Transport Canada recall 2020631
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2020631 |
| Manufacturer's number | 20S72 |
| Reported | 2020-12-21 |
| Component | Engine |
| Notification type | Safety Mfr |
| Units potentially affected | 65 |
What is wrong
Issue:
On certain vehicles, the right motor mount fasteners may not have been properly tightened. As a result, the engine may vibrate, and the axle may disconnect from the transmission. This can result in loss of power to the wheels.
Safety Risk:
A loss of power to the wheels could increase the risk of a crash.
Corrective Actions:
The company will notify owners by mail and instruct you to take your vehicle to a Ford or Lincoln dealer to remove and replace the right motor mount fasteners.
| 2020 FORD EXPLORER | |
|---|---|
| 2020 LINCOLN AVIATOR |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| SSM 55228 | 2026-10-12. Service bulletin. Some 2020-2026 Aviator/Explorer/F-150/Bronco/Ranger vehicles equipped with a 2.7L or 3.0L (non-diesel) engine may need the front engine cover removed and reinstalled for various reasons. The Workshop Manual (WSM), Section 303-01 Engine > Removal and Installation > Engine Front Cover service procedure has been updated to include a new essential special service tool (ESST) guide pin alignment tool (303-1790) that is used to align the engine front cover to the engine block, preventing the O-ring seal on the engine oil galley feed tube from getting damaged during installation. |
|---|---|
| SSM 55217 | 2026-10-06. Service bulletin. Some 2020-2024 Explorer/Aviator vehicles equipped with 3.0L EcoBoost/hybrid engine may exhibit blue or black exhaust smoke on startup for the first 5 minutes after an overnight cold soak with no illuminated malfunction indicator lamp (MIL) or powertrain diagnostic trouble codes (DTCs) present. This may be due to engine oil breaching the dynamic oil seals separating the bearing core from the turbine housing in the left side turbocharger assembly. There is a new, updated left side turbocharger oil supply tube equipped with an internal check valve to prevent the engine oil from entering turbine housing after the engine is off. Replace the existing left side turbocharger oil supply tube with the updated service part that includes the check valve (service part# L1MZ-9T516-B) or latest level part. Refer to the Workshop Manual (WSM), Section 303-04 Fuel Charging and Controls - Turbocharger > Removal and Installation > Turbocharger Oil Supply Tube LH. For claiming, use causal part 9T516 and labor operation code 9440AL. |
| 25B51 | 2026-06-05. Other. Certain 2021-2024 Model Year Bronco, 2021-2024 Model Year Bronco Sport, 2020-2022 Model Year Corsair and Escape, 2016-2024 Model Year Explorer, 2019-2020 Model Year Fusion, 2016-2018 Model Year Focus RS, 2022-2024 Model Year Maverick, 2016-2019 Model Year MKC and 2019-2024 Model Year Ranger Vehicles Equipped with a 2.0L or 2.3L Engine and Engine Block Heater System Block Heater Replacement |
| SSM 54795 | 2026-05-08. Service bulletin. Some 2021-2023 F-150 vehicles equipped with a 3.5L PowerBoost engine and 2020-2026 Explorer vehicles equipped with a 3.3L hybrid engine may exhibit an illuminated powertrain malfunction (wrench) indicator with diagnostic trouble code (DTC) P0A1E stored in the powertrain control module (PCM). The vehicle may be unable to enter electric-only drive modes as expected during normal drive cycles. This may be due to the software within the belt integrated starter generator (BISG). For vehicles with this condition, follow Pinpoint Test I: Battery Isolation/Voltage Stabilization Control Circuit Carry Outance located in the Workshop Manual (WSM), Section 303-06D and repair the vehicle as necessary. Note that the BISG is on backorder status at the time of this publication and Ford is working to make parts available. Engineering is investigating this concern. Monitor PTS for updates. |
| SSM 54262 | 2025-10-07. Service bulletin. Some 2019-2020 Edge/Nautilus vehicles equipped with a 2.7L EcoBoost, 2020 Aviator vehicles equipped with a 3.0L EcoBoost or 3.0L plug-in hybrid electric vehicle (PHEV) engine, 2020 Explorer vehicles equipped with a 3.0L EcoBoost, and 2020 F-150 vehicles equipped with a 2.7L EcoBoost engine may exhibit a ticking/tapping or rattle type noise from the top front cover area of the engine. This noise may occur on initial start-up after a cold soak of 6 hours or more that may last for 2-5 seconds. This may be due to an internal component of the variable cam timing (VCT) unit. If diagnostics lead to the VCTs as the source of the noise, refer to the 2024 F-150 Workshop Manual (WSM), Section 303-00 > Diagnosis and Testing > Engine > Pinpoint Test F. Pinpoint test F has been updated to include additional steps along with a video on how to identify the single affected VCT unit that requires replacement. |
| 24N10 S1 | 2025-08-01. Other. Certain 2020-2022 Model Year Explorer Police Interceptor Utility (PIU) Vehicles Engine Block Breaches This program provides a no-cost, one-time repair (if needed) to the engine long-block for 10 years of service or 150,000 miles from the warranty start date of the vehicle, whichever occurs first. |
| 24M01 S2 | 2025-06-03. Other. 2020 Model Year Explorer and Explorer Police Interceptor - Utility Equipped with a 3.3L Engine Replace Front Catalytic Converters If Required and Inspect Wire Harness for Runs Rough/Misfire Condition |
| SSM 53764 | 2025-05-21. Service bulletin. Some 2020 Continental, 2020-2024 Edge/Nautilus, 2020-2025 Explorer/Aviator/Escape/Corsair/F-150/F-Super Duty/Ranger/Transit/E-Series, 2021-2025 Bronco, and 2022-2025 Maverick vehicles may require an engine cooling system flush to be performed for various concerns. Workshop Manual (WSM), Section 303-03 has been updated to eliminate the need to remove and install the radiator assembly to perform a radiator flush. |
| 24M01 S1 | 2024-11-06. Other. In some of the affected vehicles, one or both of the catalytic converters may develop outer cracks or inner heat-related damage. |
| 24M01 S1 | 2024-09-04. Service bulletin. 2020 Model Year Explorer and Explorer Police Interceptor - Utility Equipped with a 3.3L Engine Replace Catalytic Converters for Diagnostic Trouble Code (DTC) P0420 or P0430 and Inspect Wire Harness for Runs Rough/Misfire Condition Reason for Supplement: additional information on reason for repair, labor allowances and technician information. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.