Transport Canada recall 2025108
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2025108 |
| Manufacturer's number | 25S16 |
| Reported | 2025-03-02 |
| Component | Powertrain |
| Notification type | Safety Mfr |
| Units potentially affected | 11 |
What is wrong
Issue:
On certain vehicles, the recall repairs completed by a Ford dealer during recall 24S33 (Transport Canada recall no. 2024-270) may not have been done correctly. As a result, a second repair is required.
On certain hybrid vehicles, a software update completed by a Ford dealer could cause the transmission to shift into neutral (N) unexpectedly. If this happens, there could be a sudden loss of power to the wheels.
Safety Risk:
A loss of power to the wheels could increase the risk of a crash.
Corrective Actions:
Ford will notify owners by mail and advise you to take your vehicle to a dealership to update the hybrid powertrain control module software.
| 2022 FORD MAVERICK | |
|---|---|
| 2023 FORD MAVERICK | |
| 2024 FORD MAVERICK | |
| 2021 LINCOLN CORSAIR |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| SSM 55221 | 2026-10-12. Service bulletin. For 20222026 vehicles equipped with a 8F35 transmission, a revision to the Road Testing Vehicle procedure has been made in the WSM, Section 307-01 > Diagnosis and Testing. This updated procedure improves the diagnosis of customer reported transmission concerns and aids in locating the proper root cause. During diagnosis and testing, details regarding whether the condition is more prevalent when the vehicle is hot or cold, throttle percentage at the time of occurrence, vehicle speed, the specific shift involved, and whether the issue occurs during transmission engagements (N>R, N>D, R>D, and/or D>R) should be noted in the warranty claim. Engineering requests including these detailed operating conditions that will significantly assist with root cause analysis. Diagnosis, testing, and repair should use established labor times outside this article. |
|---|---|
| TSB 26-2414 | 2026-09-14. Service bulletin. This article supersedes 26-2058 Reason for update: update the TSB title and TSB issue to include new DTCs Some of the vehicles listed in the Model statement above may exhibit all of the following conditions: * Intermittent or permanent no reverse (R) engagement * Illuminated MIL with DTC P0767 or P0765:7E stored in the powertrain control module (PCM) In addition to the required conditions, the vehicle may also exhibit a harsh reverse engagement, P0766, P0765:7F, P0736 and/or P2703 stored in the PCM. This may be due to an internal mechanical concern with the selectable one-way clutch (SOWC). |
| TSB 26-2328 | 2026-07-20. Service bulletin. This bulletin supersedes 26-2194. Reason for update: update the Parts list to correct a part description " Loctite 638", update the claim quantity for the drain/fill plug, update the claim quantity of the wheel hub bolts (Corsair) and limited the parts list for Edge/Nautilus to only the rear drive unit fluid. Some of the vehicles listed in the Model statement above may exhibit all of the following conditions: Shudder chatter condition, most noticeable at low speeds turning No relevant diagnostic trouble codes (DTCs) present This may be due to internal rear drive unit (RDU) fluid contamination. |
| SSM 54980 | 2026-07-08. Service bulletin. Some 2022-2024 Maverick Hybrid vehicles may exhibit an intermittent vibration and/or crunching noise after a cold start while the engine is running with the vehicle stationary in drive with no throttle input and brakes applied. An intermittent engine rocking or rolling motion in one direction may also be observed while the concern is present with the hood open. The noise may be present with no drivability concerns, relevant diagnostic trouble codes (DTC) stored, warning indicators illuminated and/or warning messages displayed. The noise may reduce or be eliminated after several minutes of driving when the powertrain warms up. This condition does not affect vehicle durability and no additional diagnosis or service is required for this condition at this time. Inform customers that they can continue to drive the vehicle and engineering is currently working on a solution for this condition that is expected in Q3 of 2026. Replacement of the engine or transmission will not resolve this condition. Monitor Professional Technician System (PTS) for additional information and schedule |
