Service bulletin SB-2014-0001
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10055106 |
| Published by NHTSA | 2014-04-10 |
| Manufacturer's number | SB-2014-0001 |
| Manufacturer's date | 2014-01-23 |
| NHTSA component | ELECTRICAL SYSTEM:SOFTWARE; ELECTRICAL SYSTEM:WIRING:FUSES AND CIRCUIT BREAKERS |
NHTSA's summary
BRP: ON SOME MOTORCYCLES, NEED TO HAVE THE FRONT FUSE BOX COVERS REPLACED WITH AN IMPROVED COVER IN PRODUCTION AND ALSO, UPDATE ECM SOFTWARE (P1614, HI TEMP LAMPS, LIMP HOME MODE). *PE
The document
No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.
Components
Electrical system, Software, Wiring and fuses
Trouble codes named
P1614
| CAN-AM SPYDER RS | 2012 (the catalog's model; the bulletin names a series or trim of it) |
|---|---|
| CAN-AM SPYDER ST | 2013 (the catalog's model; the bulletin names a series or trim of it) |
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| B2012-10 | 2021-01-25. Service bulletin. To be performed at PDI on registered (sold) vehicles. |
|---|---|
| B2012-8 | 2021-01-25. Service bulletin. To be performed at PDI on unregistered (unsold) vehicles. |
| Article Radio di | 2018-03-05. Service bulletin. Technical Service Tip (TST) informing dealers that It has been brought to BRP's attention that in some cases the radio station display option in the cluster will revert to "no display" after a few days. BRP is looking into the situation. This issue has been identified as a software problem between the cluster and the radio module. At this time replacement of parts is not the solution since they all have the problem. |
| Bulletin 2012-12 | 2017-12-22. Service bulletin. Warranty bulletin addressing the problem that analog fuel gauge needle does not have any dampening causing a variable fuel level reading. Replacing the analog fuel gauge with a new improved one (with stepper motor) is required. After fuel gauge installation, update the cluster software. |
| Article 10-23 | 2017-12-14. Service bulletin. Technical Service Tip (TST) in reference to quality warranty bulletin 2012-12. If the analog fuel gauge with stepper motor is installed with an old version of the cluster software or on a 2010 RT with a cluster which cannot be updated, the following situations may be observed: ? Fuel level is displayed in the cluster digital display. ? Wrong fuel level. ? Even if the fuel tank is full, the digital display may show 3 bars and the analog fuel gauge shows half. ? The "low fuel" indicator turns on when the fuel tank reaches half. ? The temperature gauge needle indicates maximum (overheat) even if the engine is cold. |
| 40182 | 2017-10-21. Service bulletin. Technical Service Tip (TST): A very limited quantity of vehicles may have been produced with incorrectly routed electrical wires and brake lines. Dealerships has received the specific instructions concerning the inspection, repair and warranty procedures for this situation. Letter to dealers sent on December 3, 2012 is attached. |
| BULLETIN 2013-9 | 2016-11-23. Service bulletin. REVISON 1 OF WARRANTY BULLETIN 2013-9 ADRESSING 3 PROBLEMS: A) SEAL THE FRONT FUSE BOXES BECAUSE WATER MAY INFILTRATE EITHER OF THE FRONT FUSE BOXES; B) UPDATE ECM SOFTWARE BECAUSE CODE P1614 MAY BE TRIGGERED AND CAUSE A LIMP HOME MODE WHEN STARTING THE ENGINE; C) REPLACE UPPER BELT GUARD RETAINING SCREWS THAT MAY NOT SECURE THE BELT GUARD PROPERLY. |
| 000064634 | 2015-05-26. Service bulletin. BOMBARDIER ROADSTER: COMPLAINTS REGARDING WINDSHIELD DROPPING ON BUMPY ROAD. *LJ |
| 000034361 | 2015-05-22. Service bulletin. BRP ROADSTER : COMPLAINTS REGARDING INTERMITTENT DPS ASSISTANCE OR NO ASSISTANCE AT ALL. *LJ |
| WC-2013-9 | 2014-05-05. Service bulletin. CAN-AM MOTORCYCLE: WARRANTY CAMPAIGN INFORMATION REGARDING SEAL OF FRONT FUSE BOXES (WATER INFILTRATING EITHER OF FRONT FUSE BOXES), UPDATING ECM SOFTWARE (A LIMP HOME MODE MAY BE TRIGGERED WHEN ENGINE HAS STARTED, REPLACE UPPER BELT GUARD RETAINING SCREWS (THE BELT GUARD NOT SECURED PROPERLY BY RETAINING SCREWS. MODEL 2013 SPYDER. *PE |