Transport Canada recall 2018341
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2018341 |
| Manufacturer's number | 2718F |
| Reported | 2018-06-22 |
| Component | Airbag |
| Notification type | Safety Mfr |
| Units potentially affected | 276 |
What is wrong
On certain vehicles, the side curtain airbags may not unfold properly during deployment. This could increase the risk of injury to an occupant in the event of a side-impact or rollover crash. Correction: Dealers will replace the side curtain airbags.
| 2018 MAZDA CX-5 |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| 08-002-23 | 2023-03-03. Service bulletin. Some customers may experience the airbag warning light ON with DTC B00A0:09 stored in the SAS control module memory when the battery voltage is low. DTC B00A0:09 (Occupant classification sensor internal signal output unstable). This concern is caused by the low voltage detection time of the occupant classification sensor (OCS) being too short during cranking, which causes detection of the DTC unnecessarily. The concern occurs more often in colder weather when greater electric current is consumed to start the vehicle. To eliminate this concern, the OCS has been modified to avoid unnecessary DTC detection. NOTE: Even if the voltage is recovered after the engine is started, the airbag warning light stays ON during the drive cycle. When the battery voltage becomes stable after the engine is started, the airbag system will operate normally. |
|---|---|
| 08-003-22 | 2022-05-05. Service bulletin. Some customers may experience the airbag warning light ON with DTC B00A0:09 stored in the SAS control module memory when the battery voltage is low. *DTC B00A0:09 (Occupant classification sensor internal signal output unstable) This concern is caused by the low voltage detection time of the occupant classification sensor (OCS) being too short during cranking, which causes detection of the DTC unnecessarily. The concern occurs more often in colder weather when greater electric current is consumed to start the vehicle. To eliminate this concern, the OCS has been modified to avoid unnecessary DTC detection. NOTE: *Even if the voltage is recovered after the engine is started, the airbag warning light stays ON during the drive cycle. *When the battery voltage becomes stable after the engine is started, the airbag system will operate normally. |
| SA-042-21 | 2021-07-01. Service bulletin. Some customers may complain that the passenger seat belt warning light is ON and the PASS AIRBAG OFF indicator light is OFF with no front passenger in the seat. This may be caused by an electrical device (smart phone, tablet, laptop. etc.) placed on the front passenger's seat. |
| 08-001-20-3696a | 2020-07-02. Service bulletin. Some customers may experience the airbag warning light ON with DTC B00A0:09 stored in the SAS control module memory when the battery voltage is low. • DTC B00A0:09 (Occupant classification sensor internal signal output unstable). This concern is caused by the low voltage detection time of the occupant classification sensor (OCS) being too short during cranking, which causes detection of the DTC unnecessarily. The concern occurs more often in colder weather when greater electric current is consumed to start the vehicle. To eliminate this concern, the OCS has been modified to avoid unnecessary DTC detection. NOTE: • Even if the voltage is recovered after the engine is started, the airbag warning light stays ON during the drive cycle. • When the battery voltage becomes stable after the engine is started, the airbag system will operate normally. |
| 08-001-19-3544 | 2019-02-19. Service bulletin. This information is provided to help address Passenger Airbag Deactivation (PAD) Indicator illumination concerns during vehicle service. |
| SA-027-18 | 2018-07-02. Service bulletin. Some customers may complain that the passenger seat belt warning light is ON and the PASS AIRBAG OFF indicator light is OFF with no front passenger in the seat. This may be caused by an electrical device (smart phone, tablet, laptop. etc.) placed on the front passenger's seat. |
| 08-001-18-3457 | 2018-05-14. Service bulletin. This information is provided to help address Passenger Airbag Deactivation (PAD) Indicator illumination concerns during vehicle service. |
| MT-003-18 | 2018-04-23. Service bulletin. The Workshop Manual has two-different airbag procedures, one for Standard Deployment and one for Two-Step Deployment. Standard Deployment is for Mexico spec vehicles and Two-Step Deployment is for US and Canadian spec vehicles. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.