Transport Canada recall 2016582
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2016582 |
| Manufacturer's number | S90 |
| Reported | 2016-11-18 |
| Component | Fuel System |
| Notification type | Safety Mfr |
| Units potentially affected | 48 |
What is wrong
On certain vehicles, the fuel tank control valve may have been improperly manufactured. An inoperative fuel tank control valve may result in debris in the fuel tank, the ability to overfill the fuel tank during refuelling and/or a fuel leak during a vehicle rollover event. A fuel leak during a vehicle rollover event, in the presence of an ignition source, could lead to a fire causing injury and/or damage to property. Correction: Dealers will inspect the fuel tank control valve. Vehicles found with an improperly manufactured fuel tank control valve will have the fuel tank assembly and fuel pump module replaced.
| 2017 JEEP WRANGLER |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| 9003665 | 2022-10-31. Service bulletin. Fuel Tank and Fuel Evap System Components 1) For JK MIL On ? P0441: Before replacing this part due to fault code P0441, check for restriction due to plastic over-flash in the Purge Hose Port of the Intake Manifold. If there is flash in the Purge Hose Port of the Intake Manifold and the vehicle is 2016 MY then replace the Intake Manifold and send to QEC. Otherwise, remove the flash with a 5/32? drill bit and clean the Intake Manifold of any flash debris. If the fault code P0441 continues after repairing the Intake Manifold, then send Freeze Frame data of P0441 to Michael.Ade@FCAgroup.com and contact Sylvia Lopez at cell number (248) 520-9734. If you don`t receive response within 15 minutes, please continue with the normal repair procedure. 2) For RT MIL On ? P0456: If ESIM needs to be replaced for fault code P0456, check the Vapor Line, Fresh Air Filter and the Black Frame Rail Blocker for water ingestion. If water ingestion is found, then replace the ESIM part number 04861962AB and the Jumper, Vent Recirculation Tube part number 04721757AI. Please contact Release Engineer Alfredo Salituro @ 213-700-5359 before performing repair service. If you do not receive a response within 15 minutes, please continue with the normal repair procedure. |
|---|---|
| 9003665 | 2022-10-24. Service bulletin. Fuel Tank and Fuel Evap System Components Before replacing this part due to fault code P0441, check for restriction due to plastic over-flash in the Purge Hose Port of the Intake Manifold. If there is flash in the Purge Hose Port of the Intake Manifold and the vehicle is 2016 MY then replace the Intake Manifold and send to QEC. Otherwise, remove the flash with a 5/32? drill bit and clean the Intake Manifold of any flash debris. If the fault code P0441 continues after repairing the Intake Manifold, then send Freeze Frame data of P0441 to Michael.Ade@FCAgroup.com and contact Sylvia Lopez at cell number (248) 520-9734. If you don't receive response within 15 minutes, please continue with normal repair procedure. |
| 9003768 | 2022-10-24. Service bulletin. Fuel Tank 1) Before replacing this part due to fault code P0441, check for restriction due to plastic over-flash in the Purge Hose Port of the Intake Manifold for the ERB (3.6L engine only). If there is flash in the Purge Hose Port of the Intake Manifold, then remove the flash with a 5/32? drill bit and clean the Intake Manifold of any flash debris. 2) Before replacing this part due to ?Hard to Fuel Fill? condition, check the Fuel Filler Tube for restriction in the Vent Tube. If there is blockage, then replace the Fuel Filler Tube. Contact Sylvia H. Lopez at (248) 520-9734 before replacing the Tank. If you do not receive a call back within 15 minutes, then continue the repair. |
| 9003665 | 2022-09-26. Service bulletin. Fuel tank and fuel evap system components. |
| 9003694 | 2022-08-08. Service bulletin. Oil Pump Assembly If error code P06DD present on any Pentastar V6 application, please inspect oil pump for relief valve failure. See photo attached. If valve is found out of place please call Bob Jackson (248) 944-0466 bob.jackson@fcagroup.com, or Joe Lovell (734) 309-6467 joe.lovell@fcagroup.com before proceeding. If unable to reach after 15 minutes record the following information and proceed with oil pump replacement and hold part for return to FCA via Fastrack system |
| 9003665 | 2021-05-03. Service bulletin. Fuel tank and fuel evap system components. |
| 18-039-20 | 2020-05-26. Service bulletin. Possible Driveability Issues due to the Winter-Blend Fuel into the Warmer Season |
| 18-089-19 | 2019-12-16. Service bulletin. wiTECH Small Leak Verification Test (SLVT) - P0456-EVAP SYSTEM SMALL LEAK |
| 9003639 | 2017-11-03. Service bulletin. Fuel Tank Pressure Sensor and Purge Valve Canister Before replacing this part due to fault code P0441, please call David Thomas at cell (248) 613-6908. Engineering may want to visit dealers in the metro Detroit area with this condition. If you don't receive response within 15 minutes, please continue with normal repair procedure. |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.