Service bulletin TSB-14-0151
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10056699 |
| Published by NHTSA | 2015-02-03 |
| Manufacturer's number | TSB-14-0151 |
| Manufacturer's date | 2014-08-18 |
| NHTSA component | ENGINE |
NHTSA's summary
FORD: AN INTERMITTENT NOISE IS HEARD MOSTLY AT SPECIFIC SPEEDS, RPM RANGES, AND VEHICLE LOADS, WHEN ENGINE IS RUNNING AND NOISE IS LOUD, LOW FREQUENCY, AND DRONING POWERTRAIN TYPE, WHILE DRIVING UP A GRADE OR HILL. MODEL 2013-14 C-MAX. *PE
The document
No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.
Components
Engine
| FORD C-MAX ENERGI | 2013, 2014 (the catalog's model; the bulletin names a series or trim of it) |
|---|---|
| FORD redundant C-MAX HYBRID | 2013 |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| TSB 22-2162 | 2022-05-12. Service bulletin. Some 2014-2017 C-MAX Energi, 2014-2020 Fusion plug-in hybrid electric vehicle (PHEV), 2015-2017 MKZ/MKZ Hybrid/MKC, 2016-2017 MKX, 2016-2018 Focus battery electric vehicle (BEV) and 2017 Continental vehicles equipped with SYNC screens 8 inch or larger may be unable to complete modem authorization after 3G to 4G modem upgrade was performed. No Authorization Popup displayed on SYNC infotainment screen during the Authorization process. This may be due to the Sync Software. To correct the condition, follow the Service Procedure to toggle Valet Mode. |
|---|---|
| SSM 48598 | 2020-03-03. Service bulletin. 2013-2018 C-Max, 2013-2020 Fusion Hybrid/MKZ Hybrid vehicles may exhibit a MIL with Diagnostic Trouble Code (DTC) P0340 and/or P0344. This may occur due to excessive moisture build up in the engine oil. Excess moisture occurs when the vehicle is driven short distances and/or less than 6,000 combined miles per year. To correct the condition, replace the camshaft position sensor (CMP) and change the engine oil. Advise the customer to perform more frequent oil changes and allow the internal combustion engine to reach operating temperature when running to prevent reoccurrence. Refer to the owners guide - maintenance - engine oil check - operating in cold climates and short driving cycles. |
| TSB 19-2207 | 2019-07-03. Service bulletin. Some 2013-2017 C-Max/Fusion/MKZ Hybrid/Energi vehicles may exhibit an illuminated malfunction indicator lamp (MIL) with diagnostic trouble codes (DTCs) P1450, P0456, P0457, P04EE and/or P04EF. This may be due to the sealing capability of the canister purge valve. To correct the condition, follow the Service Procedure steps to update the PCM software and replace the canister purge valve. |
| SSM 47790 | 2019-04-08. Service bulletin. Some 2013-2019 Fusion/MKZ and 2013-2018 C-Max vehicles with 2.0L HEV/PHEV engine may exhibit multiple drivability or electrical concerns with one or more diagnostic trouble codes, being the most common P26C3, P26CA, P26D0, P2800, P2802, U019F and U0284. On Fusion/MKZ inspect connectors C146, C1651, C1812, C168C, C1717 and C134 for signs of water entry or corrosion. On C-Max, inspect connectors C134, C140, C144, C1651, C1717 and C1812 and service as necessary. NOTE: Connector C1717 is only equipped on PHEVs for both Fusion and C-Max. |
| SSM 46085 | 2017-08-01. Service bulletin. The Powertrain Control/Emissions Diagnosis (PC/ED) manual has been revised for diagnosing electronic throttle bodies (ETBs). The ETC_ACT and ETC_DSD PIDs should not used to diagnose possible ETB concerns. The IDS has a limited refresh rate when reading these PIDs and cannot display quickly enough to validate a concern. The PCM automatically monitors these inputs more accurately and will set diagnostic trouble codes (DTCs) when appropriate. Using these PIDs for diagnostics will lead to inaccurate results and improper ETB replacements. If a concern is intermittent and no DTCs are present, refer to historical DTCs and the PC/ED, Section 3 No DTCs Present Index chart for further information. |
| SSM 46295 | 2017-03-15. Service bulletin. TO HELP DIFFERENTIATE ENGINE OIL LEAKS FROM OTHER POSSIBLE SOURCES, A NEW WHITE-COLORED FLUORESCENT ENGINE OIL DYE IS AVAILABLE. WORKSHOP MANUAL (WSM), SECTION 303-00 HAS BEEN REVISED TO REFERENCE THE NEW WHITE-COLORED DYE. THE NEW WHITE FLUORESCENT DYE PROVIDES A DISTINCT WHITE GLOW TO IDENTIFY ENGINE OIL LEAKS. THE NEW WHITE FLUORESCENT DYE REQUIRES A PURE UV DIAGNOSTIC INSPECTION LAMP. THE WHITE-COLORED FLUORESCENT DYE AND PURE UV LAMP ARE NOW IN THE ROTUNDA CATALOG. DYE AND LAMP PART NUMBERS. GASOLINE ONLY DYE: 1 OUNCE BOTTLE 164-TP-33200601. DIESEL ONLY DYE: 8 OUNCE BOTTLE: 164-TP-3320-0008. PURE UV DIAGNOSTIC INSPECTION LAMP 164-TP8695 OR 164-R3748. |
| ASI-45161 | 2016-06-22. Service bulletin. SUMMARY TO BE PROVIDED ON A FUTURE DATE. |
| ASI-44389 | 2014-06-16. Service bulletin. FORD: DIAGNOSTIC TROUBLE CODE (DTC) 01594 IS SET IN BODY CONTROL MODULE (BCM) AND NO OTHER CODES, AFTER REMOTE STARTING AND WITH A START STALL SYMPTOM, WITHIN 20 SECONDS. MODEL 2012-2014 FOCUS, 2013-2014 ESCAPE, C-MAX. *PE |
| ASI-44451 | 2014-05-07. Service bulletin. FORD: SOME MODEL VEHICLES MANUAL FOR POWERTRAIN CONTROL/EMISSION DIAGNOSTIC (PC/ED) HAS BEEN UPDATED REGARDING IMPROVED COOLING FAN CIRCUIT DUE TO A LACK OF AIR CONDITIONING, A MALFUNCTIONING INDICATOR LAMP (MIL) AND OVERHEATING. *PE |
| ASI-44363 | 2014-03-24. Service bulletin. FORD: WITHIN 20 SECONDS AFTER REMOTE STARTING VEHICLE, THERE IS A START STALL ISSUE AND DIAGNOSTIC TROUBLE CODE (DTC) P1594 IS SET IN BODY CONTROL MODULE (BCM). MODEL 2012-2014 FOCUS, 2013-2014 ESCAPE, C-MAX. *PE |