{"vehicle":{"id":"2005_nissan_armada","year":2005,"make":"Nissan","model":"Armada"},"may_apply":true,"as_of":{"us":"2026-10-19","ca":"2026-10-19"},"recalls":[{"source":"tc","country":"ca","campaign":"2023053","date":"2023-02-10","manufacturer":null,"component":"Airbag","summary":"Issue:\nOn certain vehicles, the plastic emblem on the steering wheel airbag cover could detach and become a projectile when the airbag inflates in a crash.\nNote: This recall is for certain vehicles that had the steering wheel airbag replaced.\n\nSafety Risk:\nProjectiles in the occupant compartment could increase the risk of an injury.\n\nCorrective Actions:\nNissan will notify owners by mail and advise you to take your vehicle to a dealership to inspect and, if necessary, replace the steering wheel airbag cover.","mfr_campaign":"PC947 / PC948 / PC949","units":10846,"do_not_drive":null,"park_outside":null,"notification":"Safety Mfr","match":"exact","models":["ARMADA"],"built_from":null,"built_to":null,"url":"https://open.wenmarpro.com/recalls/tc/2023053"},{"source":"tc","country":"ca","campaign":"2012156","date":"2012-04-11","manufacturer":null,"component":"Label","summary":"Certain vehicles fail to comply with the requirements of Canada Motor Vehicle Safety Standard 210.1 - User-ready Tether Anchorages for Restraint Systems.  Specifically, the pictograms identifying the location of the tether anchors measure 15 mm in height instead of 20 mm as required by the Standard.  Correction: Since this non-compliance condition does not pose any safety risk, no corrective action is required.","mfr_campaign":null,"units":4885,"do_not_drive":null,"park_outside":null,"notification":"Compliance Mfr","match":"exact","models":["ARMADA"],"built_from":null,"built_to":null,"url":"https://open.wenmarpro.com/recalls/tc/2012156"},{"source":"tc","country":"ca","campaign":"2010373","date":"2010-10-28","manufacturer":null,"component":"Engine","summary":"On certain vehicles  the Intelligent Power Distribution Module (IPDM) assembly contains an Engine Control Module (ECM) relay that has a diode for electrical current noise reduction.  The ECM relay may allow silicon vapor to form and over time the silicon evaporates from the diode molding which causes silicon oxide to develop on the ECM relay contact due to arcing.  In certain instances, this oxidation could cause engine performance issues (hesitation, rough engine idle, slow start/no-start condition), and engine stalling at low engine speeds which may result in a crash.  Correction: Dealers will replace the Engine Control Module (ECM) relay.","mfr_campaign":"R168, R169","units":24207,"do_not_drive":null,"park_outside":null,"notification":"Safety Mfr","match":"exact","models":["ARMADA"],"built_from":null,"built_to":null,"url":"https://open.wenmarpro.com/recalls/tc/2010373"},{"source":"nhtsa","country":"us","campaign":"10V517000","date":"2010-10-28","manufacturer":"NISSAN NORTH AMERICA, INC.","component":"ENGINE AND ENGINE COOLING","summary":"NISSAN IS RECALLING CERTAIN MODEL YEAR 2004-2006 ARMADA, TITAN, INFINITI QX56 AND MODEL YEAR 2005-2006 FRONTIER, PATHFINDER AND XTERRA VEHICLES.  THE INTELLIGENT POWER DISTRIBUTION MODULE (IPDM) ASSEMBLY CONTAINS AN ENGINE CONTROL MODULE (ECM) RELAY THAT HAS A DIODE FOR ELECTRICAL CURRENT NOISE REDUCTION. THE ECM RELAY MAY ALLOW SILICON VAPOR TO FORM AND, OVER TIME, THE SILICON EVAPORATES FROM THE DIODE MOLDING WHICH CAUSES SILICON OXIDE TO DEVELOP ON THE ECM RELAY CONTACT DUE TO ARCING.","mfr_campaign":null,"units":747480,"do_not_drive":false,"park_outside":false,"notification":null,"match":"exact","models":["ARMADA"],"built_from":"2004-02-05","built_to":"2006-05-15","url":"https://open.wenmarpro.com/recalls/nhtsa/10V517000"},{"source":"nhtsa","country":"us","campaign":"10V074000","date":"2010-03-03","manufacturer":"NISSAN NORTH AMERICA, INC.","component":"FUEL SYSTEM, OTHER:STORAGE:FUEL GAUGE SYSTEM","summary":"NISSAN IS RECALLING CERTAIN MODEL YEAR 2005-2009 TITAN, ARMADA, AND INFINITI QX56 VEHICLES.  