Transport Canada recall 2020091
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2020091 |
| Manufacturer's number | R0165 (01CC01) |
| Reported | 2020-02-28 |
| Component | Electrical |
| Notification type | Safety TC |
| Units potentially affected | 29959 |
What is wrong
Issue:
Certain vehicles may be equipped with an accessory trailer wiring harness kit that could fail. Over time, moisture could enter the control module and cause a short circuit.
Note: This recall only affects Hyundai Genuine Accessory trailer wiring harness kits that were manufactured by third parties and sold in Canada. These kits may have been ordered at the time of a vehicle purchase, or purchased separately from a dealer as an aftermarket accessory.
Safety Risk:
A short circuit could create a fire risk. This risk remains even when the vehicle is parked.
Corrective Actions:
Hyundai will notify owners by mail and instruct you to inspect your vehicle to see if it has an affected trailer wiring harness installed. If it does, Hyundai will advise you to take your vehicle to a dealer to install a redesigned trailer wiring harness. Hyundai recommends that you should park your vehicle outdoors, and away from other vehicles or structures until the recall repairs have been completed.
| 2013 HYUNDAI SANTA FE SPORT | |
|---|---|
| 2014 HYUNDAI SANTA FE SPORT | |
| 2015 HYUNDAI SANTA FE SPORT | |
| 2016 HYUNDAI SANTA FE SPORT | |
| 2017 HYUNDAI SANTA FE SPORT | |
| 2018 HYUNDAI SANTA FE SPORT | |
| 2013 HYUNDAI SANTA FE XL | Listed as a series or trim of this model. |
| 2014 HYUNDAI SANTA FE XL | Listed as a series or trim of this model. |
| 2015 HYUNDAI SANTA FE XL | Listed as a series or trim of this model. |
| 2016 HYUNDAI SANTA FE XL | Listed as a series or trim of this model. |
| 2017 HYUNDAI SANTA FE XL | Listed as a series or trim of this model. |
| 2018 HYUNDAI SANTA FE XL | Listed as a series or trim of this model. |
| 2019 HYUNDAI SANTA FE XL |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| 9C2 060518 | 2026-06-06. Service campaign. Following completion of Service Campaign 9C2 (Theta II Emissions Improvement), certain vehicles may exhibit a brief hesitation or rough shifting condition during cold start operation. If present, this condition is expected to occur only within approximately the first 1-3 minutes after engine start, while the catalyst is reaching its normal operating temperature. |
|---|---|
| 9C2 DCS 260518 | 2026-06-06. Service campaign. Following completion of Service Campaign 9C2 (Theta II Emissions Improvement), certain vehicles may exhibit a brief hesitation or rough shifting condition during cold start operation. If present, this condition is expected to occur only within approximately the first 1-3 minutes after engine start, while the catalyst is reaching its normal operating temperature. |
| 26-01-013H-2 DN | 2026-06-06. Service campaign. Certain Santa Fe (TMA), Santa Fe Sport (AN), Sonata (LFA), and Tucson (TL) vehicles equipped with Theta II engines may exhibit elevated engine-out emissions. The California Air Resources Board has determined that these vehicles may be releasing air pollutants which exceed Federal and California standards. |
| 26-01-013H-2 TSB | 2026-06-06. Service campaign. Certain Santa Fe (TMA), Santa Fe Sport (AN), Sonata (LFA), and Tucson (TL) vehicles equipped with Theta II engines may exhibit elevated engine-out emissions. This bulletin provides instructions for updating the Engine Control Module (ECM) to address this condition. |
| Z01 Letter | 2026-06-06. Warranty extension. Certain 2012 – 2017 model year Accent, 2012 – 2017 model year Azera, 2013 – 2018 model year Santa Fe Sport, 2013 – 2019 model year Santa Fe, and 2012 – 2017 model year Veloster vehicles may exhibit an intermittent airbag warning light and diagnostic trouble codes (DTCs) may be set. At Hyundai, we are committed to providing vehicles of outstanding quality and value. In an effort to meet this commitment, the warranty coverage for the Occupant Classification System (OCS)/Occupant Detection System (ODS) under these conditions has been extended to 18 years/unlimited mileage from the date of original retail delivery or date of first use (whichever occurs first) and is valid for original and subsequent owners. |
| 26-BE-011H DN | 2026-05-08. Warranty extension. Some vehicles listed below may exhibit an intermittent airbag warning light and DTC(s) B1763 (OCS ECU Defect), and/or B1764 (OCS Mat Defect) may be stored. Hyundai is extending the warranty coverage of the sensor for the Occupant Classification System (OCS) / Occupant Detection System (ODS) to 18 years/unlimited mileage from the date of original retail delivery or date of first use (whichever occurs first) and is valid for original and subsequent owners. Refer to the warranty and parts information outlined in this bulletin. |
| 26-BE-011H TSB | 2026-05-08. Warranty extension. Some vehicles listed below may exhibit an intermittent airbag warning light and DTC(s) B1763 (OCS ECU Defect), and/or B1764 (OCS Mat Defect) may be stored. Hyundai is extending the warranty coverage of the sensor for the Occupant Classification System (OCS) / Occupant Detection System (ODS) to 18 years/unlimited mileage from the date of original retail delivery or date of first use (whichever occurs first) and is valid for original and subsequent owners. Refer to the warranty and parts information outlilned in this bulletin. This bulletin contains the procedure to inspect for the airbag warning light and DTC(s), replace the OCS (ODS) unit or wire harness, reset the OCS (ODS), and initialize the power seat module (if applicable). This TSB also contains the procedure to replace the OCS (ODS) mat if DTCs exist after replacement of the OCS (ODS) wire harness. |
| 25-01-089H DCS | 2026-01-06. Other. Upon customer's request ONLY, the Technical Service Bulletin (TSB) 25-01-089H provides the service procedure for installation of a key cylinder reinforcement protector assembly and two anti-theft decals on the front windows. This repair procedure is being provided in addition to the previous Anti-Theft software provided under Service Campaign 993 (TSB 24-01-009H-1). |
| 25-01-089H DN | 2026-01-06. Other. In addition to the Anti-Theft software provided under Service Campaign 993 (TSB 24-01-009H-1), a zinc reinforced ignition cylinder protector hardware upgrade is being made available to customers upon request. This supplemental security measure is to be installed at the ignition switch location and provides additional protection against the social media theft method. Vehicles not equipped with an immobilizer during production at the factory are eligible. The repair procedure shall be performed and claimed upon customer request only. Any future repairs to these vehicles in which an installed ignition cylinder protector impacts required parts and/or labor, shall be covered by HMA. Please see TSB 25-01-089H for details. |
| 25-01-089H TSB | 2026-01-06. Other. This bulletin provides the service procedure for installation of a key cylinder reinforcement protector assembly and two anti-theft decals on the front windows. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.