Service bulletin TSB-14-0101

A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.

The communication, as NHTSA indexes it (as of 2026-10-19)
Type	Service bulletin
NHTSA id	10056210
Published by NHTSA	2014-10-06
Manufacturer's number	TSB-14-0101
Manufacturer's date	2014-05-08
NHTSA component	ENGINE

NHTSA's summary

FORD: ENGINE NOISES (WHIRRING, BUZZ OR SAW) IS HEARD AFTER A COLD START BETWEEN 950-1200 RPM FROM TIMING BELT COVER. *PE

The document

No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.

Components

Engine

Vehicles listed
FORD FIESTA	2012, 2013, 2014

Listing a model year does not mean every vehicle of it is concerned: the document says which.

Recalls for the same vehicles and component
2017184	2017-03-29. Engine
17V209000	2017-03-27. ENGINE AND ENGINE COOLING:ENGINE

A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.

Other bulletins for the same vehicles and component
26L02	2026-09-01. Other. Customer Satisfaction Program 26L02 Certain 2014-2021 Model Year Various Vehicles 1.0L Fox Classic Engine Timing Belt and Oil Pump Belt Interval Change
22N11	2023-02-03. Service bulletin. Certain 2011-2013 Model Year Fiesta Vehicles Operated in the USA Corrosion States Battery Junction Box Clean and Seal In some of the affected vehicles, the position of the Battery Junction Box (BJB) in the engine compartment is subject to unanticipated direct road water splash while driving. When vehicles are operated in high contamination/corrosion environments associated with road salt use, moisture and debris can enter through the BJB cover and base, potentially leading to corrosion of the relay and fuse terminals, especially at the front of the box. Corrosion in the battery junction box may result in a variety of symptoms, including a loss of certain vehicle functions, such as the loss of low beam headlamps, loss of high beam headlamps, or vehicle no start.
SSM 49210	2020-10-06. Service bulletin. Some 2009-2020 Ford and Lincoln vehicles equipped with turbochargers may exhibit an oil leak from the turbocharger oil supply or return tubes, O-rings or 6.7L pedestal gasket. Although oil may collect on the turbocharger, it is very rare for a turbocharger to leak oil. To isolate the source of the leak, refer to Workshop Manual (WSM), Section 303-00 General Information > Diagnosis and Testing > Engine > Engine Oil Leaks - Fluorescent Oil Additive Method procedure. When an oil leak is present at a turbocharger oil supply or drain tube, remove the affected oil tube and inspect for damage, and replace the O-ring seals, pedestal gasket or oil tube as required. Refer to WSM, Section 303-04. For claiming, use the affected oil tube or pedestal gasket as the causal part and applicable labor operations in Sections 6 and 9 of the Service Labor Time Standards (SLTS) Manual.
SSM 47587	2018-11-19. Service bulletin. 2014-2017 Fiesta, 2015-2018 Focus, 2018-2019 Ecosport vehicles equipped with a 1.0L EcoBoost engine may exhibit coolant consumption,white smoke and/or a runs rough condition. Refer to the extended coolant pressure test in Workshop Manual (WSM), Section 303-03. If no external coolant loss is confirmed, further investigation of the integrated exhaust manifold (IEM) interface is required. Carefully inspect the manifold port area for cracks. If a crack is found, follow the cost cap tool for component replacement. Follow WSM, Section 303-01 for the repair procedures
