Transport Canada recall 2017561
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2017561 |
| Reported | 2017-11-15 |
| Component | Lights And Instruments |
| Notification type | Compliance Mfr |
| Units potentially affected | 683 |
What is wrong
Certain vehicles may not comply with Canada Motor Vehicle Safety Standard (CMVSS) 101 – Location and Identification of Controls and Displays. Due to a software error, the instrument cluster may not turn on when the vehicle is started. This could disable various control telltales and warning symbols, thereby failing to meet the requirements of the standard. This could also result in the driver not being aware of malfunctions, which could affect vehicle performance and increase the risk of injury and/or damage to property. Correction: Dealers will update the vehicle software.
| 2018 BMW 2 SERIES | |
|---|---|
| 2018 BMW X2 | |
| 2018 BMW X3 |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| B630418 | 2024-04-01. Service bulletin. One or more of the LED daytime running lights are dim or discolored. |
|---|---|
| B630821 | 2023-07-24. Service bulletin. Headlight check control (CC) message 128 "High beam headlight failure" is displayed. The following fault codes are stored during a vehicle test: 80419A - Left high-beam headlight: Short circuit and/or 8041A5 - light outputs: Number of permitted short circuit cycles exceeded |
| B630418 | 2023-05-01. Service bulletin. One or more of the LED daytime running lights are dim or discolored. |
| B610323 | 2023-05-01. Service bulletin. The buttons on the gear selector switch (GWS) do not work, or the function indicator lighting has failed. |
| B121021 | 2022-05-31. Service bulletin. The customer complains that under moderate throttle application or on deceleration after throttle application, a Malfunction Indicator Lamp (MIL) is displayed in the instrument cluster. |
| B630418 | 2021-08-09. Service bulletin. One or more of the LED daytime running lights are dim or discolored. |
| B630318 | 2021-04-26. Service bulletin. LED LIGHT CARPET IS DIM OR DISTORTED: The light carpet may appear dim or distorted on one or both sides. . |
| B630720 | 2021-02-22. Service bulletin. FRONY DOOR PANEL LED FAILURES: The LED light on the front door is not working. Due to the orientation of the LED module, moisture may enter the LED module, causing corrosion. |
| B630418 | 2021-02-01. Service bulletin. ?DAYTIME RUNNING LIGHT IS DIM OR DISCOLORED: One or more of the LED daytime running lights are dim or discolored. The connection between the LED module and light tube inside the headlight is damaged. |
| B122117 | 2020-06-15. Service bulletin. ROUGH RUNNING IMMEDIATELY AFTER A COLD START: Immediately after a cold start the engine may run roughly during the catalyst heating period. Depending on the severity of this situation the malfunction indicator lamp (MIL) can be illuminated and the following fault code may be set: Fault code Control module Fault code text 151001 DME Ignition angle adjustment while idle speed cold start: ignition angle early In some circumstances if the vehicle is switched into a drive gear (R or D) when the RPM are low the engine may switch off. Should this occur the engine may be restarted normally. Software error in the DME. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.