Transport Canada recall 2023125
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2023125 |
| Manufacturer's number | C0525 (20D145 / 20D160 / 60C007) |
| Reported | 2023-03-08 |
| Component | Brakes |
| Notification type | Safety TC |
| Units potentially affected | 404543 |
What is wrong
Issue:
Hyundai is conducting a special service campaign that provides anti-corrosion treatment to certain underbody components. Over time, components under the vehicle, including brake lines could corrode. If this happens, a brake line could fail and leak. A brake fluid leak can result in reduced braking.
Safety Risk:
Reduced braking can cause an extended stopping distance and increase the risk of a crash.
Corrective Actions:
Hyundai will notify owners by mail and advise you to take your vehicle to a dealership to inspect the underbody, including the brake lines. The dealer will apply an anti-corrosion treatment to certain parts, and replace the brake lines if necessary.
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| TXXP DBP | 2022-06-10. Service bulletin. The warranty coverage for the hydraulic electronic control unit (HECU) for certain 2009-12 Genesis (BH) and 2011-12 Equus (VI) vehicles for repairs and replacement has been extended to 15 years with unlimited miles from the date of original retail delivery or date of first use and is valid for original and subsequent owners. |
|---|---|
| 22-BR-001H-1 | 2022-06-10. Service bulletin. The warranty coverage for the hydraulic electronic control unit (HECU) for certain Genesis (BH) and Equus (VI) vehicles for repairs and replacement has been extended to 15 years with unlimited miles from the date of original retail delivery or date of first use, and is valid for original and subsequent owners. |
| 22-01-013H | 2022-03-08. Service bulletin. The brake fluid specifications labeled on the master cylinder reservoir cap and in the vehicle owner’s manual require revision to indicate DOT 4 brake fluid only. This bulletin describes the procedure to replace the master cylinder reservoir cap and apply a sticker to the owner’s manual with the revised brake fluid specification. |
| 21-BR-002H | 2021-04-07. Service bulletin. This bulletin provides best practice recommendations when performing brake service procedures. |
| 20-BR-002H | 2020-12-08. Service bulletin. This bulletin describes the procedure to inspect and identify fluid which may appear around the brake caliper area. |
| 20-AT-011H | 2020-04-07. Service bulletin. If you are servicing an applicable vehicle with a “Check Engine” light on and one or more of the DTC listed below, follow the repair procedure and replace the related solenoid and oil pressure harness. |
| 19-BR-001H-1 | 2019-08-19. Service bulletin. This bulletin provides information on the rear wheel speed sensor for Santa Fe (CM), Santa Fe / XL (NC), Santa Fe Sport (AN), and Veracruz (EN) vehicles equipped with front wheel drive (FWD). The rear wheel speed sensor is available as a separate service part from the rear wheel hub assembly. When appropriate, it is recommended to replace only the rear wheel speed sensor instead of the full assembly. |
| 19-BR-001H(1) | 2019-07-29. Service bulletin. This bulletin provides information on the rear wheel speed sensor for Santa Fe (CM), Santa Fe / XL (NC), Santa Fe Sport (AN), and Veracruz (EN) vehicles equipped with front wheel drive (FWD). The rear wheel speed sensor is available as a separate service part from the rear wheel hub assembly. When appropriate, it is recommended to replace only the rear wheel speed sensor instead of the full assembly. |
| 5NP-P8B7B-03 | 2017-08-10. Service bulletin. If the rear wheel hub in the affected vehicles is submerged in salt water, salt water can enter the rear wheel speed sensor housing and may interrupt the rear wheel speed sensor signal and temporarily illuminate the ABS and/or ESC warning lights in the instrument cluster until the sensor dries. For these cases, replacement of the wheel speed sensor cap is required. If no ABS/ESC warning lamp is illuminated, applying a silicone spray to the sensor is required. This bulletin describes the service procedure for the rear wheel speed sensors. |
| 5NP-Y6K2G-10 | 2016-10-18. Service bulletin. "HYUNDAI MOTOR AMERICA IS CONDUCTING RECALL 146 TO REPLACE THE BRAKE PEDAL STOPPER ON CERTAIN 2013 MODEL YEAR ELANTRA VEHICLES. RECALL 146 PROVIDES A PROCEDURE TO REPLACE THE BRAKE PEDAL STOPPER." |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.