WenmarOpen by Wenmar Pro

Transport Canada recall 2023527

A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.

Campaign
Published byTransport Canada (Canada)
Campaign number2023527
Manufacturer's numberR0246
Reported2023-09-22
ComponentBrakes
Notification typeSuperseded
Units potentially affected326942

What is wrong

This recall was replaced by Transport Canada Recall No. 2024-080.

Issue:

On certain vehicles, brake fluid could leak into the control module for the antilock brake system (ABS) and cause it to short circuit.

Safety Risk:

A short circuit could create a fire risk, even while the vehicle is parked and turned off.

Corrective Actions:

Hyundai will notify owners by mail and advise you to take your vehicle to a dealership to replace the fuse for the ABS module. Hyundai recommends that you should park your vehicle outdoors and away from other vehicles or structures until the recall repairs have been completed.

Vehicles this campaign lists
2012 HYUNDAI ACCENT
2013 HYUNDAI ACCENT
2014 HYUNDAI ACCENT
2015 HYUNDAI ACCENT
2011 HYUNDAI ELANTRA
2012 HYUNDAI ELANTRA
2013 HYUNDAI ELANTRA
2014 HYUNDAI ELANTRA
2015 HYUNDAI ELANTRA
2014 HYUNDAI EQUUS
2015 HYUNDAI EQUUS
2011 HYUNDAI GENESIS COUPE
2012 HYUNDAI GENESIS COUPE
2013 HYUNDAI GENESIS COUPE
2014 HYUNDAI GENESIS COUPE
2015 HYUNDAI GENESIS COUPE
2013 HYUNDAI SANTA FE
2014 HYUNDAI SANTA FE
2015 HYUNDAI SANTA FE
2013 HYUNDAI SANTA FE SPORT
2010 HYUNDAI TUCSON
2011 HYUNDAI TUCSON
2012 HYUNDAI TUCSON
2013 HYUNDAI TUCSON
2010 HYUNDAI VERACRUZ
2011 HYUNDAI VERACRUZ
2012 HYUNDAI VERACRUZ

A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.

Bulletins for the same vehicles and component

Bulletins for the same vehicles and component
21-BR-002H2021-04-07. Service bulletin. This bulletin provides best practice recommendations when performing brake service procedures.
20-BR-002H2020-12-08. Service bulletin. This bulletin describes the procedure to inspect and identify fluid which may appear around the brake caliper area.
20-AT-011H2020-04-07. Service bulletin. If you are servicing an applicable vehicle with a “Check Engine” light on and one or more of the DTC listed below, follow the repair procedure and replace the related solenoid and oil pressure harness.
19-BR-001H-12019-08-19. Service bulletin. This bulletin provides information on the rear wheel speed sensor for Santa Fe (CM), Santa Fe / XL (NC), Santa Fe Sport (AN), and Veracruz (EN) vehicles equipped with front wheel drive (FWD). The rear wheel speed sensor is available as a separate service part from the rear wheel hub assembly. When appropriate, it is recommended to replace only the rear wheel speed sensor instead of the full assembly.
19-BR-001H(1)2019-07-29. Service bulletin. This bulletin provides information on the rear wheel speed sensor for Santa Fe (CM), Santa Fe / XL (NC), Santa Fe Sport (AN), and Veracruz (EN) vehicles equipped with front wheel drive (FWD). The rear wheel speed sensor is available as a separate service part from the rear wheel hub assembly. When appropriate, it is recommended to replace only the rear wheel speed sensor instead of the full assembly.
5NP-L2J7D-042017-08-10. Service bulletin. If the rear wheel hub in the affected vehicles is submerged in salt water, salt water can enter the rear wheel speed sensor housing and may interrupt the rear wheel speed sensor signal and temporarily illuminate the ABS and/or ESC warning lights in the instrument cluster until the sensor dries. For these cases, replacement of the wheel speed sensor cap is required. If no ABS/ESC warning lamp is illuminated, applying a silicone spray to the sensor is required. This bulletin describes the service procedure for the rear wheel speed sensors.
5NP-P8B7B-032017-08-10. Service bulletin. If the rear wheel hub in the affected vehicles is submerged in salt water, salt water can enter the rear wheel speed sensor housing and may interrupt the rear wheel speed sensor signal and temporarily illuminate the ABS and/or ESC warning lights in the instrument cluster until the sensor dries. For these cases, replacement of the wheel speed sensor cap is required. If no ABS/ESC warning lamp is illuminated, applying a silicone spray to the sensor is required. This bulletin describes the service procedure for the rear wheel speed sensors.
5NP-Y6K2G-102016-10-18. Service bulletin. "HYUNDAI MOTOR AMERICA IS CONDUCTING RECALL 146 TO REPLACE THE BRAKE PEDAL STOPPER ON CERTAIN 2013 MODEL YEAR ELANTRA VEHICLES. RECALL 146 PROVIDES A PROCEDURE TO REPLACE THE BRAKE PEDAL STOPPER."
5NP-U7B6K-102016-10-14. Service bulletin. "THE BRAKE PEDAL STOPPER PAD IS LOCATED BETWEEN THE STOP LAMP SWITCH AND THE BRAKE PEDAL ARM. THE BRAKE PEDAL STOPPER PAD MATERIAL IN THE AFFECTED VEHICLES CAN DETERIORATE ALLOWING THE STOP LAMP SWITCH PLUNGER TO REMAIN EXTENDED WHEN THE BRAKE PEDAL IS RELEASED. A DETERIORATED PAD CAN RESULT IN THE STOP LAMPS ILLUMINATING CONTINUOUSLY, ILLUMINATION OF THE TRACTION CONTROL WARNING LAMP, THE ABILITY TO MOVE THE SHIFT LEVER WITHOUT DEPRESSING THE BRAKE PEDAL, OR ACTIVATION OF THE ENGINE MANAGEMENT SYSTEM’S BRAKE PEDAL OVERRIDE FEATURE. ANY OF THE DESCRIBED SYMPTOMS CAN INCREASE THE RISK OF A CRASH."
SB-12-01-036-12016-06-17. Service bulletin. SUMMARY TO BE PROVIDED ON A FUTURE DATE.

A bulletin is the manufacturer's note to its dealers. It is not part of this recall.

Check one vehicle officially

Contains information licensed under the Open Government Licence – Canada.