Transport Canada recall 2019512
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2019512 |
| Manufacturer's number | 19S34 |
| Reported | 2019-10-10 |
| Component | Heater And Defroster |
| Notification type | Safety Mfr |
| Units potentially affected | 1544 |
What is wrong
Issue:
On certain vehicles, the heating, ventilating and air conditioning (HVAC) blower motor may have been built incorrectly. This could result in a short circuit.
Safety Risk:
A short circuit could cause overheating, melting, smoke, and create the risk of a fire.
Corrective Actions:
Ford will notify owners by mail and instruct them to take their vehicle to a dealer for an inspection. The HVAC blower motor will be replaced as necessary.
| 2019 FORD RANGER |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| SSM 51332 | 2023-03-04. Service bulletin. Some 2019 Ranger vehicles equipped with an 8 in. center display screen may have had the climate control buttons no longer present on the center display screen after accessory protocol interface module (APIM) replacement or dealer software update, although the mechanical buttons for climate are still functional. To correct this condition, perform the APIM configuration programming feature in FDRS. For claiming, use causal part 14G371 and applicable labor operations in Section 10 of the Service Labor Time Standards (SLTS) Manual. |
|---|---|
| SSM 51313 | 2023-02-02. Service bulletin. Some 2019-2020 Ranger vehicles built on or before 30-Jul-2020 may experience poor and/or no temperature change when the temperature is adjusted in the climate control system. There may also be a clicking/snapping noise from behind the instrument panel. Diagnostic trouble code (DTC) B1082 and/or B1081 may also be retrieved from the front controls interface module (FCIM). This may be due to an issue with the blend door and its controls. To avoid repeat repairs, replace the air distribution housing/heater assembly (service base part# 18478). Refer to Workshop Manual (WSM), Section 412-00. Do not replace the evaporator core for this condition. The WSM has been updated to reflect this change. For claiming use causal part 18478 and use applicable labor operations in Section 11 of the Service Labor Time Standards (SLTS) Manual. |
| SSM 50629 | 2022-03-30. Service bulletin. Some 2019-2020 Ranger vehicles built on or before 30-Jul-2020 may experience poor and/or no temperature change when the temperature is adjusted in the climate control system. There may also be a clicking/snapping noise from behind the instrument panel. Diagnostic trouble code (DTC) B1082 and/or B1081 may also be retrieved from the front controls interface module (FCIM). This may be due to an issue with the blend door and its controls. To avoid repeat repairs, replace the air distribution housing/heater assembly (service base part# 18478). Refer to Workshop Manual (WSM), Section 412-00. Do not replace the evaporator core for this condition. The WSM has been updated to reflect this change. Use causal part 18478 and labor operation 19700D33 of the Service Labor Time Standards (SLTS) Manual. |
| SSM 50603 | 2022-03-22. Service bulletin. Some 2019-2022 Ranger vehicles may experience condensation from the climate control system dripping on the driver's side floor and/or the driver's foot. This may be due to improper or poorly wrapped evaporator lines between the interior bulkhead and the climate control assembly case. Using a flashlight and a mirror, inspect the evaporator lines for being exposed or poorly wrapped. The cut ends of the mastic wrap should be on the top of the lines and have complete coverage. If an issue is found, cover the lines by manipulating the existing mastic wrap, or by adding more mastic to better insulate the lines and limit condensation. |
| SSM 50293 | 2021-12-07. Service bulletin. Some 2019-2021 Ranger vehicles built on or before 01-Sep-2021 may experience a lack of air conditioning (A/C) cooling performance condition and/or an A/C compressor engagement concern when using the remote start function (if equipped). This may be due to the software within the front controls interface module (FCIM). To correct the condition, reprogram the FCIM using the latest software level of the appropriate Ford diagnostic scan tool. For claiming, use causal part 19980 and applicable labor operations in Section 12651D4 of the Service Labor Time Standards (SLTS) Manual. After FCIM programing, check for A/C operation and correct as necessary. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.