Transport Canada recall 2016253
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2016253 |
| Manufacturer's number | 16C08 |
| Reported | 2016-05-24 |
| Component | Lights And Instruments |
| Notification type | Compliance Mfr |
| Units potentially affected | 1050 |
What is wrong
Certain vehicles may not comply with the requirements of Canada Motor Vehicle Safety Standard 108 - Lighting System and Retroreflective Devices. Some vehicles equipped with LED headlamps were built with defective support brackets which can cause the daytime running lamp light guide to shift out of design position. If this occurs, the support bracket can melt due to the increased exposure to the LED light energy. This can cause melted material to partially block the end of the light guide, subsequently causing a loss of lighting performance which could result in failure to meet the daytime running lamp light output requirements of the standard. This could result in the vehicle being less visible to other drivers, which could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace both headlamp assemblies.
| 2017 FORD FUSION |
|---|
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| SSM 54504 | 2026-01-21. Service bulletin. Some 2016-2017 Edge/MKX, 2017 Continental/Fusion/MKZ vehicles equipped with a 2.7L or 3.0L EcoBoost engine and built on 1-Apr-2016 and through 1-Jan-2017 may exhibit white or blue smoke from the exhaust, rough idle in neutral or park at normal operating temperature or after a hot restart. The vehicle may also exhibit an illuminated malfunction indicator lamp (MIL) with diagnostic trouble codes (DTCs) P0300, P0301, P0302, P0303, P0304, P0305, P0306 and/or P0316, P0524 and/or P06DD with excessive oil consumption. Oil consumption may be 1 Liter (1 quart) in less than 4,800 km (3,000 miles). This may be due to the valve guides. To correct the condition replace the cylinder heads. During service and repair, achieving proper torque of the crankshaft pulley bolt is critical. Incorrect torque may allow the bolt to loosen resulting in timing gear failure and engine damage. Replacement of the bolt is critical to the repair. The bolt requires a 4 stage torque procedure. Hold the pulley using a universal holding tool OTC 4754 or equivalent. Refer to Workshop Manual, Section 303-01. The bolt torque procedure can be |
|---|---|
| 16B27 | 2017-02-10. Service bulletin. CERTAIN 2017 MODEL YEAR FUSION TITANIUM, PLATINUM, SPORT, SE WITH LUXURY PACKAGE, AND ENERGI VEHICLES - HEADLAMP ASSEMBLY REPLACEMENT |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.