Transport Canada recall 2026287
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2026287 |
| Manufacturer's number | 26C27 |
| Reported | 2026-06-10 |
| Component | Lights And Instruments |
| Notification type | Compliance Mfr |
| Units potentially affected | 111 |
What is wrong
Issue:
On certain vehicles, the recall repairs completed by a Ford dealer during recall 19C03 (Transport Canada recall no. 2019-064) may not have been done correctly. As a result, a second repair is required.
On certain vehicles, a software problem could cause the instrument panel cluster screen not to display when the vehicle is started. As a result, you may not be able to see certain information about the vehicle, including the gear selection, speedometer, warning lights and malfunction tell-tales.
Safety Risk:
Warnings, gauges, gear selection and tell-tales indicators that don't display could increase the risk of a crash.
Corrective Actions:
Ford will notify owners by mail and advise you to take your vehicle to a dealership to update the instrument panel cluster software.
| 2019 FORD MUSTANG | |
|---|---|
| 2019 LINCOLN MKX | |
| 2019 LINCOLN NAVIGATOR |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| SSM 50347 | 2021-12-26. Service bulletin. Some 20182021 Expedition/Navigator vehicles may exhibit inoperative reverse lamps with DTC B1277 stored in the body control module (BCM). The vehicle may also exhibit the auto dimming rear view mirror becoming dark as soon as the key is turned on or is inoperative. This may be due to incorrect wiring of an aftermarket 5 pin jumper connector from a non-Ford windshield supplier that is causing a short to ground. To correct this condition, inspect if the windshield was recently replaced and verify the circuits in the 5 pin jumper connector located between connector C9440 and C9224 are routed in the correct pin location and adjust as necessary. Refer to the Wiring Diagram, Cell 124-10. |
|---|
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.