WenmarOpen by Wenmar Pro

Transport Canada recall 2014589

A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.

Campaign
Published byTransport Canada (Canada)
Campaign number2014589
Manufacturer's number14892
Reported2014-12-22
ComponentPowertrain
Notification typeSafety Mfr
Units potentially affected15

What is wrong

On certain vehicles, rear axle shafts may not have been properly heat treated. An improperly heat-treated axle shaft could fracture without warning near the hub flange resulting in separation of a rear wheel from the axle shaft, increasing the risk of a crash which may result in injury and/or property damage. Correction: Dealers will inspect the manufacturing code on rear axle shafts and replace those identified as defective.

Vehicles this campaign lists
2015 CHEVROLET SILVERADO
2015 GMC SIERRA

A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.

Bulletins for the same vehicles and component

Bulletins for the same vehicles and component
PI0281L2025-06-12. Service bulletin. This preliminary informational (PI) bulletin provides information to dealership personnel that may be helpful when addressing underbody component corrosion with customers.
PIP5966A2025-03-02. Service bulletin. This Preliminary information communicates Diagnostic aids for a no start or DTC'S following a transmission replacement
PIP5966A2025-03-02. Service bulletin. This Preliminary information communicates Diagnostic aids for a no start or DTC'S following a transmission replacement
16-NA-0192025-02-19. Service bulletin. This service bulletin provides information on Transmission Adaptive Functions and Correcting Low Mileage Harsh Shifts, Slips, or Flares.
PIP5175F2025-02-10. Service bulletin. This Preliminary Information communication provides information to the technician about vehicles that may have a delayed engagement into drive, shudder at a launch, or the transmission is slipping when shifting into 1st, 2nd, 3rd or 4th gears. This may be due to loose stator support to pump cover bolts causing a leak at the stator support to pump cover gasket. Technician will check for the bolts to be loose. If any of the bolts are loose or the gasket is misaligned or leaking, the transmission pump cover must be replaced and the 1234 clutch plates should be inspected for being distressed and repaired as needed.
09-06-04-026Z2025-01-23. Service bulletin. This bulletin provides information on identifying Non-GM Engine Calibrations for Gasoline Engines using the Tech 2 or GDS 2.
08-07-30-035I2024-12-19. Service bulletin. This service bulletin provides information on the harmful effects of ethylene glycol in transmission fluid.
PIP60142024-12-05. Service bulletin. This Preliminary information communicates for Technicians installing a Service Replacement Transmission Assembly to contact Technical Assistance to make sure unit is not suspect of a snap ring concern prior to installation.
04-06-01-029K2024-12-04. Service bulletin. This informational bulletin explains Unscheduled Supplemental Services and the importance of GM Simplified Maintenance Schedules.
20-NA-1382024-11-05. Service bulletin. This bulletin provides information on Policies Applicable to All U.S. Dealers for Engine and Transmission Assembly Replacement Under Warranty, Policy or Customer Enthusiasm and information on Submission of Warranty Transaction in Global Warranty Management.

A bulletin is the manufacturer's note to its dealers. It is not part of this recall.

Check one vehicle officially

Contains information licensed under the Open Government Licence – Canada.