Transport Canada recall 2013047
A recall listed here may apply to a vehicle of this year, make and model. Only the manufacturer can say whether it applies to one vehicle: check the VIN with the official lookups.
| Published by | Transport Canada (Canada) |
|---|---|
| Campaign number | 2013047 |
| Reported | 2013-02-07 |
| Component | Brakes |
| Notification type | Safety Mfr |
| Units potentially affected | 3912 |
What is wrong
On certain vehicles, a check valve in the brake vacuum pump may leak a small amount of lubricating oil. Over time, this could result in contamination of the brake booster. Loss of brake power assist could occur which, in conjunction with traffic, road conditions, and driver's reactions, could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the brake booster and master cylinder. Additionally, the brake vacuum line (including the check valve) will be replaced to eliminate the possibility of oil reaching the brake booster.
| 2007 BMW X5 | |
|---|---|
| 2008 BMW X5 | |
| 2009 BMW X5 | |
| 2010 BMW X5 |
A vehicle with no link is not in this site's catalog, which covers cars, multipurpose vehicles and trucks by model year. The campaign is from data as of 2026-10-19.
Bulletins for the same vehicles and component
| B270216 | 2018-11-05. Service bulletin. "REPAIRING TRANSFER CASE ACTUATOR (VTG SERVO-MOTOR). The Anti-lock Brakes (ABS), Brakes and Dynamic Stability Control (DSC) warnings are on and there may also be a ""Drivetrain Malfunction"" warning on in the Control Display. There is also an audible clicking noise coming from the transfer case actuator when cycling the ignition. The following fault codes may be stored: (DSC) 5F3A - Clutch gearbox-ECU: clutch is open - rear-wheel drive! (VTG) 5463 - Break mechanics (VTG) 5462 - Error actuator or increased power requirements for clutch (VTG) 5461 - Error actuator control Internal wear to the plastic gears of the transfer case actuator." |
|---|---|
| B340716 | 2018-11-05. Service bulletin. "PARKING BRAKE DOES NOT WORK. Parking brake (EMF) sporadically or permanently fails to engage. Check Control Message (CCM) ""Parking brake failed"" is displayed. One or more of the following fault codes are stored in the EMF control unit: o 0x6023 - PER_POWER_ SUPPLY o 0x600E - ECU_RELAY_MOSFET o 0x6011 - ECU_MOTOR_CIRCUIT o 0x600C - PER_BUTTON_RAW o 0x6019 - PER_BUTTON_APPLY o 0x6020 - PER_BUTTON_RELEASE o 0x6021 - PER_IGN_WAKE o 0x6022 - PER_WHEEL_SPEED o 0xD387 - CAN_BUS Damaged wiring harness Defective electromechanical parking brake (EMF) actuator unit." |
| 34 04 15 | 2016-02-02. Service bulletin. BMW - BRAKE BOOSTER VACUUM MIGHT REDUCE IF TEMPERATURE GETS BELOW 14 DEGREES *MA |
| SIB-27-02-12 | 2013-07-18. Service bulletin. BMW: DUE TO AN ERROR IN SOFTWARE CALIBRATION, SOME VEHICLES ARE EXPERIENCING WARNING ILLUMINATION OF DSC, ABS AND BRAKE AND A POSSIBLE WARNING IN CONTROL DISPLAY FOR CHASSIS CONTROL SYSTEM FAILURE. MODELS 2009-2012 F30, 01, 02, 07, 10, 12, 13, 25, E70, 71, 84. NO MODEL YEARS LISTED. *PE |
| SI B34 01 08 | 2008-08-22. Service bulletin. THE PARKING BRAKE WARNING IS ILLUMINATED AND FAULT CODE 6032 IS STORED. FOR MODEL E70 (X5). *PE |
A bulletin is the manufacturer's note to its dealers. It is not part of this recall.
Check one vehicle officially
Contains information licensed under the Open Government Licence – Canada.