SSM 47563	2018-11-19. Service bulletin. Some 2011-2014 Fiesta and 2012-2014 Focus vehicles equipped with a DPS6 transmission may experience a fluid leak between the engine and transmission. Be aware that the engine oil and DPS6 transmission fluid are similar in color and texture. A transmission fluid leak at the input shaft seal can cause a buildup of fluid in the bell housing; creating the appearance of a rear main seal leak. The rear main seal should only be replaced after a rear main seal failure is confirmed through appropriate diagnostics outlined in the updated online Workshop Manual (WSM) Section 303-00 / Diagnosis and Testing with the use of Fluorescent dye (164-TP33200601).
tsb18-2185	2018-09-10. Service bulletin. This article supersedes TSB 18-2024 to update the model years. Some 2011-2018 Fiesta vehicles may exhibit a lack of heat resulting from a frozen blower motor. This may be caused by snow entering through the cowl panel grille and screen assemblies. Snow may melt in the heating, ventilation and air conditioning (HVAC) case allowing water to enter the blower motor and freeze during a below freezing overnight soak. Blower motor fuse F4 in the battery junction box (BJB) may also be open and the cabin air filter may be saturated. Follow the Service Procedure steps to correct the condition.
TSB18-2024	2018-06-11. Service bulletin. Some 2011-2017 Fiesta vehicles may exhibit a lack of heat resulting from a frozen blower motor. This may be caused by snow entering through the cowl panel grille and prior screen assemblies. Snow may melt in the heating, ventilation and air conditioning (HVAC) case allowing water to enter the blower motor and freeze during a below freezing overnight soak. The blower motor fuse at location F4 in the power distribution box may also be open and the cabin air filter may be water saturated. Follow the Service Procedure steps to correct the condition.
SSM 46085	2017-08-01. Service bulletin. The Powertrain Control/Emissions Diagnosis (PC/ED) manual has been revised for diagnosing electronic throttle bodies (ETBs). The ETC_ACT and ETC_DSD PIDs should not used to diagnose possible ETB concerns. The IDS has a limited refresh rate when reading these PIDs and cannot display quickly enough to validate a concern. The PCM automatically monitors these inputs more accurately and will set diagnostic trouble codes (DTCs) when appropriate. Using these PIDs for diagnostics will lead to inaccurate results and improper ETB replacements. If a concern is intermittent and no DTCs are present, refer to historical DTCs and the PC/ED, Section 3 No DTCs Present Index chart for further information.
SSM 46327	2017-03-15. Service bulletin. 2013-2016 FIESTA, ESCAPE, TRANSIT CONNECT AND 2013 FUSION VEHICLES WITH A 1.6L GASOLINE TURBOCHARGED DIRECT INJECTION (GTDI) ENGINE MAY EXHIBIT AN ENGINE OIL LEVEL READING THAT IS UP TO 8 MM ABOVE THE MAXIMUM MARK ON THE ENGINE OIL DIPSTICK WHEN THE ENGINE IS FILLED WITH THE CORRECT AMOUNT OF OIL. THIS IS A NORMAL CHARACTERISTIC OF THIS ENGINE. DO NOT LOWER THE OIL LEVEL TO THE MAXIMUM MARK ON THE ENGINE OIL DIPSTICK IF THE ENGINE CONTAINS THE CORRECT AMOUNT OF OIL. ADDING OIL IS NOT REQUIRED IF THE LEVEL IS ABOVE THE MINIMUM MARK ON THE ENGINE OIL DIPSTICK. REFER TO THE OWNERS MANUAL FOR PROPER ENGINE OIL CAPACITY.
SSM 46295	2017-03-15. Service bulletin. TO HELP DIFFERENTIATE ENGINE OIL LEAKS FROM OTHER POSSIBLE SOURCES, A NEW WHITE-COLORED FLUORESCENT ENGINE OIL DYE IS AVAILABLE. WORKSHOP MANUAL (WSM), SECTION 303-00 HAS BEEN REVISED TO REFERENCE THE NEW WHITE-COLORED DYE. THE NEW WHITE FLUORESCENT DYE PROVIDES A DISTINCT WHITE GLOW TO IDENTIFY ENGINE OIL LEAKS. THE NEW WHITE FLUORESCENT DYE REQUIRES A PURE UV DIAGNOSTIC INSPECTION LAMP. THE WHITE-COLORED FLUORESCENT DYE AND PURE UV LAMP ARE NOW IN THE ROTUNDA CATALOG. DYE AND LAMP PART NUMBERS. GASOLINE ONLY DYE: 1 OUNCE BOTTLE 164-TP-33200601. DIESEL ONLY DYE: 8 OUNCE BOTTLE: 164-TP-3320-0008. PURE UV DIAGNOSTIC INSPECTION LAMP 164-TP8695 OR 164-R3748.