Transport Canada recall 2017081
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2017081 |
| Manufacturer's number | T03 |
| Reported | 2017-02-15 |
| Component | Powertrain |
| Notification type | Safety Mfr |
| Units potentially affected | 5206 |
What is wrong
On certain all-wheel drive vehicles, the front propshaft bolts may be loose. This could result in the front propshaft disconnecting from the vehicle, which would lead to loss of motive power while driving and could also damage powertrain and/or underbody components and create a road hazard, increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace all eight front propshaft bolts.
| 2014 CHRYSLER 300 | |
|---|---|
| 2015 CHRYSLER 300 | |
| 2016 CHRYSLER 300 | |
| 2017 CHRYSLER 300 | |
| 2014 DODGE CHARGER | |
| 2015 DODGE CHARGER | |
| 2016 DODGE CHARGER | |
| 2017 DODGE CHARGER |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| S2621000003 REV.A | 2026-03-18. Service bulletin. The vehicle will exhibit a service transmission/check engine warning indicator for the following transmission models: 845RE, 8HP45, 850RE, 8HP50, 8HP70, 8HP75, 8HP75-PHEV, 8HP75-LCV, 8HP90, 8HP95. Transmissions may exhibit the following diagnostic codes: P07E4, P1DB2, P0716, P1B14, P0733, P1D90, P1DB7, P1B13. |
|---|---|
| 2103014 | 2023-01-17. Service bulletin. Transmission Quick Learn Procedure |
| 2100314a | 2023-01-17. Service bulletin. Flash: 845RE Transmission Shift Enhancements, 2-1 Downshift This bulletin involves reprogramming the Transmission Control Module (TCM) with the latest available software. The following TCM calibration improvements are available for vehicles equipped an 845RE Automatic Transmission (Sales Code DFL). These updates are listed by vehicle and engine.LD and LX vehicles equipped with a 3.6L engine (Sales Code ERB) Software to correct a harsh bump feel during a 2-1 downshift. Software to enable the scan tool based transmission ?Quick Learn.? Software to address customer concerns of Malfunction Indicator Lamp (MIL) illumination and Diagnostic Trouble Code (DTC) P215C Output Shaft Speed, Wheel Speed Correlation setting on AWD equipped vehicles.LX and WK vehicles equipped with a 3.0L engine (Sales Code EHD) Software to correct a harsh bump feel during a 2-1 downshift.WK vehicles e |
| 2101214 | 2023-01-17. Service bulletin. Transmission Shift Enhancements - Adaptation Drive Learn Procedure |
| 1802714 | 2023-01-17. Service bulletin. Powertrain System Improvements/Enhancements |
| S2203000003 | 2023-01-09. Service bulletin. Proper Front Driveshaft Universal Joint (U-joint) Inspection Procedures For All Wheel Drive (AWD) Vehicles. |
| W56 | 2023-01-09. Service bulletin. Customer Satisfaction Notification W56 Reprogram Powertrain Control Module |
| 9003704 | 2023-01-09. Service bulletin. Transmission Oil Pan, Heater (TMU), Tube or O-ring Applies to vehicles equipped with 8 speed transmissions only; if you have a leak that appears to be at the pan the use of proper leak detection is recommended. The fluid in the 8 speeds can be detected with a black light and there are aftermarket spray on leak detection materials to help ensure that the leak is properly diagnosed and not from another location such as cooler lines, heater tubes, or case porosity. Please note that the transmission pan gasket is available for many of the 8 speed applications FCA offers. Please review the available quick connect and transfer tube parts, as replacement of the TMU may not be required. If a TOC line connection is found to be the source, the quick connect may need replacement. If the leak source is coming from the connection of the TMU to the transmission, the transfer tube may need replacement. When parts are returned to the QEC the retaining clips (snap ring) for the quick disconnect fittings are missing. (This leaves a question as to whether the clips were missing from the assembly plant, or the technician removed them in order to make line removal easier.) Please return the clips with the transmission heater and note if they were not there to begin with. For any questions regarding transmission heater, contact FCA Redacted Content. If no response in 15 minutes, proceed with repair. |
| 2103415 | 2023-01-09. Service bulletin. Electronic Shifter Operation This bulletin involves Inspecting and replacing the Electronic Shifter (E-shifter) if required. Customer may experience the E-shifter will not shift out of park or the customer may be able to turn the E-shifter knob without the brakes being depressed. The shift indicator and cluster will show a flashing D and the cluster will display a message to put the shifter back to the park position. The Transmission will NOT shift out of park, when the brake pedal is not depressed. On further inspection the technician may find DTC P0928-00 BTSI Control. |
| 0500122 | 2023-01-09. Service bulletin. Front Click Noise at Low Speed Turns This bulletin involves installing a friction disc kit on both front hub bearing surfaces between the hub and rotor. The customer may comment on the following:When making a sharp turn at low speed (parking lot) maneuvers, a click noise is heard. Most of the time the noise can be heard if the windows are open. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.