Service bulletin SB-P-4213
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10058825 |
| Published by NHTSA | 2015-12-01 |
| Manufacturer's number | SB-P-4213 |
| Manufacturer's date | 2014-04-25 |
| NHTSA component | ENGINE |
NHTSA's summary
NISSAN: CHECK ENGINE LIGHT WILL BE ILLUMINATED DUE TO DETERIORATION OF THE TIMING CHANGE OVER TIME AND WILL BECOME DISTORTED. MODEL 2011-13 JUKE. *PE
The document
No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.
Components
Engine
| NISSAN JUKE | 2011, 2012, 2013 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 2011431 | 2011-12-12. Engine |
|---|---|
| 11V583000 | 2011-12-08. ENGINE AND ENGINE COOLING:ENGINE:GASOLINE:TURBO/SUPERCHARGER |
A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.
| NTB17-082E | 2022-03-12. Service bulletin. DTC P0456 CAUSED BY EVAP LEAK AT VENT CONTROL VALVE O-RING This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. |
|---|---|
| NTB13-097J | 2022-03-12. Service bulletin. EVAP LEAK DTC P0442, P0455, P0456 INFORMATION This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. |
| NTB13-027C | 2022-03-12. Service bulletin. CAN COMMUNICATION – NETWORK DIAGNOSTIC FLOW CHART This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin. |
| NTB16-035 | 2021-05-24. Service bulletin. Juke; Turbocharger service |
| NTB16035 | 2021-05-10. Service bulletin. SERVICE INFORMATION Whenever a turbocharger on an Applied Vehicle is replaced for any reason, always replace with the part listed below: Oil Supply/Inlet Tube (TUBE-TURBOCHARGER OIL FEED)* * This is the steel tube that feeds oil from the engine front to the turbocharger housing. Always replace this part on either of the Turbocharger configurations available on the Juke. |
| NTB14030D | 2021-05-10. Service bulletin. INTRODUCTION Nissan is conducting this Voluntary Service Campaign to replace the engine timing chain on certain specific 2011- 2013 Juke vehicles. This service will be performed at no charge for parts or labor. IDENTIFICATION NUMBER Nissan has assigned identification number P4213 to this campaign. This number must appear on all communications and documentation of any nature dealing with this campaign. See this bulletin for further detail. |
| NTB15055 | 2021-05-10. Service bulletin. SERVICE INFORMATION After ECM reprogramming, the Calibration Verification Number (CVN) needs to be automatically calculated prior to State emissions testing (also known as Inspection Maintainence, I/M, or SMOG testing depending upon location). Allowing the vehicle to idle for 22 minutes will allow for faster CVN calculation. It is recommended that customers utilize this method if the vehicle needs to be tested for emissions soon after ECM reprogramming. See this bulletin for further detail. |
| NTB14109 | 2021-05-10. Service bulletin. SERVICE INFORMATION Starting with 2010 Model Year, Nissan vehicles have been gradually incorporating a new type of DTC known as Permanent DTC or P-DTC. If a vehicle is equipped with P-DTCs, all emission related DTCs will also set a P-DTC if the MIL is turned ON. A listing of which DTCs that will also set a P-DTC is found in the DTC Index in the EC-Engine Control section of the Electronic Service Manual (ESM). If a DTC repair is performed and the DTC erased, a vehicle may fail an Emission Inspection and Maintenance test if the P-DTC is not also erased. See this bulletin for further detail. |
| P4213D | 2021-05-10. Service bulletin. We were temporarily using an alternate part (13094-31U00) as a substitute to fill VOR & CSC part backorders. |
| P4213C | 2021-05-10. Service bulletin. Due to the damage of the Slack Guide Bolt (13094-EN200) during the removal procedure and the unforeseen part demand for the campaign, the slack guide bolt has been on backorder the last two weeks. Nissan will use part 13094-31U00 (Slack Guide Bolt-Alternative) as a temporary alternative to fill all VOR and CSC part backorders, which will arrive by Friday, 5/23 via FedEx. |