Service bulletin ITB-14-025
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10055928 |
| Published by NHTSA | 2014-08-06 |
| Manufacturer's number | ITB-14-025 |
| Manufacturer's date | 2014-06-02 |
| NHTSA component | SEAT BELTS:FRONT |
NHTSA's summary
INFINITI: DRIVING AFTER OVERNIGHT COLD SOAKED, OR BRIEFLY IN REVERSE THEN DRIVE, OR AFTER SHIFTED INTO DRIVE, SLOW ACCELERATION, PRE CRASH FRONT SEAT BELT CINCHES BUCKLED FRONT SEAT BELTS AND RELEASES WHEN MOVING FORWARD IN DRIVE. MODEL 2014 QX60 (HYBRID). *PE
The document
No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.
Components
Seat belts
| INFINITI QX60 | 2014 |
|---|---|
| INFINITI QX60 HYBRID | 2014 (the catalog's model; the bulletin names a series or trim of it) |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 2016179 | 2016-04-25. Seats And Restraints |
|---|
A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.
| ITB14059A | 2021-05-10. Service bulletin. IF YOU CONFIRM All "hands free" functions of the Intelligent Key (I-Key) do not work. For example, the doors will not lock or unlock when pressing either front door request switch. NOTE: - The issue of all I-Key "hands free" functions not working may occur intermittently or all the time. - The message "No Key Detected" or similar may show on the Vehicle Information Display (located in the combination meter). - All I-Key remote button functions (door lock/unlock, etc.) WILL work normally when all I-Key "hands free" functions are NOT working. ACTION 1. Inspect the I-Key?s battery on its negative contact side. 2. If excessive scratching is found, replace the battery. 3. Verify all I-Key functions (both "hands free" and remote) work properly after battery replacement. NOTE: Do NOT replace the BCM, I-Key, or other parts for the issue described under IF YOU CONFIRM, if it should occur. See this bulletin for further detail. |
|---|---|
| ITB14025 | 2021-05-10. Service bulletin. IF YOU CONFIRM: The front Pre-Crash Seat Belt System suddenly cinches down the front seat belts (only belts that are buckled) for a few seconds and then releases them while moving forward in drive under the following conditions: * After the vehicle has been cold soaked overnight. And * After the vehicle has been placed in reverse and briefly backed and then placed in drive. And * During the first initial slow acceleration after being shifted into drive. And * No DTCs are set. And * The Brake Pedal Stroke Sensor signal is not between 1.0V and 1.3V. ACTION Adjust the Brake Pedal Stroke Sensor with service procedure starting on page 2. Please see this bulletin for further details. |