WenmarOpen by Wenmar Pro

Service bulletin TSB-15-01-015-1

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
TypeService bulletin
NHTSA id10058398
Published by NHTSA2015-09-15
Manufacturer's numberTSB-15-01-015-1
Manufacturer's date2015-06-01
NHTSA componentEQUIPMENT

NHTSA's summary

HYUNDAI: PROCEDURE IS PROVIDED FOR PASSENGER'S SEAT CONNECTOR FOR INSTALLATION OF DUMMY HOUSING TO SEAL CONNECTION HOUSING DUE TO WATER INTRUDING IN INTERIOR CABIN. MODEL 2015 GENESIS. *PE

The document

No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.

Components

Equipment and accessories

Vehicles listed
HYUNDAI GENESIS2015

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Other bulletins for the same vehicles and component
22-GI-006G2022-08-05. Service bulletin. Effective June 2, 2008, Federal Motor Vehicle Safety Standard 110 (FMVSS 110) sets a threshold for correcting load capacity information indicated on tire placards when the vehicle weight has been increased before retail sale. This limit is the lesser of 1.5% of the Gross Vehicle Weight Rating or 100 pounds. If the total added weight exceeds the lesser of the limit, a label (See Figure 1) must be added to the driver-side B-pillar within 25mm (1 inch) of the original tire placard. NOTE: Effective immediately, all ports will stop the installation of the Load Capacity Label when there are no port accessories installed.
21-EM-004H2021-04-07. Service bulletin. This bulletin provides the service procedure for engine connecting rod bearing clearance testing. Perform the procedure outlined in this bulletin to fulfill the Bearing Clearance Test inspection requirements to determine next required steps.
21-BR-002H2021-04-07. Service bulletin. This bulletin provides best practice recommendations when performing brake service procedures.
21-EM-003H2021-04-06. Service bulletin. This bulletin provides the inspection procedure and repair guidelines for certain vehicles listed below.
21-01-016H2021-04-06. Service bulletin. This bulletin describes the procedure to inspect and if necessary replace the brake tube assemblies for certain 2015MY Hyundai Genesis (DH) vehicles located in the non-salt belt states. Nonsalt belt states are listed below in Applicable Vehicles.
21-01-015H2021-04-06. Service bulletin. This bulletin describes the procedure to replace the brake tube assemblies for certain 2015MY Hyundai Genesis (DH) vehicles located in the salt belt states. Salt belt states are listed below in Applicable Vehicles.
20-DS-002H2020-10-08. Service bulletin. The bulletin describes the procedure to measure and set propeller shaft angles to optimize driveline vibration performance on certain 2015-2016MY 3.8L AWD G80 (DH) vehicles.
20-BE-009H-12020-10-08. Service bulletin. This bulletin provides the warranty extension, service procedure to replace the left side of the multifunction switch assembly, and perform a software update. Certain vehicles may exhibit intermittent headlight flickering while driving with the light switch on AUTO light mode.
20-BD-014H2020-08-07. Service bulletin. This bulletin provides information regarding condensation related to moisture accumulation in the headlamp, rear combination lamp, daytime running lamp (DRL), or fog lamp. The TSB illustrates the various causes of condensation inside the lamp assembly. Lamp assembly replacement is NOT necessary in most cases. This condition can be eliminated by turning on the lamps with the engine running for several minutes, or during normal driving operation.
20-BE-009H2020-07-08. Service bulletin. This bulletin provides the warranty extension and service procedure to replace the multifunction switch assembly. Certain vehicles may exhibit intermittent headlight flickering while driving with the light switch on AUTO light mode. Hyundai is extending the multifunction switch assembly warranty to 15 years with unlimited miles from the date of original retail delivery or date of first use (whichever occurs first). Refer to the warranty and service parts information outlined in this bulletin whenever the multifunction switch assembly replacement is required.