > Accessories > Installation > Wireless RF Keypad Diagnosis Guide > PPT C > Step C2.<br /><br /> Note: The only available keypad for some vehicles from the assembly plant is the accessory wireless keyless entry keypad. The integrated wired keypad cannot be installed on vehicles not equipped from the factory with a wired keyless entry k
SSM 515362023-05-04. Service bulletin. For 2000-2024 Ford and Lincoln vehicles, swapping a module from a vehicle for diagnosis purposes is likely to cause errors and is not recommended. It is also not recommended to order a replacement module using a vehicle identification number (VIN) from a different vehicle. Most modules on these affected vehicles are VIN/vehicle specific and hardware variations between modules do exist. Swapping a module from a vehicle or ordering a module using a different vehicle/VIN can cause ineffective repairs and additional vehicle down time. Make sure all appropriate Workshop Manual (WSM) procedures are followed when diagnosing the condition prior to all module replacements and only order modules using the correct VIN.
Service2021-12-20. Service bulletin. Online automotive service information system for March 2016
TSB1600012021-12-20. Service bulletin. 49 CFR Part 579.5 Monthly Communications - March 2016 Air bag warning light illuminated with diagnostic trouble code (DTC) B141B and/or B141C
LTR37562021-12-20. Service bulletin. 49 CFR Part 579.5 Monthly Communications - January 2016
TSB 20-21712020-06-05. Service bulletin. Some 2013-2018 C-Max, 2013-2020 Escape/Fusion/MKZ, 2015-2018 Focus,2015-2019 MKC, 2015-2020 Edge/F150/Mustang, 2016-2018 MKX, 2016-2019 Explorer, 2017-2020 F-Super Duty, 2018-2020 EcoSport/Expedition, 2019-2020 Ranger/Nautilus vehicles may experience seat pan looseness, lateral movement, or a clunk/thump noise on turns. This may be due to the seat pan track. To correct the condition, follow the Service Procedure steps to install a reinforcement.
19N092020-01-09. Service bulletin. Customer Satisfaction Program 19N09 Certain 2011-2014 Model Year Edge and MKX and 2013-2014 Model Year Explorer, Flex, and MKT Vehicles Left Front Door Latch Extended Coverage
17-22182018-01-29. Service bulletin. Some 2013-2018 Escape, Focus and C-Max vehicles may exhibit a water stained headliner after the vehicle has experienced a water leak from areas such as the roof opening panel, fixed glass, roof rails and roof ditch mouldings. Follow the procedure below to remove the water stains from the headliner after the water leak has been repaired. Follow the Service Procedure steps to correct the condition.
SSM 461972017-03-20. Service bulletin. SOME 2013-2017 FOCUS/C-MAX VEHICLES EXHIBIT A FRAYED/CUT SHORT APPEARANCE AT THE FRONT EDGE OF THE HEADLINER NEAR THE WINDSHIELD. THIS IS A NORMAL CHARACTERISTIC OF THE HEADLINER AND NO REPAIRS SHOULD BE ATTEMPTED. ON 5 DOOR FOCUS(HATCHBACK) THE EXPOSED EDGE AT THE REAR LIFT GATE AREA MAY BE DUE THE HEM LIP OUT OF POSITION (BENT) PULLING THE WEATHER STRIP OUT OF POSITION, EXPOSING THE EDGE. THE HEM LIP CAN EASILY BE REPOSITIONED AND WILL KEEP THE HEADLINER EDGE COVERED BY THE WEATHER-STRIP, WITHOUT HEADLINER REPLACEMENT.
SSM 459112017-02-10. Service bulletin. 2016 FOCUS RS SPOILER IS WRAPPED FOR EXPORT TO NORTH AMERICA WITH WRAP GUARD. WHEN THE WRAP IS REMOVED IT CAN LEAVE A RESIDUE ON THE SPOILER. THE RESIDUE IS WATER SOLUBLE, USE WARM WATER ONLY TO ASSIST WITH THE REMOVAL.