Transport Canada recall 2017150
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2017150 |
| Reported | 2017-03-17 |
| Component | Airbag |
| Notification type | Safety Mfr |
| Units potentially affected | 6 |
What is wrong
On certain vehicles, the passenger's frontal airbag could produce excessive internal pressure during airbag deployment due to a potential airflow impairment in the inflator module. Increased pressure may cause the inflator to rupture, which could allow fragments to be propelled toward vehicle occupants, increasing the risk of injury. This could also damage the airbag module, which could prevent proper deployment. Failure of the airbag to fully deploy during a crash (where deployment is warranted) could increase the risk of personal injury to the seat occupant. Correction: Dealers will replace the passenger's frontal airbag inflator.
| 2017 BMW X5 |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| B650414 | 2022-12-12. Service bulletin. According to the customer, the airbag warning light was on, but it may not be illuminated when the vehicle arrives in the workshop. 1. ACSM fault code "930A60 - Seat occupancy detection, front passenger; malfunction" is stored. The fault may or may not currently be present. Or 2. ACSM fault code "930A1C - Front passenger seat occupancy detection transmitting fault(moisture)" is stored. The fault may or may not currently be present. |
|---|---|
| SIB650222 | 2022-08-22. Service bulletin. A check control message for the restraint system appears. In the Instrument cluster, the red air bag warning light lights up permanently. One of the following fault codes stored in the ACSM (air bag control unit): 930949 - Knee airbag, driver: short circuit to negative terminal; 93094F - Knee airbag, front passenger: short circuit to negative terminal. |
| B650518 | 2021-12-20. Service bulletin. The red air bag warning light is illuminated. |
| B513016 | 2020-04-20. Service bulletin. TAILGATE UNINTENTIONALLY OPENS: This Service Information Bulletin (Revision 4) replaces SI B51 30 16 dated March 2018. Trunk/tailgate may open when vehicle is locked Trunk/tailgate may open while the vehicle is in motion usually after stopping such as a traffic light etc. Vehicle key trunk/tailgate button may be accidentally pressed thus opening the tailgate. |
| B650518 | 2020-03-16. Service bulletin. AIR BAG LAMP ILLUMINATED. FAULT CODE 9309A0: This Service Information Bulletin (Revision 4) replaces SI B65 05 18 dated October 2018. The red air bag warning light is illuminated: Check Control message: restraint system CCM-ID: 97 The following fault memory is entered in the ACSM4 (Advanced Crash Safety Module): 9309A0 - Safety battery terminal 3: Resistance too big / Safety cutout of EME: Resistance too great A contact problem with connector A190*1B at the EME (Electrical Machine Electronics). The wires going to pins 7 (CRASH +) and 20 (CRASH-) in connector A190*1B are under tension. Vibrations may sporadically increase the resistance values of these connections outside of the acceptable range leading to an air bag warning light being illuminated. |
| B651716 | 2018-12-10. Service bulletin. Airbag (SRS) Warning Lamp Illuminated. Airbag lamp (SRS) is illuminated and both of the following fault codes are stored: 930904 - Airbag driver stage 1: Resistance too large 93090A - Airbag driver stage 2: Resistance too large CAUSE Coil spring cassette damage. |
| B650518 | 2018-11-26. Service bulletin. AIR BAG LAMP ILLUMINATED. FAULT CODE 9309A0. The red air bag warning light is illuminated (check-control message: restraint system, CCM-ID: 97) The following fault memory is entered in the ACSM4 (Advanced Crash Safety Module): 9309A0 - Safety battery terminal 3: Resistance too big / Safety cutout of EME: Resistance too great Contact problem with connector A190*1B at the EME (Electrical Machine Electronics). The wires going to pins 7 (CRASH +) and 20 (CRASH-) in connector A190*1B are under tension. Vibrations may sporadically increase the resistance values of these connections outside of the acceptable range leading to an air bag warning light being illuminated. Note: This repair will also satisfy SI B12 28 18 'F15 PHEV - Malfunction indicator lamp lit' |
| B650414 | 2018-11-05. Service bulletin. "AIRBAG WARNING LIGHT: ACSM FC 930A60 OR 930A1C SEAT OCCUPANCY DETECTION. According to the customer, the airbag warning light was on, but it may not be on when the vehicle arrives in the workshop. 1. ACSM fault code ""930A60 - Seat occupancy detection, front passenger; malfunction"" is stored. The fault may or may not currently be present. Or 2. ACSM fault code ""930A1C - Front passenger seat occupancy detection transmitting fault (moisture)"" is stored. The fault may or may not currently be present. The front passenger seat occupancy mat consists of a seat occupancy mat with a capacitive sensor system. This means a front passenger is detected by measuring the resistance of the human body. The fault is set when moisture is detected on the mat itself." |
| B650518 | 2018-10-09. Service bulletin. AIR BAG LAMP ILLUMINATED. FAULT CODE 9309A0: The red air bag warning light is illuminated (check-control message: restraint system, CCM-ID: 97) |
| B650518 | 2018-05-21. Service bulletin. AIR BAG LAMP ILLUMINATED. FAULT CODE 9309A0: The red air bag warning light is illuminated (check-control message: restraint system, CCM-ID: 97) |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.