Service bulletin 0401
A bulletin is a manufacturer's communication to its dealers, as NHTSA indexes it. The summary is NHTSA's. The document is the manufacturer's: read it at NHTSA. A bulletin is not a recall, and listing a model year does not mean every vehicle of it is concerned.
| Type | Service bulletin |
|---|---|
| NHTSA id | 10008094 |
| Published by NHTSA | 2004-07-21 |
| Manufacturer's number | 0401 |
| Manufacturer's date | 2005-12-20 |
| Replaces | 0505 |
| NHTSA component | ELECTRICAL SYSTEM |
NHTSA's summary
REAR HATCH GLASS, OPEN WARNING DISPLAYED IN MULTI-FUNCTION DISPLAY. *MJ
The document
No address for NHTSA's copy can be built for this communication. Ask the dealer for it by the manufacturer's number.
Components
Electrical system
| VOLKSWAGEN TOUAREG | 2004 |
|---|
Listing a model year does not mean every vehicle of it is concerned: the document says which.
| 2003177 | 2003-07-29. Electrical |
|---|---|
| 03V266000 | 2003-07-25. ELECTRICAL SYSTEM:WIRING |
A recall listed here may apply to some of the same vehicles. Only the manufacturer can say whether it applies to one vehicle.
| Edition86 | 2023-10-02. Service bulletin. VW Elsa Newsletter |
|---|---|
| Edition115 | 2023-10-02. Service bulletin. VW Elsa Newsletter |
| Edition26 | 2023-09-18. Service bulletin. VW Elsa Newsletter |
| Edition86 | 2023-09-18. Service bulletin. VW Elsa Newsletter |
| TB011407 | 2023-08-28. Service bulletin. Software Version Management |
| Guide | 2023-08-14. Service bulletin. P0102, P1128, P1296 - WA front oxygen sensor faults |
| TT661101 | 2023-07-31. Service bulletin. After installing the -J345- trailer recognition control module (vehicles with PR code 1D8 only), wiring harness and plug, the following steps need to be performed in order to enable the system. |
| TT641402 | 2023-07-31. Service bulletin. To detect which line(s) is inoperative, utilize a volt meter to check for 0 V, which will be present after the open in the grid line. The check must be performed with the engine running and heated rear window switched on. Switch OFF the ignition and visually locate the damage. Proceed with checking any other lines as necessary. Once the damaged line is identified, repair utilizing the Repair kit by Permatex® ITEM 09117. |
| TT571302 | 2023-07-17. Service bulletin. If key blade is found to stick or bind when opening or closing, check position of roll pin that secures key blade to mechanism. If roll pin is sticking out on either side (as shown below), do not replace key. Instead, use appropriate sized punch and hammer to drive in the roll pin so that it is flush with edge of mechanism. |
| TT571202 | 2023-07-17. Service bulletin. If the vehicle is entered using the door key, the alarm may activate when opening the door. The door lock cylinder does not disarm the alarm. The lock cylinder in the door is meant to be used as an emergency entry, therefore the key must be inserted into the ignition within 15-30 seconds of opening the door (dependent on vehicle and equipment), in order to disarm the alarm. |