Transport Canada recall 2023077
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2023077 |
| Manufacturer's number | 5491810 |
| Reported | 2023-02-17 |
| Component | Electrical |
| Notification type | Safety Mfr |
| Units potentially affected | 41 |
What is wrong
Issue:
On certain vehicles equipped with front swivel-seats, the wiring harness under the seat may not be properly secured. As a result, the airbag wires could be damaged when the seat is moved. If this happens, the side airbag may not work properly in a crash.
Note: If the wiring to the side airbag is damaged, the SRS light will stay on in the instrument cluster.
Safety Risk:
An airbag that does not work properly could increase the risk of injury in a crash.
Corrective Actions:
Mercedes-Benz will notify owners by mail and instruct you to take your vehicle to a dealership to inspect the routing of the seat wiring harness and attach it correctly.
| 2022 MERCEDES-BENZ SPRINTER |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| 2025080008 | 2025-10-07. Service campaign. MBAG has determined the software of the control unit for the anti-theft warning system does not correspond to the current production configuration. There is a possibility that the alarm system (EDW) could be triggered while the vehicle is parked and locked. MBUSA is conducting a service campaign. An authorized Mercedes-Benz Sprinter dealer will update the anti-theft system software on the affected vehicles. |
|---|---|
| LI49.20-N-079157_6 | 2025-07-01. Service bulletin. Complaint The check engine light is activated, accompanied by one or more of the following fault codes related to the Adblue System: •P20F409: The Adblue consumption is too low. There is a component fault. •P202E84: The Adblue metering valve 1 (Motor side) has a malfunction. There is a signal below the permissible limit value. Cause The potential causes for these fault codes are: A. A leak in the Adblue System B. An internal fault with the Adblue Injection Valve #1 (Motor side) C. An air pocket forming in the Adblue Injection Valve #1 (Motor side) Adblue Injector Line Remedy Vehicles Produced Before August 1, 2024 (Code XY4 = MY24) A. Leak in the AdBlue System 1. Complete the Guided Tests for DTC P20F409 or P202E84: •Inspect the AdBlue tank, pump, line, and both injectors for leaks. •Ensure the AdBlue line is properly routed, securely fastened, and not in contact with the exhaust system. •Remove both AdBlue injection valves, perform 2–3 pressure build-ups, and check for AdBlue leaks. •If a leak is detected, repair it and retest. B. Internal Fault with AdBlue Injection Valve #1 (Motor Side) 1. Process All Other Related DTCs First: •Address any other fault codes relating to AdBlue injection valves before proceeding. •If AdBlue Injection Valve #1 (engine side) fails the guided tests, replace it and retest. C. Air Pocket Forming in the AdBlue Line (Motor Side) 1. If Guided Tests Pass and No Leaks are Found: --Do not replace any components.-- •The MY23-24 (Code XY4 = MY24, OM654) AdBlue line (A907 470 01 01) has a known design issue that can cause air pockets and DTC P20F409. This may also result in DTC P202E84, depending on the air pocket size. •The guided tests for P20F409 now include resetting the learned values for the AdBlue delivery pump (A103m1). After this, the vehicle can be released to the customer. NOTE: Replacing the AdBlue tank or line will NOT resolve this air pocket issue. TIPS cases are no longer required for MY23–24 vehicles. Steps to Perform (MY23–24, Code XY4): 1. Complete the guided tests for DTC P20F409 and/or P202E84. 2. Perform an initial start-up of: •The SCR control unit •AdBlue tank components •Both AdBlue injectors 3. Conduct a 20-mile test drive. If no faults occur, the vehicle can be released. 4. Inform the customer that frequent starting/stopping increases the likelihood of this fault due to repeated cycling of AdBlue in/out of the line each ignition cycle. Vehicles Produced After August 1, 2024 (Code XY5 = MY25) A. Leak in the AdBlue System 1. Complete the Guided Tests for DTC P20F409 or P202E84: •Inspect the AdBlue tank, pump, line, and both injectors for leaks. •Ensure the AdBlue line is properly routed, securely fastened, and not in contact with the exhaust system. •Remove both AdBlue injection valves, perform 2–3 pressure build-ups, and check for AdBlue leaks. •If a leak is detected, repair it and retest. B. Internal Fault with AdBlue Injection Valve #1 (Motor Side) 1. Process All Other Related DTCs First: •Address any other fault codes relating to AdBlue injection valves before proceeding. •If AdBlue Injection Valve #1 (engine side) fails the guided tests, replace it and retest. C. Incorrect AdBlue Injection Line Installed 1. Verify the Updated Line is Installed: •Confirm that part number A907 470 33 02 is present. •If the AdBlue line is incorrect (e.g., A907 470 01 01), replace it with the updated line. TIPS Case Instructions for All MY25 and Newer Vehicles If you encounter any of the issues above on any MY25 or newer vehicle, including finding an incorrect AdBlue line in- stalled: •Open a TIPS case addressed to the Powertrain inbox. •Reference this LI document. •Include the following information: •Description of the issue encountered (e.g., fault code, check engine light, or incorrect AdBlue injection line) •Current Quick Test, SCR N118/5 Control Unit Log, and Guided Test results. •Photo of AdBlue line part number label. •Photos documenting any issues, leaks, or melting observed |
| LI47.70-N-079422_1 | 2025-07-01. Service bulletin. HV battery is not charging to its full capacity with restricted maximum SoC Complaint The vehicle's HV battery is not charging to its full capacity, with the maximum State of Charge (SoC) being restricted to a specific percentage. Cause The State of Charge (SoC) percentage limitation might be influenced by the Onboard Logic Unit (OLU), MBUX Headunit, or the Powertrain Control Unit (PTCU). Remedy If the Onboard Logic Unit (OLU) and MBUX Headunit do not impose a SoC percentage limitation, then proceed with the SCN coding of the Powertrain Control Unit (PTCU). |
| LI88.30-N-078036 | 2024-08-03. Service bulletin. Complaint T57 Electric step inoperative with warning on cluster. Cause Possible damage to end position sensors. |
| News Channel Upd | 2023-05-22. Service bulletin. Update Instrument Cluster Software |
| 22V2790614-2 | 2023-04-24. Service bulletin. Software Updates. |
| 22V2790614 | 2023-04-24. Service bulletin. Software Updates. |
| 22V2790613-1 | 2023-04-24. Service bulletin. Software Updates. |
| 22V2790613 | 2023-04-24. Service bulletin. Software Updates. |
| 22V2790612-1 | 2023-04-24. Service bulletin. Software Updates. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.