THE  INSTRUMENT PANEL FUEL GAUGE MAY INACCURATELY DISPLAY THAT THE VEHICLE STILL HAS SOME FUEL, TYPICALLY ABOUT ONE QUARTER TANK, WHEN THE FUEL TANK IS EMPTY.","mfr_campaign":null,"units":340000,"do_not_drive":false,"park_outside":false,"notification":null,"match":"exact","models":["ARMADA"],"built_from":null,"built_to":null,"url":"https://open.wenmarpro.com/recalls/nhtsa/10V074000"},{"source":"tc","country":"ca","campaign":"2010060","date":"2010-03-02","manufacturer":null,"component":"Fuel System","summary":"On certain vehicles, the material used on fuel level sending unit contacts can wear and contaminate the sender.  This causes the instrument panel fuel gauge to display that the vehicle still has some fuel left in the tank when the fuel tank is empty.  An inaccurate fuel gauge can lead to engine stalling while driving, which may increase the risk of a crash causing property damage, personal injury or death.  Correction: Letters will be sent to owners in two stages.  The first letter will advise owners of fuel gauge inaccuracy and recommend maintaining a fuel level above the one half position.  The second letter will follow, requesting owners bring their vehicles to a dealer for replacement of the fuel sender unit.","mfr_campaign":"R151, R152","units":8681,"do_not_drive":null,"park_outside":null,"notification":"Safety Mfr","match":"exact","models":["ARMADA"],"built_from":null,"built_to":null,"url":"https://open.wenmarpro.com/recalls/tc/2010060"},{"source":"nhtsa","country":"us","campaign":"08V284000","date":"2008-06-27","manufacturer":"NISSAN NORTH AMERICA, INC.","component":"EQUIPMENT:APPLIANCE:AIR CONDITIONER","summary":"NISSAN IS RECALLING 180,664 MY 2005-2006 TITAN, ARMADA AND INFINITY QX56 VEHICLES MANUFACTURED AFTER MARCH 17, 2005, THAT ARE EQUIPPED WITH A VISTEON AIR CONDITIONING CONDENSER FAN MOTOR. THE FAN MOTOR MAY NOT BE PROPERLY SEALED ALLOWING EXCESSIVE WATER INTRUSION AND INADEQUATE DRAINAGE OF MOISTURE.","mfr_campaign":null,"units":180664,"do_not_drive":false,"park_outside":false,"notification":null,"match":"exact","models":["ARMADA"],"built_from":"2005-03-17","built_to":"2006-08-21","url":"https://open.wenmarpro.com/recalls/nhtsa/08V284000"},{"source":"tc","country":"ca","campaign":"2008221","date":"2008-06-24","manufacturer":null,"component":"Electrical","summary":"Certain 2005-2006 model year vehicles may have been assembled with an incorrectly manufactured air conditioning condenser fan motor, which could allow excessive water intrusion and inadequate drainage.  If sufficient moisture accumulates in the motor, corrosion could occur, increasing internal friction, and thereby augmenting the electrical current draw.  This could cause an increase in the motors operating temperature that could eventually melt its wiring insulation and other plastic components and form a gas.  If two wires without insulation touch each other and create a spark, this gas could ignite and result in a vehicle fire, which could cause property damage, personal injury or death.  Note: 2004, and some 2005 model year vehicles are equipped with a different fan motor that is not subject to this campaign.  However, it is possible that a limited number of these vehicles may have received the subject condenser fan as a service replacement part, thereby being included in this action.  Correction: Dealers will affect repairs.","mfr_campaign":"R133 R134 R136 R137","units":8080,"do_not_drive":null,"park_outside":null,"notification":"Safety Mfr","match":"exact","models":["ARMADA"],"built_from":null,"built_to":null,"url":"https://open.wenmarpro.com/recalls/tc/2008221"}],"lookup":{"nhtsa":"https://www.nhtsa.gov/recalls","tc":"https://wwwapps.tc.gc.ca/Saf-Sec-Sur/7/VRDB-BDRV/search-recherche/menu.aspx?lang=eng","maker":null},"attribution":["Contains information licensed under the Open Government Licence – Canada."]}