Transport Canada recall 2022085
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2022085 |
| Manufacturer's number | 5492313 |
| Reported | 2022-02-23 |
| Component | Visual System |
| Notification type | Safety Mfr |
| Units potentially affected | 3701 |
What is wrong
Issue:
On certain vehicles, the rearview camera image could freeze while backing up.
Safety Risk:
A rearview camera that doesn't display correctly could reduce a driver's ability to see behind the vehicle while backing up. This could increase the risk of a crash.
Corrective Actions:
Mercedes-Benz will notify owners by mail and advise you to take your vehicle to a dealership to have the rearview camera replaced.
| 2016 MERCEDES-BENZ METRIS | |
|---|---|
| 2017 MERCEDES-BENZ METRIS | |
| 2018 MERCEDES-BENZ METRIS |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| LI82.35-N-078930 | 2025-04-03. Service bulletin. Warning Lamp "Washer Fluid Empty" Yet Reservoir Is Not Empty Complaint: Warning lamp "washer fluid empty", even thought the washer fluid reservoir is full Cause: Insufficient electrical conductivity of the washer fluid, as the washer fluid was mixed with distilled water. Tip: The washer fluid sensor detects the electrical conductivity. If air is present without electrical conductivity between the measuring points, as is the case with an empty tank, an empty tank is detected by the sensor. Distilled water also does not have electrical conductivity, meaning that the sensor detects an empty tank, even if this is not the case. Remedy: Fill reservoir with standard washer fluid and water (no distilled water) in an adequate ratio in order to ensure electrical conductivity. Exchange of the reservoir with a welded-in sensor is only required if filling with conductive washer fluid has not provi- ded a remedy. This can be made certain by utilizing water with a light amount of salt dissolved in to it for stronger con- ductivity. |
|---|---|
| MB Launch NCU-VS | 2023-01-23. Service bulletin. (RC)Replace Rear View Camera and Update Software |
| LI54.65-N-075675 | 2023-01-05. Service bulletin. Complaint Camera cover of reversing camera does not fold in (see Picture 01, shown on vehicle with code W65 (Tailgate)). Remedy Note: Do not replace any component parts or carry out any diagnostic work! Model 447.6/7 (Metris) As of the introduction of code FR1 (Rearview camera, non-folding), the folding function of the reversing camera is no longer available (discontinuation of camera cover (KAB) control unit (N144)). Consequently, the reversing camera remains open/folded out at all times. The representation of the camera image on the media display of the radio/radio- navigation (N87/15) is not restricted and functions in the usual way. Information: There are no plans for a retrospective adaptation of the folding function through Aftersales. |
| Recall Informati | 2022-08-08. Service bulletin. (RC)Replace and Update Rear View Camera |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.