Service bulletin SSM 46198
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10095992 |
| Published by NHTSA | 2017-03-20 |
| Manufacturer's number | SSM 46198 |
| Manufacturer's date | 2016-11-11 |
| NHTSA component | STRUCTURE:BODY |
NHTSA's summary
SOME 2017 F-SUPER DUTY VEHICLES EQUIPPED WITH A 6.7L ENGINE AND BUILT ON OR BEFORE 03-NOV-2016 MAY EXHIBIT A LEAK FROM THE TRANSMISSION FLUID COOLER TUBES. THIS MAY BE DUE TO POOR ALIGNMENT OF THE COOLER TUBES WITH THE COOLER TUBE PORTS ON THE TRANSMISSION AND/OR IMPROPER HOLD DOWN PLATE ALIGNMENT. WHEN INSTALLING THESE TUBES, VISUALLY VERIFY THAT EACH TUBE IS FULLY INSERTED INTO THE TRANSMISSION AND ARE NOT OFFSET TO ONE SIDE OF THE COOLER PORT BORE BEFORE INSTALLING THE HOLD DOWN PLATE. WHEN INSTALLING THE HOLD DOWN PLATE, USE A NEW BOLT PART NUMBER W715131-S437 WITH WASHER W718565-S437U INSTALLED OVER THE BOLT BETWEEN THE PLATE AND THE TRANSMISSION. TORQUE TO 25 NM (18 LB-FT). THIS WILL PROVIDE PROPER PLATE TO COOLER TUBE ALIGNMENT AND CLAMPING.
The document
No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.
Components
Body and frame
| FORD F-250 SD | 2017 (the catalog's model; the bulletin names a series or trim of it) |
|---|---|
| FORD F-350 SD | 2017 (the catalog's model; the bulletin names a series or trim of it) |
| FORD F-450 SD | 2017 (the catalog's model; the bulletin names a series or trim of it) |
| FORD F-550 SD | 2017 (the catalog's model; the bulletin names a series or trim of it) |
| FORD F-650 SD | 2017 (the catalog's model; the bulletin names a series or trim of it) |
| FORD F-750 SD | 2017 (the catalog's model; the bulletin names a series or trim of it) |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 22V087000 | 2022-02-16. STRUCTURE:FRAME AND MEMBERS:UNDERBODY SHIELDS; POWER TRAIN:DRIVELINE:DRIVESHAFT |
|---|---|
| 19V880000 | 2019-12-11. SEAT BELTS:PRETENSIONER; STRUCTURE:BODY:ROOF AND PILLARS |
| 2017502 | 2017-10-18. Structure |
| 17V331000 | 2017-05-22. LATCHES/LOCKS/LINKAGES:DOORS:LATCH; STRUCTURE:BODY:DOOR |
| 2016640 | 2016-12-19. Structure |
A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.
| 25N10S1 | 2026-07-01. Other. Certain 2017-2025 F-450 – F-600 Chassis Cab Upfitted with an Aerial Bucket Frame Rail Crack |
|---|---|
| SSM 54601 | 2026-02-27. Service bulletin. Ford and Lincoln vehicles equipped with wired keyless entry keypad systems and accessory wireless keyless entry keypad systems may or may not come with a wallet card containing the master code. Unlike the integrated wired keypad, the accessory wireless keypad master code cannot be retrieved from the vehicle using a diagnostic scan tool or from the label printed on the body control module (BCM). The Factory Keyless Entry Code application within the diagnostic scan tool will not provide an applicable master code for the accessory wireless keypad. If the wallet card for an accessory keypad is not available, the "Wireless RF Keypad Diagnosis Guide" can be referenced and provides direction on how to retrieve the master code. This guide is located under the Workshop Manual tab > Accessories > Installation > Wireless RF Keypad Diagnosis Guide > PPT C > Step C2.<br /><br /> Note: The only available keypad for some vehicles from the assembly plant is the accessory wireless keyless entry keypad. The integrated wired keypad cannot be installed on vehicles not equipped from the factory with a wired keyless entry k |
| SSM 51536 | 2023-05-04. Service bulletin. For 2000-2024 Ford and Lincoln vehicles, swapping a module from a vehicle for diagnosis purposes is likely to cause errors and is not recommended. It is also not recommended to order a replacement module using a vehicle identification number (VIN) from a different vehicle. Most modules on these affected vehicles are VIN/vehicle specific and hardware variations between modules do exist. Swapping a module from a vehicle or ordering a module using a different vehicle/VIN can cause ineffective repairs and additional vehicle down time. Make sure all appropriate Workshop Manual (WSM) procedures are followed when diagnosing the condition prior to all module replacements and only order modules using the correct VIN. |
| SSM 51263 | 2023-01-06. Service bulletin. Some 2015-2023 F-150, 2017-2022 F-Super Duty, and 2019-2023 Ranger vehicles may exhibit dust ingress into the cabin through the doors or air extractors. This may be due to the climate control system being in recirculation mode as a result of the recirculation button being on or automatic strategies for heating/cooling efficiency. To minimize dust ingress when driving in off-road or secondary road conditions, make sure that all doors and windows are fully closed and the climate control system is switched to defrost on and the instrument panel and footwell air vents are switched to off. Temperature and fan settings may be adjusted as desired. Alternatively, max defrost can be activated which will adjust all settings automatically. Operating in defrost mode will keep constant air flow through the rear air extractors and other small areas, helping minimize dust ingress. |
| SSM 51185 | 2022-11-30. Service bulletin. Some 2015-2022 F-150 and 2017-2022 F-Super Duty vehicles may experience issues with the tailgate center step moulding. If there is an issue with the center molding (warped, damaged condition, loose, or if the molding is missing), the trim cover is now available separately. It is no longer necessary to replace the entire rear step assembly (402A48). |
| 21B04 S4 | 2022-10-05. Service bulletin. Certain 2017 through 2020 Model Year F550 Equipped with Payload Plus Upgrade Package Frame Rail Crack Program Terms: Program will be extended for an additional year; Urgency/Expiration Date: Program will be extended for an additional year Owner Refunds: Refunds have been extended to December 31, 2022, for owner paid repairs completed prior to owner notification date |
| TSB 22-2247 | 2022-08-23. Service bulletin. Some 2017-2022 F-Super Duty vehicles may experience a loose/sagging underbody insulator that could be seen or heard by the customer. This may be due to insufficient retention. To correct the condition, follow the Service Procedure to re-secure the insulator and adding additional clamping points. |
| 21M05-S1 | 2022-07-28. Service bulletin. Certain 2017-2022 Model Year Super Duty Vehicles Equipped with a Power Release Tailgate - Unintended Tailgate Opening. In the affected vehicles, some customers report experiencing an unintended tailgate opening and may have previously serviced their vehicle for this concern. Ford had developed an enhanced remedy for customers who may want this enhanced repair performed n their vehicle. |
| 21B04-S3 | 2022-05-04. Service bulletin. Certain 2017 through 2020 Model Year F550 Equipped with Payload Plus Upgrade Package-Frame Rail Cracks: In some of the affected vehicles certain second unit body (SUB) upfits could cause stress points on the frame rail. Over time this stress could cause a crack in the fame rail behind the cab. |
| 21B04-S2 | 2022-04-04. Service bulletin. Certain 2017 through 2020 Model Year F550 Equipped with Payload Plus Upgrade Package - Frame Rail Crack: In some of the affected vehicles certain second unit body (SUB) upfits could cause stress points on the frame rail. Over time this stress could cause a crack in the frame rail behind the cab. |