| SSM 54939 | 2026-06-22. Service bulletin. Some 2020-2026 Corsair/Escape, 2021-2026 Bronco Sport, and 2022-2026 Maverick vehicles equipped with an 8F35 transmission may exhibit a shudder condition, most noticeable at speeds below 60 mph (100 km/h), with no relevant diagnostic trouble codes (DTC) stored in the powertrain control module (PCM). Sometimes, this may be perceived/felt as an engine misfire. This may be due to the torque converter. If Pinpoint Test K: Torque Converter Clutch Operation in Workshop Manual (WSM), Section 307-01 > Diagnosis and Testing > Diagnosis by Symptom directs to replace the torque converter, remove and replace the torque converter and torque converter seal. Refer to WSM, Section 307-01 > Removal and Installation > Torque Converter Seal. Remove the main control valve body. Refer to WSM, Section 307-01 > Removal and Installation > Main Control Valve Body. Overhaul and thoroughly clean the main control valve body. Refer to WSM, Section 307-01 > Overhaul > Main Control Valve Body. Reverse the removal procedure to reassemble the transmission. Install the transmission. Refer to WSM, Section 307-01 > Installation. For claim |
| SSM 54797 | 2026-05-08. Service bulletin. Some 2020-2026 Corsair/Escape, 2021-2026 Bronco Sport, and 2022-2026 Maverick vehicles equipped with an 8F35 transmission may exhibit a shudder condition, most noticeable at speeds below 60 mph (100 km/h), with no relevant diagnostic trouble codes (DTC) stored in the powertrain control module (PCM). Sometimes, this may be perceived/felt as an engine misfire. This may be due to the torque converter. If Pinpoint Test K: Torque Converter Clutch Operation in Workshop Manual (WSM), Section 307-01 > Diagnosis and Testing > Diagnosis by Symptom directs to replace the torque converter, remove and replace the torque converter and torque converter seal. Refer to WSM, Section 307-01 > Removal and Installation > Torque Converter Seal. Remove the main control valve body. Refer to WSM, Section 307-01 > Removal and Installation > Main Control Valve Body. Overhaul and thoroughly clean the main control valve body. Refer to WSM, Section 307-01 > Overhaul > Main Control Valve Body. Reverse the removal procedure to reassemble the transmission. Install the transmission. Refer to WSM, Section 307-01 > Installation. |
| TSB 26-2194 | 2026-04-28. Service bulletin. This bulletin supersedes 25-2627. Reason for update: To add a Step to reprogram the all-wheel drive (AWD) module for Bronco Sport vehicles. Some of the vehicles listed in the Model statement above may exhibit all of the following conditions: Shudder chatter condition, most noticeable at low speeds turning No relevant diagnostic trouble codes (DTCs) present This may be due to internal rear drive unit (RDU) fluid contamination. |
| SSM 54615 | 2026-03-04. Service bulletin. Some 2020-2026 Escape and 2021-2026 Corsair vehicles equipped with a 2.5L engine may exhibit a fuel door that won't open with diagnostic trouble code (DTC) P04CA stored in the powertrain control module (PCM). This may be due to an open circuit on circuit SBB05 and/or a damaged splice S133. Before performing the pinpoint test for P04CA in Workshop Manual (WSM), Section 310-00, inspect circuit SBB05 and splice S133 for damage such as an open circuit. Repair as necessary. Refer to Wiring Diagram, Cell 005. If no damage is found, refer to WSM, Section 310-00 for normal diagnostics. For claiming use causal 14290 and labor operations 12650D, 12650D45, and 12650D45WR. |
| SSM 54593 | 2026-02-27. Service bulletin. Some 2024-2025 F-150, Expedition/Navigator, Escape/Corsair, Bronco, Explorer, Mustang, Maverick vehicles equipped with a 1.5/2.0/2.3/3.5L EcoBoost engine and built on 01-Oct-2024 and through 31-May-2025 may exhibit an extended crank condition, strong fuel smell in the engine oil, high engine oil level and/or may have various drivability diagnostic trouble codes (DTCs) stored in the powertrain control module (PCM) with an illuminated malfunction indicator lamp (MIL). This may be due to an internal fuel leak of the high-pressure fuel pump causing fuel to enter the crankcase and reduce fuel pressure in the direct injection fuel rail. Diagnose this condition using Pinpoint Test HP located in Workshop Manual (WSM), Section 303-04. If no DTCs are stored in the PCM, proceed from Step HP1 to Step HP5 and continue testing. Repair as necessary outside of this article. For claiming, if high-pressure fuel pump replacement is required, use causal part number 9D376 and labor operation code 9543A. If the root cause is identified as anything other than the fuel injection pump, claim the repair outside of this article. |
| TSB 26-2058 | 2026-02-26. Service bulletin. This article supersedes TSB 25-2567 Reason for update: update the model years Some of the vehicles listed in the Model statement above may exhibit all of the following conditions: * Intermittent or permanent no reverse (R) engagement * Illuminated MIL with diagnostic trouble code (DTC) P0767 stored in the powertrain control module (PCM) In addition to the required conditions, the vehicle may also exhibit a harsh reverse engagement, P0766, and/or P2703. This may be due to an internal mechanical concern with the selectable one-way clutch. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.